347 research outputs found
Linear Precoders for Non-Regenerative Asymmetric Two-way Relaying in Cellular Systems
Two-way relaying (TWR) reduces the spectral-efficiency loss caused in
conventional half-duplex relaying. TWR is possible when two nodes exchange data
simultaneously through a relay. In cellular systems, data exchange between base
station (BS) and users is usually not simultaneous e.g., a user (TUE) has
uplink data to transmit during multiple access (MAC) phase, but does not have
downlink data to receive during broadcast (BC) phase. This non-simultaneous
data exchange will reduce TWR to spectrally-inefficient conventional
half-duplex relaying. With infrastructure relays, where multiple users
communicate through a relay, a new transmission protocol is proposed to recover
the spectral loss. The BC phase following the MAC phase of TUE is now used by
the relay to transmit downlink data to another user (RUE). RUE will not be able
to cancel the back-propagating interference. A structured precoder is designed
at the multi-antenna relay to cancel this interference. With multiple-input
multiple-output (MIMO) nodes, the proposed precoder also triangulates the
compound MAC and BC phase MIMO channels. The channel triangulation reduces the
weighted sum-rate optimization to power allocation problem, which is then cast
as a geometric program. Simulation results illustrate the effectiveness of the
proposed protocol over conventional solutions.Comment: 30 pages, 7 figures, submitted to IEEE Transactions on Wireless
Communication
Wireless Information and Energy Transfer for Two-Hop Non-Regenerative MIMO-OFDM Relay Networks
This paper investigates the simultaneous wireless information and energy
transfer for the non-regenerative multipleinput multiple-output orthogonal
frequency-division multiplexing (MIMO-OFDM) relaying system. By considering two
practical receiver architectures, we present two protocols, time switchingbased
relaying (TSR) and power splitting-based relaying (PSR). To explore the system
performance limit, we formulate two optimization problems to maximize the
end-to-end achievable information rate with the full channel state information
(CSI) assumption. Since both problems are non-convex and have no known solution
method, we firstly derive some explicit results by theoretical analysis and
then design effective algorithms for them. Numerical results show that the
performances of both protocols are greatly affected by the relay position.
Specifically, PSR and TSR show very different behaviors to the variation of
relay position. The achievable information rate of PSR monotonically decreases
when the relay moves from the source towards the destination, but for TSR, the
performance is relatively worse when the relay is placed in the middle of the
source and the destination. This is the first time to observe such a
phenomenon. In addition, it is also shown that PSR always outperforms TSR in
such a MIMO-OFDM relaying system. Moreover, the effect of the number of
antennas and the number of subcarriers are also discussed.Comment: 16 pages, 12 figures, to appear in IEEE Selected Areas in
Communication
Joint Source and Relay Precoding Designs for MIMO Two-Way Relaying Based on MSE Criterion
Properly designed precoders can significantly improve the spectral efficiency
of multiple-input multiple-output (MIMO) relay systems. In this paper, we
investigate joint source and relay precoding design based on the
mean-square-error (MSE) criterion in MIMO two-way relay systems, where two
multi-antenna source nodes exchange information via a multi-antenna
amplify-and-forward relay node. This problem is non-convex and its optimal
solution remains unsolved. Aiming to find an efficient way to solve the
problem, we first decouple the primal problem into three tractable
sub-problems, and then propose an iterative precoding design algorithm based on
alternating optimization. The solution to each sub-problem is optimal and
unique, thus the convergence of the iterative algorithm is guaranteed.
Secondly, we propose a structured precoding design to lower the computational
complexity. The proposed precoding structure is able to parallelize the
channels in the multiple access (MAC) phase and broadcast (BC) phase. It thus
reduces the precoding design to a simple power allocation problem. Lastly, for
the special case where only a single data stream is transmitted from each
source node, we present a source-antenna-selection (SAS) based precoding design
algorithm. This algorithm selects only one antenna for transmission from each
source and thus requires lower signalling overhead. Comprehensive simulation is
conducted to evaluate the effectiveness of all the proposed precoding designs.Comment: 32 pages, 10 figure
Power Allocation in Two-Hop Amplify-and-Forward MIMO Relay Systems with QoS requirements
The problem of minimizing the total power consumption while satisfying
different quality-of-service (QoS) requirements in a two-hop multiple-input
multiple-output network with a single non-regenerative relay is considered. As
shown by Y. Rong in [1], the optimal processing matrices for both linear and
non-linear transceiver architectures lead to the diagonalization of the
source-relay-destination channel so that the power minimization problem reduces
to properly allocating the available power over the established links.
Unfortunately, finding the solution of this problem is numerically difficult as
it is not in a convex form. To overcome this difficulty, existing solutions
rely on the computation of upper- and lower-bounds that are hard to obtain or
require the relaxation of the QoS constraints. In this work, a novel approach
is devised for both linear and non-linear transceiver architectures, which
allows to closely approximate the solutions of the non-convex power allocation
problems with those of convex ones easy to compute in closed-form by means of
multi-step procedures of reduced complexity. Computer simulations are used to
assess the performance of the proposed approach and to make comparisons with
alternatives
A Tutorial on the Optimization of Amplify-and-Forward MIMO Relay Systems
The remarkable promise of multiple-input multiple-output (MIMO) wireless channels has motivated an intense research activity to characterize the theoretical and practical issues associated with the design of transmit (source) and receive (destination) processing matrices under different operating conditions. This activity was primarily focused on point-to-point (single-hop) communications but more recently there has been an extensive work on two-hop or multi-hop settings in which single or multiple relays are used to deliver the information from the source to the destination. The aim of this tutorial is to provide an up-to-date overview of the fundamental results and practical implementation issues of designing amplify-and-forward MIMO relay systems
Secure Beamforming for MIMO Two-Way Communications with an Untrusted Relay
This paper studies the secure beamforming design in a multiple-antenna
three-node system where two source nodes exchange messages with the help of an
untrusted relay node. The relay acts as both an essential signal forwarder and
a potential eavesdropper. Both two-phase and three-phase two-way relay
strategies are considered. Our goal is to jointly optimize the source and relay
beamformers for maximizing the secrecy sum rate of the two-way communications.
We first derive the optimal relay beamformer structures. Then, iterative
algorithms are proposed to find source and relay beamformers jointly based on
alternating optimization. Furthermore, we conduct asymptotic analysis on the
maximum secrecy sum-rate. Our analysis shows that when all transmit powers
approach infinity, the two-phase two-way relay scheme achieves the maximum
secrecy sum rate if the source beamformers are designed such that the received
signals at the relay align in the same direction. This reveals an important
advantage of signal alignment technique in against eavesdropping. It is also
shown that if the source powers approach zero the three-phase scheme performs
the best while the two-phase scheme is even worse than direct transmission.
Simulation results have verified the efficiency of the secure beamforming
algorithms as well as the analytical findings.Comment: 10 figures, Submitted to IEEE Transactions on Signal Processin
How to Understand LMMSE Transceiver Design for MIMO Systems From Quadratic Matrix Programming
In this paper, a unified linear minimum mean-square-error (LMMSE) transceiver
design framework is investigated, which is suitable for a wide range of
wireless systems. The unified design is based on an elegant and powerful
mathematical programming technology termed as quadratic matrix programming
(QMP). Based on QMP it can be observed that for different wireless systems,
there are certain common characteristics which can be exploited to design LMMSE
transceivers e.g., the quadratic forms. It is also discovered that evolving
from a point-to-point MIMO system to various advanced wireless systems such as
multi-cell coordinated systems, multi-user MIMO systems, MIMO cognitive radio
systems, amplify-and-forward MIMO relaying systems and so on, the quadratic
nature is always kept and the LMMSE transceiver designs can always be carried
out via iteratively solving a number of QMP problems. A comprehensive framework
on how to solve QMP problems is also given. The work presented in this paper is
likely to be the first shoot for the transceiver design for the future
ever-changing wireless systems.Comment: 31 pages, 4 figures, Accepted by IET Communication
- …