On the Design of a Novel Joint Network-Channel Coding Scheme for the Multiple Access Relay Channel

This paper proposes a novel joint non-binary network-channel code for the Time-Division Decode-and-Forward Multiple Access Relay Channel (TD-DF-MARC), where the relay linearly combines -- over a non-binary finite field -- the coded sequences from the source nodes. A method based on an EXIT chart analysis is derived for selecting the best coefficients of the linear combination. Moreover, it is shown that for different setups of the system, different coefficients should be chosen in order to improve the performance. This conclusion contrasts with previous works where a random selection was considered. Monte Carlo simulations show that the proposed scheme outperforms, in terms of its gap to the outage probabilities, the previously published joint network-channel coding approaches. Besides, this gain is achieved by using very short-length codewords, which makes the scheme particularly attractive for low-latency applications.Comment: 28 pages, 9 figures; Submitted to IEEE Journal on Selected Areas in Communications - Special Issue on Theories and Methods for Advanced Wireless Relays, 201

A Study on the Impact of Locality in the Decoding of Binary Cyclic Codes

In this paper, we study the impact of locality on the decoding of binary cyclic codes under two approaches, namely ordered statistics decoding (OSD) and trellis decoding. Given a binary cyclic code having locality or availability, we suitably modify the OSD to obtain gains in terms of the Signal-To-Noise ratio, for a given reliability and essentially the same level of decoder complexity. With regard to trellis decoding, we show that careful introduction of locality results in the creation of cyclic subcodes having lower maximum state complexity. We also present a simple upper-bounding technique on the state complexity profile, based on the zeros of the code. Finally, it is shown how the decoding speed can be significantly increased in the presence of locality, in the moderate-to-high SNR regime, by making use of a quick-look decoder that often returns the ML codeword.Comment: Extended version of a paper submitted to ISIT 201

Capacity of Coded Index Modulation

We consider the special case of index coding over the Gaussian broadcast channel where each receiver has prior knowledge of a subset of messages at the transmitter and demands all the messages from the source. We propose a concatenated coding scheme for this problem, using an index code for the Gaussian channel as an inner code/modulation to exploit side information at the receivers, and an outer code to attain coding gain against the channel noise. We derive the capacity region of this scheme by viewing the resulting channel as a multiple-access channel with many receivers, and relate it to the 'side information gain' -- which is a measure of the advantage of a code in utilizing receiver side information -- of the inner index code/modulation. We demonstrate the utility of the proposed architecture by simulating the performance of an index code/modulation concatenated with an off-the-shelf convolutional code through bit-interleaved coded-modulation.Comment: To appear in Proc. IEEE Int. Symp. Inf. Theory (ISIT) 2015, Hong Kong, Jun. 2015. 5 pages, 4 figure

A unary error correction code for the near-capacity joint source and channel coding of symbol values from an infinite set

A novel Joint Source and Channel Code (JSCC) is proposed, which we refer to as the Unary Error Correction (UEC) code. Unlike existing JSCCs, our UEC facilitates the practical encoding of symbol values that are selected from a set having an infinite cardinality. Conventionally, these symbols are conveyed using Separate Source and Channel Codes (SSCCs), but we demonstrate that the residual redundancy that is retained following source coding results in a capacity loss, which is found to have a value of 1.11 dB in a particular practical scenario. By contrast, the proposed UEC code can eliminate this capacity loss, or reduce it to an infinitesimally small value. Furthermore, the UEC code has only a moderate complexity, facilitating its employment in practical low-complexity applications