Coherence-Multiplexed Optical RF Feeder Networks

An optical RF feeding system for wireless access is proposed, in which the radio access points are distinguished by means of coherence multiplexing (CM). CM is a rather unknown and potentially inexpensive optical code division multiple access technique, which is particularly suitable for relatively short-range applications with moderate transmission bandwidth requirements. Subcarrier multiplexing (SCM) can possibly be used on top of CM, either as single-channel or multichannel SCM. The performances of the resulting distribution networks are analyzed, incorporating the effect of chromatic dispersion, optical beat noise, shot noise, thermal noise, and—in the case of multichannel SCM—intermodulation distortion. The results of the IEEE 802.11b standard for wireless LAN.\u

Baseband Radio over Fiber Aided Millimeter-Wave Distributed Antenna for Optical/Wireless Integration

A Baseband Radio Over Fiber (BROF) architecture is proposed, where upto four Radio Frequency (RF) carriers can be generated, while using the heterodyne photo-detection of only two optical signals. This proposed BROF architecture has a star-like structure and it is composed of six Radio Access Units (RAUs), where data is transmitted from the Central Unit (CU) to the Base Station (BS) and from the BS to the RAU over a distance of 20 Km and 0.3 Km, respectively, at a rate of 768 Mbps. The performance of the system supporting four carrier frequencies drops by at most 1dB, at a BER of 10-9, compared to conventional heterodyne photo-detection

Development of highly flexible broadband networks incorporating wavelength division multiplexing and sub-carrier division multiplexing in a hybrid radio/fiber distribution system

A radio over fiber distribution system incorporating both SCM and WDM technologies is presented. The SCM signal contains five 155 Mbit/s data channels, centered around 18.5 GHz with 450 MHz spacing. This signal is directly modulated onto three high-speed lasers with emission frequencies spaced by 50 GHz. Bragg filters are employed at the receiver base station in order both to demultiplex the required optical channel, and to ensure that the detected signal is single side band (in order to overcome dispersion limitations on the link). Our results show negligible degradation in system performance for the demultiplexing of the WDM signal compared with the back-to-back performance curves

Joint distribution of polarization-multiplexed UWB and WiMAX radio in PON

In this paper, the feasibility of the joint distribution of ultra-wideband (UWB) and WIMAX wireless using polarization multiplexing as a coexistence technique is proposed and experimentally demonstrated within the framework of passive optical networks (PON). Four single- and orthogonal-polarization multiplexing schemes are studied targeting to reduce the mutual interference when UWB and WiMAX are distributed jointly through standard single-mode fiber (SSMF) without transmission impairments compensation techniques and amplification. Experimental results indicate successful transmission up to 25 km, in SSMF exceeding the range in typical PON deployments. The radio link penalty introduced by optical transmission is also investigated in this paper

Simultaneous chromatic dispersion, polarization-mode-dispersion and OSNR monitoring at 40Gbit/s

A novel method for independent and simultaneous monitoring of chromatic dispersion ( CD), first-order PMD and OSNR in 40Gbit/s systems is proposed and demonstrated. This is performed using in-band tone monitoring of 5GHz, optically down-converted to a low intermediate-frequency (IF) of 10kHz. The measurement provides a large monitoring range with good accuracies for CD (4742 +/- 100ps/nm), differential group delay (DGD) (200 +/- 4ps) and OSNR (23 +/- 1dB), independently of the bit-rate. In addition, the use of electro-absorption modulators (EAM) for the simultaneous down-conversion of all channels and the use of low-speed detectors makes it cost effective for multi-channel operation. (C) 2008 Optical Society of Americ

Chromatic dispersion monitoring for high-speed WDM systems using two-photon absorption in a semiconductor microcavity

This paper presents a theoretical and experimental investigation into the use of a two-photon absorption (TPA) photodetector for use in chromatic dispersion (CD) monitoring in high-speed, WDM network. In order to overcome the inefficiency associated with the nonlinear optical-to-electrical TPA process, a microcavity structure is employed. An interesting feature of such a solution is the fact that the microcavity enhances only a narrow wavelength range determined by device design and angle at which the signal enters the device. Thus, a single device can be used to monitor a number of different wavelength channels without the need for additional external filters. When using a nonlinear photodetector, the photocurrent generated for Gaussian pulses is inversely related to the pulsewidth. However, when using a microcavity structure, the cavity bandwidth also needs to be considered, as does the shape of the optical pulses incident on the device. Simulation results are presented for a variety of cavity bandwidths, pulse shapes and durations, and spacing between adjacent wavelength channels. These results are verified experimental using a microcavity with a bandwidth of 260 GHz (2.1 nm) at normal incident angle, with the incident signal comprising of two wavelength channels separated by 1.25 THz (10 nm), each operating at an aggregate data rate of 160 Gb/s. The results demonstrate the applicability of the presented technique to monitor accumulated dispersion fluctuations in a range of 3 ps/nm for 160 Gb/s RZ data channel

Green radio communication networks applying radio-over-fibre technology for wireless access

Wireless communication increasingly is becoming the first choice link to enter into the global information society. It is an essential part of broadband communication networks, due to its capacity to cover the end-user domain, outdoors or indoors. The use of mobile phones and broadband has already exceeded the one of the fixed telephones and has caused tremendous changes in peoples life, as not only to be recognised in the current political overthrows. The all-around presence of wireless communication links combined with functions that support mobility will make a roaming person-bound communication network possible in the near future. This idea of a personal network, in which a user has his own communication environment available everywhere, necessitates immense numbers of radio access points to maintain the wireless links and support mobility. The progress towards “all-around wireless” needs budget and easily maintainable radio access points, with simplified signal processing and consolidation of the radio network functions in a central station. The RF energy consumption in mobile base stations is one of the main problems in the wireless communication system, which has led to the worldwide research in so called green communication, which offers an environmentally friendly and cost-effective solution. In order to extend networks and mobility support, the simplification of antenna stations and broadband communication capacity becomes an increasingly urgent demand, also the extension of the wireless signal transmission distance to consolidate the signal processing in a centralised site. Radio-over-Fibre technology (RoF) was considered and found to be the most promising solution to achieve effective delivery of wireless and baseband signals, also to reduce RF energy consumption. The overall aim of this research project was to simulate the transmission of wireless and baseband RF signals via fibre for a long distance in high quality, consuming a low-power budget. Therefore, this thesis demonstrated a green radio communication network and the advantage of transmitting signals via fibre rather than via air. The contributions of this research work were described in the follows: Firstly, a comparison of the power consumption in WiMAX via air and fibre is presented. As shown in the simulation results, the power budget for the transmission of 64 QAM WiMAX IEEE 802.16-2005 via air for a distance of 5km lies at -189.67 dB, whereas for the transmission via RoF for a distance of 140km, the power consumption ranges at 65dB. Through the deployment of a triple symmetrical compensator technique, consisting of SMF, DCF and FBG, the transmission distance of the 54 Mbps WiMAX signal can be increased to 410km without increasing the power budget of 65dB. An amendment of the triple compensator technique to SMF, DCF and CFBG allows a 120Mbps WiMAX signal transmission with a clear RF spectrum of 3.5 GHz and constellation diagram over a fibre length of 792km using a power budget of 192dB. Secondly, the thesis demonstrates a simulation setup for the deployment of more than one wireless system, namely 64 QAM WiMAX IEEE 802.16-2005 and LTE, for a data bit rate of 1Gbps via Wavelength Division Multiplexing (WDM) RoF over a transmission distance of 1800km. The RoF system includes two triple symmetrical compensator techniques - DCF, SMF, and CFBG - to obtain a large bandwidth, power budget of 393.6dB and a high signal quality for the long transmission distance. Finally, the thesis proposed a high data bit rate and energy efficient simulation architecture, applying a passive optical component for a transmission span up to 600km. A Gigabit Optical Passive Network (GPON) based on RoF downlink 2.5 Gbps and uplink 1.25Gbps is employed to carry LTE and WiMAX, also 18 digital channels by utilising Coarse Wavelength Division Multiplexing (CWDM). The setup achieved high data speed, a low-power budget of 151.2dB, and an increased service length of up to 600km