376 research outputs found
Performance Analysis of Iterative Channel Estimation and Multiuser Detection in Multipath DS-CDMA Channels
This paper examines the performance of decision feedback based iterative
channel estimation and multiuser detection in channel coded aperiodic DS-CDMA
systems operating over multipath fading channels. First, explicit expressions
describing the performance of channel estimation and parallel interference
cancellation based multiuser detection are developed. These results are then
combined to characterize the evolution of the performance of a system that
iterates among channel estimation, multiuser detection and channel decoding.
Sufficient conditions for convergence of this system to a unique fixed point
are developed.Comment: To appear in the IEEE Transactions on Signal Processin
Large-System Analysis of Multiuser Detection with an Unknown Number of Users: A High-SNR Approach
We analyze multiuser detection under the assumption that the number of users
accessing the channel is unknown by the receiver. In this environment, users'
activity must be estimated along with any other parameters such as data, power,
and location. Our main goal is to determine the performance loss caused by the
need for estimating the identities of active users, which are not known a
priori. To prevent a loss of optimality, we assume that identities and data are
estimated jointly, rather than in two separate steps. We examine the
performance of multiuser detectors when the number of potential users is large.
Statistical-physics methodologies are used to determine the macroscopic
performance of the detector in terms of its multiuser efficiency. Special
attention is paid to the fixed-point equation whose solution yields the
multiuser efficiency of the optimal (maximum a posteriori) detector in the
large signal-to-noise ratio regime. Our analysis yields closed-form approximate
bounds to the minimum mean-squared error in this regime. These illustrate the
set of solutions of the fixed-point equation, and their relationship with the
maximum system load. Next, we study the maximum load that the detector can
support for a given quality of service (specified by error probability).Comment: to appear in IEEE Transactions on Information Theor
A Tutorial on Nonorthogonal Multiple Access for 5G and Beyond
Today's wireless networks allocate radio resources to users based on the
orthogonal multiple access (OMA) principle. However, as the number of users
increases, OMA based approaches may not meet the stringent emerging
requirements including very high spectral efficiency, very low latency, and
massive device connectivity. Nonorthogonal multiple access (NOMA) principle
emerges as a solution to improve the spectral efficiency while allowing some
degree of multiple access interference at receivers. In this tutorial style
paper, we target providing a unified model for NOMA, including uplink and
downlink transmissions, along with the extensions tomultiple inputmultiple
output and cooperative communication scenarios. Through numerical examples, we
compare the performances of OMA and NOMA networks. Implementation aspects and
open issues are also detailed.Comment: 25 pages, 10 figure
On the Impact of Phase Noise in Communication Systems –- Performance Analysis and Algorithms
The mobile industry is preparing to scale up the network capacity by a factor of 1000x in order to cope with the staggering growth in mobile traffic. As a consequence, there is a tremendous pressure on the network infrastructure, where more cost-effective, flexible, high speed connectivity solutions are being sought for. In this regard, massive multiple-input multiple-output (MIMO) systems, and millimeter-wave communication systems are new physical layer technologies, which promise to facilitate the 1000 fold increase in network capacity. However, these technologies are extremely prone to hardware impairments like phase noise caused by noisy oscillators. Furthermore, wireless backhaul networks are an effective solution to transport data by using high-order signal constellations, which are also susceptible to phase noise impairments.
Analyzing the performance of wireless communication systems impaired by oscillator phase noise, and designing systems to operate efficiently in strong phase noise conditions are critical problems in communication theory. The criticality of these problems is accentuated with the growing interest in new physical layer technologies, and the deployment of wireless backhaul networks. This forms the main motivation for this thesis where we analyze the impact of phase noise on the system performance, and we also design algorithms in order to mitigate phase noise and its effects.
First, we address the problem of maximum a posteriori (MAP) detection of data in the presence of strong phase noise in single-antenna systems. This is achieved by designing a low-complexity joint phase-estimator data-detector. We show that the proposed method outperforms existing detectors, especially when high order signal constellations are used. Then, in order to further improve system performance, we consider the problem of optimizing signal constellations for transmission over channels impaired by phase noise. Specifically, we design signal constellations such that the error rate performance of the system is minimized, and the information rate of the system is maximized. We observe that these optimized constellations significantly improve the system performance, when compared to conventional constellations, and those proposed in the literature.
Next, we derive the MAP symbol detector for a MIMO system where each antenna at the transceiver has its own oscillator. We propose three suboptimal, low-complexity algorithms for approximately implementing the MAP symbol detector, which involve joint phase noise estimation and data detection. We observe that the proposed techniques significantly outperform the other algorithms in prior works. Finally, we study the impact of phase noise on the performance of a massive MIMO system, where we analyze both uplink and downlink performances. Based on rigorous analyses of the achievable rates, we provide interesting insights for the following question: how should oscillators be connected to the antennas at a base station, which employs a large number of antennas
Exploiting constructive interference for simultaneous wireless information and power transfer in multiuser downlink systems
In this paper we propose a power-efficient approach for information and energy transfer in multiple-input single output downlink systems. By means of data-aided precoding, we
exploit the constructive part of interference for both information decoding and wireless power transfer. Rather than suppressing interference as in conventional schemes, we take advantage of constructive interference among users, inherent in the downlink, as a source of both useful information signal energy and electrical
wireless energy. Specifically, we propose a new precoding design that minimizes the transmit power while guaranteeing the quality
of service (QoS) and energy harvesting constraints for generic phase shift keying modulated signals. The QoS constraints are
modified to accommodate constructive interference, based on the constructive regions in the signal constellation.
Although the resulting problem is nonconvex, several methods are developed for its solution. First we derive necessary and
sufficient conditions for the feasibility of the considered problem. Then we propose second-order cone programming and semi definite programming algorithms with polynomial complexity that provide upper and lower bounds to the optimal solution and establish the asymptotic optimality of these algorithms when the modulation order and SINR threshold tend to infinity. A
practical iterative algorithm is also proposed based on successive linear approximation of the non-convex terms yielding excellent results. More complex algorithms are also proposed to provide
tight upper and lower bounds for benchmarking purposes. Simulation results show significant power savings with the proposed data-aided precoding approach compared to the conventional precoding scheme
Rate-Splitting for Max-Min Fair Multigroup Multicast Beamforming in Overloaded Systems
In this paper, we consider the problem of achieving max-min fairness amongst
multiple co-channel multicast groups through transmit beamforming. We
explicitly focus on overloaded scenarios in which the number of transmitting
antennas is insufficient to neutralize all inter-group interference. Such
scenarios are becoming increasingly relevant in the light of growing
low-latency content delivery demands, and also commonly appear in multibeam
satellite systems. We derive performance limits of classical beamforming
strategies using DoF analysis unveiling their limitations; for example, rates
saturate in overloaded scenarios due to inter-group interference. To tackle
interference, we propose a strategy based on degraded beamforming and
successive interference cancellation. While the degraded strategy resolves the
rate-saturation issue, this comes at a price of sacrificing all spatial
multiplexing gains. This motivates the development of a unifying strategy that
combines the benefits of the two previous strategies. We propose a beamforming
strategy based on rate-splitting (RS) which divides the messages intended to
each group into a degraded part and a designated part, and transmits a
superposition of both degraded and designated beamformed streams. The
superiority of the proposed strategy is demonstrated through DoF analysis.
Finally, we solve the RS beamforming design problem and demonstrate significant
performance gains through simulations
Soft-in soft-output detection in the presence of parametric uncertainty via the Bayesian EM algorithm
We investigate the application of the Bayesian expectation-maximization (BEM) technique to the design of soft-in soft-out (SISO) detection algorithms for wireless communication systems operating over channels affected by parametric uncertainty. First, the BEM algorithm is described in detail and its relationship with the well-known expectation-maximization (EM) technique is explained. Then, some of its applications are illustrated. In particular, the problems of SISO detection of spread spectrum, single-carrier and multicarrier space-time block coded signals are analyzed. Numerical results show that BEM-based detectors perform closely to the maximum likelihood (ML) receivers endowed with perfect channel state information as long as channel variations are not too fast
- …