Designing application software in wide area network settings

Progress in methodologies for developing robust local area network software has not been matched by similar results for wide area settings. The design of application software spanning multiple local area environments is examined. For important classes of applications, simple design techniques are presented that yield fault tolerant wide area programs. An implementation of these techniques as a set of tools for use within the ISIS system is described

Optimistic total order in wide area networks

Total order multicast greatly simplifies the implementa- tion of fault-tolerant services using the replicated state ma- chine approach. The additional latency of total ordering can be masked by taking advantage of spontaneous order- ing observed in LANs: A tentative delivery allows the ap- plication to proceed in parallel with the ordering protocol. The effectiveness of the technique rests on the optimistic as- sumption that a large share of correctly ordered tentative deliveries offsets the cost of undoing the effect of mistakes. This paper proposes a simple technique which enables the usage of optimistic delivery also in WANs with much larger transmission delays where the optimistic assumption does not normally hold. Our proposal exploits local clocks and the stability of network delays to reduce the mistakes in the ordering of tentative deliveries. An experimental evalu- ation of a modified sequencer-based protocol is presented, illustrating the usefulness of the approach in fault-tolerant database management

CSP channels for CAN-bus connected embedded control systems

Closed loop control system typically contains multitude of sensors and actuators operated simultaneously. So they are parallel and distributed in its essence. But when mapping this parallelism to software, lot of obstacles concerning multithreading communication and synchronization issues arise. To overcome this problem, the CT kernel/library based on CSP algebra has been developed. This project (TES.5410) is about developing communication extension to the CT library to make it applicable in distributed systems. Since the library is tailored for control systems, properties and requirements of control systems are taken into special consideration. Applicability of existing middleware solutions is examined. A comparison of applicable fieldbus protocols is done in order to determine most suitable ones and CAN fieldbus is chosen to be first fieldbus used. Brief overview of CSP and existing CSP based libraries is given. Middleware architecture is proposed along with few novel ideas