Optimal Power Control for Analog Bidirectional Relaying with Long-Term Relay Power Constraint

Wireless systems that carry delay-sensitive information (such as speech and/or video signals) typically transmit with fixed data rates, but may occasionally suffer from transmission outages caused by the random nature of the fading channels. If the transmitter has instantaneous channel state information (CSI) available, it can compensate for a significant portion of these outages by utilizing power allocation. In a conventional dual-hop bidirectional amplify-and-forward (AF) relaying system, the relay already has instantaneous CSI of both links available, as this is required for relay gain adjustment. We therefore develop an optimal power allocation strategy for the relay, which adjusts its instantaneous output power to the minimum level required to avoid outages, but only if the required output power is below some cutoff level; otherwise, the relay is silent in order to conserve power and prolong its lifetime. The proposed scheme is proven to minimize the system outage probability, subject to an average power constraint at the relay and fixed output powers at the end nodes.Comment: conference IEEE Globecom 2013, Atlanta, Georgia, U

Power allocation in wireless multi-user relay networks

In this paper, we consider an amplify-and-forward wireless relay system where multiple source nodes communicate with their corresponding destination nodes with the help of relay nodes. Conventionally, each relay equally distributes the available resources to its relayed sources. This approach is clearly sub-optimal since each user experiences dissimilar channel conditions, and thus, demands different amount of allocated resources to meet its quality-of-service (QoS) request. Therefore, this paper presents novel power allocation schemes to i) maximize the minimum signal-to-noise ratio among all users; ii) minimize the maximum transmit power over all sources; iii) maximize the network throughput. Moreover, due to limited power, it may be impossible to satisfy the QoS requirement for every user. Consequently, an admission control algorithm should first be carried out to maximize the number of users possibly served. Then, optimal power allocation is performed. Although the joint optimal admission control and power allocation problem is combinatorially hard, we develop an effective heuristic algorithm with significantly reduced complexity. Even though theoretically sub-optimal, it performs remarkably well. The proposed power allocation problems are formulated using geometric programming (GP), a well-studied class of nonlinear and nonconvex optimization. Since a GP problem is readily transformed into an equivalent convex optimization problem, optimal solution can be obtained efficiently. Numerical results demonstrate the effectiveness of our proposed approach

On the Performance of the Relay-ARQ Networks

This paper investigates the performance of relay networks in the presence of hybrid automatic repeat request (ARQ) feedback and adaptive power allocation. The throughput and the outage probability of different hybrid ARQ protocols are studied for independent and spatially-correlated fading channels. The results are obtained for the cases where there is a sum power constraint on the source and the relay or when each of the source and the relay are power-limited individually. With adaptive power allocation, the results demonstrate the efficiency of relay-ARQ techniques in different conditions.Comment: Accepted for publication in IEEE Trans. Veh. Technol. 201

Precoding for coded communication on block fading channels and cooperative communications

We study precoding for the outage probability minimization of block fading (BF) channels and BF relay channels. Recently, an upper bound on the outage probability with precoding was established for BF channels, but only for high instantaneous SNR. This upper bound is much easier to minimize than the actual outage probability, so that optimal precoding matrices can be determined without much computational effort. Here, we provide a proof for the upper bound on the outage probability at low instantaneous SNR. Next, the structure of the precoding matrix is simplified so that it can be easily constructed for an arbitrary number of blocks in the BF channel. Finally, we apply this technique to cooperative communications

Optimal Save-Then-Transmit Protocol for Energy Harvesting Wireless Transmitters

In this paper, the design of a wireless communication device relying exclusively on energy harvesting is considered. Due to the inability of rechargeable energy sources to charge and discharge at the same time, a constraint we term the energy half-duplex constraint, two rechargeable energy storage devices (ESDs) are assumed so that at any given time, there is always one ESD being recharged. The energy harvesting rate is assumed to be a random variable that is constant over the time interval of interest. A save-then-transmit (ST) protocol is introduced, in which a fraction of time {\rho} (dubbed the save-ratio) is devoted exclusively to energy harvesting, with the remaining fraction 1 - {\rho} used for data transmission. The ratio of the energy obtainable from an ESD to the energy harvested is termed the energy storage efficiency, {\eta}. We address the practical case of the secondary ESD being a battery with {\eta} < 1, and the main ESD being a super-capacitor with {\eta} = 1. The optimal save-ratio that minimizes outage probability is derived, from which some useful design guidelines are drawn. In addition, we compare the outage performance of random power supply to that of constant power supply over the Rayleigh fading channel. The diversity order with random power is shown to be the same as that of constant power, but the performance gap can be large. Furthermore, we extend the proposed ST protocol to wireless networks with multiple transmitters. It is shown that the system-level outage performance is critically dependent on the relationship between the number of transmitters and the optimal save-ratio for single-channel outage minimization. Numerical results are provided to validate our proposed study.Comment: This is the longer version of a paper to appear in IEEE Transactions on Wireless Communication