396 research outputs found
An antenna switching based NOMA scheme for IEEE 802.15.4 concurrent transmission
This paper introduces a Non-Orthogonal Multiple Access (NOMA) scheme to support concurrent transmission of multiple IEEE 802.15.4 packets. Unlike collision avoidance Multiple Access Control (MAC), concurrent transmission supports Concurrent-MAC (C-MAC) where packet collision is allowed. The communication latency can be reduced by C-MAC because a user can transmit immediately without waiting for the completion of other users’ transmission. The big challenge of concurrent transmission is that error free demodulation of multiple collided packets hardly can be achieved due to severe Multiple Access Interference (MAI). To improve the demodulation performance with MAI presented, we introduce an architecture with multiple switching antennas sharing a single analog transceiver to capture spatial character of different users. Successive Interference Cancellation (SIC) algorithm is designed to separate collided packets by utilizing the spatial character. Simulation shows that at least five users can transmit concurrently to the SIC receiver equipped with eight antennas without sacrificing Packet Error Rate
Efficient Downlink Channel Reconstruction for FDD Multi-Antenna Systems
In this paper, we propose an efficient downlink channel reconstruction scheme
for a frequency-division-duplex multi-antenna system by utilizing uplink
channel state information combined with limited feedback. Based on the spatial
reciprocity in a wireless channel, the downlink channel is reconstructed by
using frequency-independent parameters. We first estimate the gains, delays,
and angles during uplink sounding. The gains are then refined through downlink
training and sent back to the base station (BS). With limited overhead, the
refinement can substantially improve the accuracy of the downlink channel
reconstruction. The BS can then reconstruct the downlink channel with the
uplink-estimated delays and angles and the downlink-refined gains. We also
introduce and extend the Newtonized orthogonal matching pursuit (NOMP)
algorithm to detect the delays and gains in a multi-antenna multi-subcarrier
condition. The results of our analysis show that the extended NOMP algorithm
achieves high estimation accuracy. Simulations and over-the-air tests are
performed to assess the performance of the efficient downlink channel
reconstruction scheme. The results show that the reconstructed channel is close
to the practical channel and that the accuracy is enhanced when the number of
BS antennas increases, thereby highlighting that the promising application of
the proposed scheme in large-scale antenna array systems
5G Downlink Throughput Enhancement by Beams Consolidating at Vacant Traffic
The 3GPP release for 5G (R15) assigns each User Equipment (UE) a radio beam by employing Massive Multi-User MU-Multiple-Input-Multiple-Output (MIMO) technology. Each beam carries, at the downlink, a data rate according to the modulation and coding scheme (MCS) assigned by the base station (BS). For the limited existence of active UEs and during vacant traffic or standby UEs, the assigned beams will be transmitted, but not to any UE. This paper proposes a new scheme that consolidates vacant beams of inactive UEs, to the adjacent beam of the active UE or UE at the cell edge to duplicate the bandwidth of the new beam. The proposed scheme increases the level of desired modulation and coding scheme (MCS) to a higher scheme and hence enhances the spectral efficiency (SE) of the 5G mobile networks. Specifically, the BS consolidates (combines) multiple radio beams along with the assigned beam during vacant traffic. More than two beams are consolidated in particular to the active UE to increase the bit rate by assigning higher MCS. The simulation evaluation depicted that the performance of beams consolidation provides a gain of 3.5 dB above than the state before beams consolidation. Moreover, more than 40 % improvement in UE throughput is achieved
RIS-Aided Cell-Free Massive MIMO Systems for 6G: Fundamentals, System Design, and Applications
An introduction of intelligent interconnectivity for people and things has
posed higher demands and more challenges for sixth-generation (6G) networks,
such as high spectral efficiency and energy efficiency, ultra-low latency, and
ultra-high reliability. Cell-free (CF) massive multiple-input multiple-output
(mMIMO) and reconfigurable intelligent surface (RIS), also called intelligent
reflecting surface (IRS), are two promising technologies for coping with these
unprecedented demands. Given their distinct capabilities, integrating the two
technologies to further enhance wireless network performances has received
great research and development attention. In this paper, we provide a
comprehensive survey of research on RIS-aided CF mMIMO wireless communication
systems. We first introduce system models focusing on system architecture and
application scenarios, channel models, and communication protocols.
Subsequently, we summarize the relevant studies on system operation and
resource allocation, providing in-depth analyses and discussions. Following
this, we present practical challenges faced by RIS-aided CF mMIMO systems,
particularly those introduced by RIS, such as hardware impairments and
electromagnetic interference. We summarize corresponding analyses and solutions
to further facilitate the implementation of RIS-aided CF mMIMO systems.
Furthermore, we explore an interplay between RIS-aided CF mMIMO and other
emerging 6G technologies, such as next-generation multiple-access (NGMA),
simultaneous wireless information and power transfer (SWIPT), and millimeter
wave (mmWave). Finally, we outline several research directions for future
RIS-aided CF mMIMO systems.Comment: 30 pages, 15 figure
- …