197 research outputs found

    Investigation of the tolerance of wavelength-routed optical networks to traffic load variations.

    Get PDF
    This thesis focuses on the performance of circuit-switched wavelength-routed optical network with unpredictable traffic pattern variations. This characteristic of optical networks is termed traffic forecast tolerance. First, the increasing volume and heterogeneous nature of data and voice traffic is discussed. The challenges in designing robust optical networks to handle unpredictable traffic statistics are described. Other work relating to the same research issues are discussed. A general methodology to quantify the traffic forecast tolerance of optical networks is presented. A traffic model is proposed to simulate dynamic, non-uniform loads, and used to test wavelength-routed optical networks considering numerous network topologies. The number of wavelengths required and the effect of the routing and wavelength allocation algorithm are investigated. A new method of quantifying the network tolerance is proposed, based on the calculation of the increase in the standard deviation of the blocking probabilities with increasing traffic load non-uniformity. The performance of different networks are calculated and compared. The relationship between physical features of the network topology and traffic forecast tolerance is investigated. A large number of randomly connected networks with different sizes were assessed. It is shown that the average lightpath length and the number of wavelengths required for full interconnection of the nodes in static operation both exhibit a strong correlation with the network tolerance, regardless of the degree of load non-uniformity. Finally, the impact of wavelength conversion on network tolerance is investigated. Wavelength conversion significantly increases the robustness of optical networks to unpredictable traffic variations. In particular, two sparse wavelength conversion schemes are compared and discussed: distributed wavelength conversion and localized wavelength conversion. It is found that the distributed wavelength conversion scheme outperforms localized wavelength conversion scheme, both with uniform loading and in terms of the network tolerance. The results described in this thesis can be used for the analysis and design of reliable WDM optical networks that are robust to future traffic demand variations

    Dynamic routing and load balancing in IP-over-WDM networks

    Get PDF
    Master'sMASTER OF ENGINEERIN

    NETWORK DESIGN UNDER DEMAND UNCERTAINTY

    Get PDF
    A methodology for network design under demand uncertainty is proposed in this dissertation. The uncertainty is caused by the dynamic nature of the IP-based traffic which is expected to betransported directly over the optical layer in the future. Thus, there is a need to incorporate the uncertainty into a design modelexplicitly. We assume that each demand can be represented as a random variable, and then develop an optimization model to minimizethe cost of routing and bandwidth provisioning. The optimization problem is formulated as a nonlinear Multicommodity Flow problemusing Chance-Constrained Programming to capture both the demand variability and levels of uncertainty guarantee. Numerical work ispresented based on a heuristic solution approach using a linear approximation to transform the nonlinear problem to a simpler linearprogramming problem. In addition, the impact of the uncertainty on a two-layer network is investigated. This will determine how theChance-Constrained Programming based scheme can be practically implemented. Finally, the implementation guidelines for developingan updating process are provided

    Development of traffic planning techniques for energy efficient in ip over wdm networks under traffic uncertainty

    Get PDF

    Energy management in communication networks: a journey through modelling and optimization glasses

    Full text link
    The widespread proliferation of Internet and wireless applications has produced a significant increase of ICT energy footprint. As a response, in the last five years, significant efforts have been undertaken to include energy-awareness into network management. Several green networking frameworks have been proposed by carefully managing the network routing and the power state of network devices. Even though approaches proposed differ based on network technologies and sleep modes of nodes and interfaces, they all aim at tailoring the active network resources to the varying traffic needs in order to minimize energy consumption. From a modeling point of view, this has several commonalities with classical network design and routing problems, even if with different objectives and in a dynamic context. With most researchers focused on addressing the complex and crucial technological aspects of green networking schemes, there has been so far little attention on understanding the modeling similarities and differences of proposed solutions. This paper fills the gap surveying the literature with optimization modeling glasses, following a tutorial approach that guides through the different components of the models with a unified symbolism. A detailed classification of the previous work based on the modeling issues included is also proposed

    Dynamic wavelength allocation in IP/WDM metro access networks

    Get PDF
    Ankara : The Department of Electrical and Electronics Engineering and the Institute of Engineering and Science of Bilkent University, 2008.Thesis (Ph.D.) -- Bilkent University, 2008.Includes bibliographical references leaves 132-139.Increasing demand for bandwidth and proliferation of packet based traffic have been causing architectural changes in the communications infrastructure. In this evolution, metro networks face both the capacity and dynamic adaptability constraints. The increase in the access and backbone speeds result in high bandwidth requirements, whereas the popularity of wireless access and limited number of customers in metro area necessitates traffic adaptability. Traditional architecture which has been optimized for carrying circuit-switched connections, is far from meeting these requirements. Recently, several architectures have been proposed for future metro access networks. Nearly all of these solutions support dynamic allocation of bandwidth to follow fluctuations in the traffic demand. However, reconfiguration policies that can be used in this process have not been fully explored yet. In this thesis, dynamic wavelength allocation (DWA) policies for IP/WDM metro access networks with reconfiguration delays are considered. Reconfiguration actions incur a cost since a portion of the capacity becomes idle in the reconfiguration period due to the signalling latencies and tuning times of optical transceivers. Exact formulation of the DWA problem is developed as a Markov Decision Process (MDP) and a new cost function is proposed to attain both throughput efficiency and fairness. For larger problems, a heuristic approach based on first passage probabilities is developed. The performance of the method is evaluated under both stationary and non-stationary traffic conditions. The effects of relevant network and traffic parameters, such as delay and flow size are also discussed. Finally, performance bounds for the DWA methods are derived.Yetginer, EmrePh.D

    Balanced traffic planning under traffic uncertainty for ip over wdm with efficient energy consumption

    Get PDF

    Joint dimensioning of server and network infrastructure for resilient optical grids/clouds

    Get PDF
    We address the dimensioning of infrastructure, comprising both network and server resources, for large-scale decentralized distributed systems such as grids or clouds. We design the resulting grid/cloud to be resilient against network link or server failures. To this end, we exploit relocation: Under failure conditions, a grid job or cloud virtual machine may be served at an alternate destination (i.e., different from the one under failure-free conditions). We thus consider grid/cloud requests to have a known origin, but assume a degree of freedom as to where they end up being served, which is the case for grid applications of the bag-of-tasks (BoT) type or hosted virtual machines in the cloud case. We present a generic methodology based on integer linear programming (ILP) that: 1) chooses a given number of sites in a given network topology where to install server infrastructure; and 2) determines the amount of both network and server capacity to cater for both the failure-free scenario and failures of links or nodes. For the latter, we consider either failure-independent (FID) or failure-dependent (FD) recovery. Case studies on European-scale networks show that relocation allows considerable reduction of the total amount of network and server resources, especially in sparse topologies and for higher numbers of server sites. Adopting a failure-dependent backup routing strategy does lead to lower resource dimensions, but only when we adopt relocation (especially for a high number of server sites): Without exploiting relocation, potential savings of FD versus FID are not meaningful
    corecore