Multipath Multiplexing for Capacity Enhancement in SIMO Wireless Systems

This paper proposes a novel and simple orthogonal faster than Nyquist (OFTN) data transmission and detection approach for a single input multiple output (SIMO) system. It is assumed that the signal having a bandwidth $B$ is transmitted through a wireless channel with $L$ multipath components. Under this assumption, the current paper provides a novel and simple OFTN transmission and symbol-by-symbol detection approach that exploits the multiplexing gain obtained by the multipath characteristic of wideband wireless channels. It is shown that the proposed design can achieve a higher transmission rate than the existing one (i.e., orthogonal frequency division multiplexing (OFDM)). Furthermore, the achievable rate gap between the proposed approach and that of the OFDM increases as the number of receiver antennas increases for a fixed value of $L$. This implies that the performance gain of the proposed approach can be very significant for a large-scale multi-antenna wireless system. The superiority of the proposed approach is shown theoretically and confirmed via numerical simulations. {Specifically, we have found {upper-bound average} rates of 15 bps/Hz and 28 bps/Hz with the OFDM and proposed approaches, respectively, in a Rayleigh fading channel with 32 receive antennas and signal to noise ratio (SNR) of 15.3 dB. The extension of the proposed approach for different system setups and associated research problems is also discussed.Comment: IEEE Transactions on Wireless Communication

INTERFERENCE MANAGEMENT IN LTE SYSTEM AND BEYOUND

The key challenges to high throughput in cellular wireless communication system are interference, mobility and bandwidth limitation. Mobility has never been a problem until recently, bandwidth has been constantly improved upon through the evolutions in cellular wireless communication system but interference has been a constant limitation to any improvement that may have resulted from such evolution. The fundamental challenge to a system designer or a researcher is how to achieve high data rate in motion (high speed) in a cellular system that is intrinsically interference-limited. Multi-antenna is the solution to data on the move and the capacity of multi-antenna system has been demonstrated to increase proportionally with increase in the number of antennas at both transmitter and receiver for point-to-point communications and multi-user environment. However, the capacity gain in both uplink and downlink is limited in a multi-user environment like cellular system by interference, the number of antennas at the base station, complexity and space constraint particularly for a mobile terminal. This challenge in the downlink provided the motivation to investigate successive interference cancellation (SIC) as an interference management tool LTE system and beyond. The Simulation revealed that ordered successive interference (OSIC) out performs non-ordered successive interference cancellation (NSIC) and the additional complexity is justified based on the associated gain in BER performance of OSIC. The major drawback of OSIC is that it is not efficient in network environment employing power control or power allocation. Additional interference management techniques will be required to fully manage the interference.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format

A Study on MIMO Wireless Communication Channel Performance in Correlated Channels

MIMO wireless communication system is gaining popularity by days due to its versatility and wide applicability. When signal travels through wireless link it gets affected due to the disturbances present in the channel i.e. different sorts of interference and noise. Plus because there may or may not be a Line of sight (LOS) path between transmitter and receiver signal copies leaving the transmitter at the same time reaches the receiver with different delays and attenuation due to multiple reflections and interfere with each other at the receiver. Therefore fading of received signal power is also observed in case of a wireless MIMO link. In case of wireless two most important objectives can be channel estimation and signal detection. The importance of the wireless channel estimation can be attributed to faithful signal detection and transmit beam forming, power allocation etc. when Channel state information (CSI) is communicated to the transmitter via feedback loop in case of uni-directional channel or by simultaneous estimation by the transmitter itself in case of bi-directional channel. This text introduces some aspects of signal detection and mostly different aspects of channel estimation and explains why it is important in context of signal detection, beam forming etc. A brief introduction to antenna arrays and beam forming procedures have been given here. The cause of occurrence of spatial and temporal correlations have been discussed and different ways of modelling the spatial and temporal correlations involved are also briefly introduced in this text. How different link and link-end properties e.g. antenna spacing, angular spread of radiation beam, mean angle of radiation, mutual coupling present between elements of an antenna array etc. affects the channel correlations thereby affecting the performance of the MIMO wireless communication channel. Modelling of antenna mutual coupling and different estimation and compensation techniques are also discussed here

Frequency-domain transmit processing for MIMO SC-FDMA in wideband propagation channels

This document is made available in accordance with publisher policies. Please cite only the published version using the reference above. Full terms of use are available