Decoder Hardware Architecture for HEVC

This chapter provides an overview of the design challenges faced in the implementation of hardware HEVC decoders. These challenges can be attributed to the larger and diverse coding block sizes and transform sizes, the larger interpolation filter for motion compensation, the increased number of steps in intra prediction and the introduction of a new in-loop filter. Several solutions to address these implementation challenges are discussed. As a reference, results for an HEVC decoder test chip are also presented.Texas Instruments Incorporate

A 249-Mpixel/s HEVC Video-Decoder Chip for 4K Ultra-HD Applications

High Efficiency Video Coding, the latest video standard, uses larger and variable-sized coding units and longer interpolation filters than [H.264 over AVC] to better exploit redundancy in video signals. These algorithmic techniques enable a 50% decrease in bitrate at the cost of computational complexity, external memory bandwidth, and, for ASIC implementations, on-chip SRAM of the video codec. This paper describes architectural optimizations for an HEVC video decoder chip. The chip uses a two-stage subpipelining scheme to reduce on-chip SRAM by 56 kbytes-a 32% reduction. A high-throughput read-only cache combined with DRAM-latency-aware memory mapping reduces DRAM bandwidth by 67%. The chip is built for HEVC Working Draft 4 Low Complexity configuration and occupies 1.77 mm[superscript 2] in 40-nm CMOS. It performs 4K Ultra HD 30-fps video decoding at 200 MHz while consuming 1.19 [nJ over pixel] of normalized system power.Texas Instruments Incorporate

An energy-aware system-on-chip architecture for intra prediction in HEVC standard

High resolution 4K and 8K are becoming the more used in video applications. Those resolutions are well supported in the new HEVC standard. Thus, embedded solutions such as development of dedicated ystems-On-Chips (SOC) to accelerate video processing on one chip instead of only software solutions are commendable. This paper proposes a novel parallel and high efficient hardware accelerator for the intra prediction block. This accelerator achieves a high-speed treatment due to pipelined processing units and parallel shaped architecture. The complexity of memory access is also reduced thanks to the proposed design with less increased power consumption. The implementation was performed on the 7 Series FPGA 28 nm technology resources on Zynq-7000 and results show, that the proposed architecture takes 16520 LUTs and can reach 143.65 MHz as a maximum frequency and it is able to support the throughput of 3840×2160 sequence at 90 frames per second

Algoritmo de estimação de movimento e sua arquitetura de hardware para HEVC

Doutoramento em Engenharia EletrotécnicaVideo coding has been used in applications like video surveillance, video conferencing, video streaming, video broadcasting and video storage. In a typical video coding standard, many algorithms are combined to compress a video. However, one of those algorithms, the motion estimation is the most complex task. Hence, it is necessary to implement this task in real time by using appropriate VLSI architectures. This thesis proposes a new fast motion estimation algorithm and its implementation in real time. The results show that the proposed algorithm and its motion estimation hardware architecture out performs the state of the art. The proposed architecture operates at a maximum operating frequency of 241.6 MHz and is able to process 1080p@60Hz with all possible variables block sizes specified in HEVC standard as well as with motion vector search range of up to ±64 pixels.A codificação de vídeo tem sido usada em aplicações tais como, vídeovigilância, vídeo-conferência, video streaming e armazenamento de vídeo. Numa norma de codificação de vídeo, diversos algoritmos são combinados para comprimir o vídeo. Contudo, um desses algoritmos, a estimação de movimento é a tarefa mais complexa. Por isso, é necessário implementar esta tarefa em tempo real usando arquiteturas de hardware apropriadas. Esta tese propõe um algoritmo de estimação de movimento rápido bem como a sua implementação em tempo real. Os resultados mostram que o algoritmo e a arquitetura de hardware propostos têm melhor desempenho que os existentes. A arquitetura proposta opera a uma frequência máxima de 241.6 MHz e é capaz de processar imagens de resolução 1080p@60Hz, com todos os tamanhos de blocos especificados na norma HEVC, bem como um domínio de pesquisa de vetores de movimento até ±64 pixels

A Dynamic Parallel and Pipelined Architecture for Intra Prediction in H.265 Standard

In the present world where technology is growing faster, the video based applications are rapidly increasing and needs a technology which supports high resolution videos. High Efficiency Video Coding (HEVC) method is one which works on 4K and 8K video applications. In this work we have implemented the new parallel and a hardware accelerator which is highly efficient for the intra prediction blocks. Due to parallel and pipelined architecture, Intra Prediction speeds up the process of prediction and also minimizes the time required for accessing the data from the memory. The given architecture design reduces Area, Power and Delay elements. The results when compared with different FPGA versions shows that our architecture consumes 69 LUTs in ZYNQ FPGA for 4X4 pixels

VLSI architectures design for encoders of High Efficiency Video Coding (HEVC) standard

The growing popularity of high resolution video and the continuously increasing demands for high quality video on mobile devices are producing stronger needs for more efficient video encoder. Concerning these desires, HEVC, a newest video coding standard, has been developed by a joint team formed by ISO/IEO MPEG and ITU/T VCEG. Its design goal is to achieve a 50% compression gain over its predecessor H.264 with an equal or even higher perceptual video quality. Motion Estimation (ME) being as one of the most critical module in video coding contributes almost 50%-70% of computational complexity in the video encoder. This high consumption of the computational resources puts a limit on the performance of encoders, especially for full HD or ultra HD videos, in terms of coding speed, bit-rate and video quality. Thus the major part of this work concentrates on the computational complexity reduction and improvement of timing performance of motion estimation algorithms for HEVC standard. First, a new strategy to calculate the SAD (Sum of Absolute Difference) for motion estimation is designed based on the statistics on property of pixel data of video sequences. This statistics demonstrates the size relationship between the sum of two sets of pixels has a determined connection with the distribution of the size relationship between individual pixels from the two sets. Taking the advantage of this observation, only a small proportion of pixels is necessary to be involved in the SAD calculation. Simulations show that the amount of computations required in the full search algorithm is reduced by about 58% on average and up to 70% in the best case. Secondly, from the scope of parallelization an enhanced TZ search for HEVC is proposed using novel schemes of multiple MVPs (motion vector predictor) and shared MVP. Specifically, resorting to multiple MVPs the initial search process is performed in parallel at multiple search centers, and the ME processing engine for PUs within one CU are parallelized based on the MVP sharing scheme on CU (coding unit) level. Moreover, the SAD module for ME engine is also parallelly implemented for PU size of 32×32. Experiments indicate it achieves an appreciable improvement on the throughput and coding efficiency of the HEVC video encoder. In addition, the other part of this thesis is contributed to the VLSI architecture design for finding the first W maximum/minimum values targeting towards high speed and low hardware cost. The architecture based on the novel bit-wise AND scheme has only half of the area of the best reference solution and its critical path delay is comparable with other implementations. While the FPCG (full parallel comparison grid) architecture, which utilizes the optimized comparator-based structure, achieves 3.6 times faster on average on the speed and even 5.2 times faster at best comparing with the reference architectures. Finally the architecture using the partial sorting strategy reaches a good balance on the timing performance and area, which has a slightly lower or comparable speed with FPCG architecture and a acceptable hardware cost

Low energy video processing and compression hardware designs

Digital video processing and compression algorithms are used in many commercial products such as mobile devices, unmanned aerial vehicles, and autonomous cars. Increasing resolution of videos used in these commercial products increased computational complexities of digital video processing and compression algorithms. Therefore, it is necessary to reduce computational complexities of digital video processing and compression algorithms, and energy consumptions of digital video processing and compression hardware without reducing visual quality. In this thesis, we propose a novel adaptive 2D digital image processing algorithm for 2D median filter, Gaussian blur and image sharpening. We designed low energy 2D median filter, Gaussian blur and image sharpening hardware using the proposed algorithm. We propose approximate HEVC intra prediction and HEVC fractional interpolation algorithms. We designed low energy approximate HEVC intra prediction and HEVC fractional interpolation hardware. We also propose several HEVC fractional interpolation hardware architectures. We propose novel computational complexity and energy reduction techniques for HEVC DCT and inverse DCT/DST. We designed high performance and low energy hardware for HEVC DCT and inverse DCT/DST including the proposed techniques. VII We quantified computation reductions achieved and video quality loss caused by the proposed algorithms and techniques. We implemented the proposed hardware architectures in Verilog HDL. We mapped the Verilog RTL codes to Xilinx Virtex 6 and Xilinx ZYNQ FPGAs, and estimated their power consumptions using Xilinx XPower Analyzer tool. The proposed algorithms and techniques significantly reduced the power and energy consumptions of these FPGA implementations in some cases with no PSNR loss and in some cases with very small PSNR loss

Análise do HEVC escalável : desempenho e controlo de débito

Mestrado em Engenharia Eletrónica e TelecomunicaçõesEsta dissertação apresenta um estudo da norma de codificação de vídeo de alta eficiência (HEVC) e a sua extensão para vídeo escalável, SHVC. A norma de vídeo SHVC proporciona um melhor desempenho quando codifica várias camadas em simultâneo do que quando se usa o codificador HEVC numa configuração simulcast. Ambos os codificadores de referência, tanto para a camada base como para a camada superior usam o mesmo modelo de controlo de débito, modelo R-λ, que foi otimizado para o HEVC. Nenhuma otimização de alocação de débito entre camadas foi até ao momento proposto para o modelo de testes (SHM 8) para a escalabilidade do HEVC (SHVC). Derivamos um novo modelo R-λ apropriado para a camada superior e para o caso de escalabilidade espacial, que conduziu a um ganho de BD-débito de 1,81% e de BD-PSNR de 0,025 em relação ao modelo de débito-distorção existente no SHM do SHVC. Todavia, mostrou-se também nesta dissertação que o proposto modelo de R-λ não deve ser usado na camada inferior (camada base) no SHVC e por conseguinte no HEVC.This dissertation provides a study of the High Efficiency Video Coding standard (HEVC) and its scalable extension, SHVC. The SHVC provides a better performance when encoding several layers simultaneously than using an HEVC encoder in a simulcast configuration. Both reference encoders, in the base layer and in the enhancement layer use the same rate control model, R-λ model, which was optimized for HEVC. No optimal bitrate partitioning amongst layers is proposed in scalable HEVC (SHVC) test model (SHM 8). We derived a new R-λ model for the enhancement layer and for the spatial case which led to a DB-rate gain of 1.81% and DB-PSNR gain of 0.025 in relation to the rate-distortion model of SHM-SHVC. Nevertheless, we also show in this dissertation that the proposed model of R-λ should not be used neither in the base layer nor in HEVC