Proportional-Integral Extremum Seeking for Optimizing Power of Vapor Compression Systems

Conventionally, online methods for minimizing power consumption of vapor compression systems rely on the use of physical models. These model-based approaches attempt to describe the influence of commanded inputs, disturbances and setpoints on the thermodynamic behavior of the system and the resultant consumed electrical power. These models are then used online to predict the combination of inputs for a measured set of thermodynamic conditions that both meets the heat load and minimizes power consumption. However, these models of vapor compression systems must contain nonlinear terms of sufficient complexity in order to accurately describe the region near the optimum operating point(s), but also must rely on simplifying assumptions in order to produce a mathematically tractable representation. For these reasons, model-based online optimization of vapor compression machines have not gained traction in application, and have created an opportunity for model-free techniques such as extremum seeking control, which is gradient descent optimization implemented as a feedback controller. While traditional perturbation-based extremum seeking controllers for vapor compression systems have proven effective at minimizing power without requiring a process model, the algorithm\u27s requirement for multiple distinct timescales has limited the applicability of this method to laboratory tests where boundary conditions can be carefully controlled, or simulation studies with unrealistic convergence times. Perturbation-based extremum seeking requires that the control input be manipulated with a time constant approximately two orders of magnitude slower than the slowest vapor compression system dynamics, otherwise instabilities in the closed loop system occur. As a result, convergence to the optimum for slow processes such as thermal systems is restrictive due to inefficient estimation of the gradient, and slow (integral-action dominated) adaptation in the extremum seeking control law. In order to address this timescale separation issue, we have previously developed an algorithm called ``time-varying extremum seeking that more efficiently estimates the gradient of the performance metric and applied this algorithm to the problem of setpoint optimization for compressor temperatures. That algorithm improved the convergence rate to one timescale slower than the vapor compression machine dynamics. In this paper, we optimize power consumption through the application of a newly-developed proportional--integral extremum seeking controller (PI-ESC) that converges at the same timescale as the process. This method uses the improved gradient estimation routines of time-varying extremum seeking but also modifies the control law to include terms proportional to the estimated gradient. This modification of the control law, in turn, requires a revision to the gradient estimator in order to avoid bias. PI-ESC is applied to the problem of compressor discharge temperature selection for a vapor compression system so that power consumption is minimized. Because of the improved convergence properties of PI-ESC, we show that optimum values of discharge temperature can be tracked in the presence of realistic disturbances such as variation in the outdoor air temperature---enabling application of extremum seeking control to vapor compression systems in environments where previous methods have failed. The method is demonstrated experimentally on a 2.8 kW split ductless room air conditioner and in simulation using a custom-developed Modelica model

Investigation of Some Self-Optimizing Control Problems for Net-Zero Energy Buildings

Green buildings are sustainable buildings designed to be environmentally responsible and resource efficient. The Net-Zero Energy Building (NZEB) concept is anchored on two pillars: reducing the energy consumption and enhancing the local energy generation. In other words, efficient operation of the existing building equipment and efficient power generation of building integrated renewable energy sources are two important factors of NZEB development. The heating, ventilation and air conditioning (HVAC) systems are an important class of building equipment that is responsible for large portion of building energy usage, while the building integrated photovoltaic (BIPV) system is well received as the key technology for local generation of clean power. Building system operation is a low-investment practice that aims low operation and maintenance cost. However, building HVAC and BIPV are systems subject to complicated intrinsic processes and highly variable environmental conditions and occupant behavior. Control, optimization and monitoring of such systems desire simple and effective approaches that require the least amount of model information and the use of smallest number but most robust sensor measurements. Self-optimizing control strategies promise a competitive platform for control, optimization and control integrated monitoring for building systems, and especially for the development of cost-effective NZEB. This dissertation study endorses this statement with three aspects of work relevant to building HVAC and BIPV, which could contribute several small steps towards the ramification of the self-optimizing control paradigm. This dissertation study applies self-optimizing control techniques to improve the energy efficiency of NZEB from two aspects. First, regarding the building HVAC efficiency, the dither based extremum seeking control (DESC) scheme is proposed for energy efficient operation of the chilled-water system typically used in the commercial building ventilation and air conditioning (VAC) systems. To evaluate the effectiveness of the proposed control strategy, Modelica based dynamic simulation model of chilled water chiller-tower plant is developed, which consists of a screw chiller and a mechanical-draft counter-flow wet cooling tower. The steady-state performance of the cooling tower model is validated with the experimental data in a classic paper and good agreement is observed. The DESC scheme takes the total power consumption of the chiller compressor and the tower fan as feedback, and uses the fan speed setting as the control input. The inner loop controllers for the chiller operation include two proportional-integral (PI) control loops for regulating the evaporator superheat and the chilled water temperature. Simulation was conducted on the whole dynamic simulation model with different environment conditions. The simulation results demonstrated the effectiveness of the proposed ESC strategy under abrupt changes of ambient conditions and load changes. The potential for energy savings of these cases are also evaluated. The back-calculation based anti-windup ESC is also simulated for handling the integral windup problem due to actuator saturation. Second, both maximum power point tracking (MPPT) and control integrated diagnostics are investigated for BIPV with two different extremum seeking control strategies, which both would contribute to the reduction of the cost of energy (COE). In particular, the Adaptive Extremum Seeking Control (AESC) is applied for PV MPPT, which is based on a PV model with known model structure but unknown nonlinear characteristics for the current-voltage relation. The nonlinear uncertainty is approximated by a radial basis function neural network (RBFNN). A Lyapunov based inverse optimal design technique is applied to achieve parameter estimation and gradient based extremum seeking. Simulation study is performed for scenarios of temperature change, irradiance change and combined change of temperature and irradiance. Successful results are observed for all cases. Furthermore, the AESC simulation is compared to the DESC simulation, and AESC demonstrates much faster transient responses under various scenarios of ambient changes. Many of the PV degradation mechanisms are reflected as the change of the internal resistance. A scheme of detecting the change of PV internal shunt resistance is proposed using the available signals in the DESC based MPPT with square-wave dither. The impact of the internal resistance on the transient characteristics of step responses is justified by using the small-signal transfer function analysis. Simulation study is performed for both the single-string and multi-string PV examples, and both cases have demonstrated successful results. Monotonic relationship between integral error indices and the shunt internal resistance is clearly observed. In particular, for the multi-string, the inter-channel coupling is weak, which indicates consistent monitoring for multi-string operation. The proposed scheme provides the online monitoring ability of the internal resistance condition without any additional sensor, which benefits further development of PV degradation detection techniques

CONTROL AND ESTIMATION ALGORITHMS FOR MULTIPLE-AGENT SYSTEMS

Tese arquivada ao abrigo da Portaria nº 227/2017 de 25 de julhoIn this thesis we study crucial problems within complex, large scale, networked control systems and mobile sensor networks. The ¯rst one is the problem of decomposition of a large-scale system into several interconnected subsystems, based on the imposed information structure constraints. After associating an intelligent agent with each subsystem, we face with a problem of formulating their local estimation and control laws and designing inter-agent communication strategies which ensure stability, desired performance, scalability and robustness of the overall system. Another problem addressed in this thesis, which is critical in mobile sensor networks paradigm, is the problem of searching positions for mobile nodes in order to achieve optimal overall sensing capabilities. Novel, overlapping decentralized state and parameter estimation schemes based on the consensus strategy have been proposed, in both continuous-time and discrete-time. The algorithms are proposed in the form of a multi-agent network based on a combination of local estimators and a dynamic consensus strategy, assuming possible intermittent observations and communication faults. Under general conditions concerning the agent resources and the network topology, conditions are derived for the stability and convergence of the algorithms. For the state estimation schemes, a strategy based on minimization of the steady-state mean-square estimation error is proposed for selection of the consensus gains; these gains can also be adjusted by local adaptation schemes. It is also demonstrated that there exists a connection between the network complexity and e±ciency of denoising, i.e., of suppression of the measurement noise in°uence. Several numerical examples serve to illustrate characteristic properties of the proposed algorithm and to demonstrate its applicability to real problems. Furthermore, several structures and algorithms for multi-agent control based on a dynamic consensus strategy have been proposed. Two novel classes of structured, overlapping decentralized control algorithms are presented. For the ¯rst class, an agreement between the agents is implemented at the level of control inputs, while the second class is based on the agreement at the state estimation level. The proposed control algorithms have been illustrated by several examples. Also, the second class of the proposed consensus based control scheme has been applied to decentralized overlapping tracking control of planar formations of UAVs. A comparison is given with the proposed novel design methodology based on the expansion/contraction paradigm and the inclusion principle. Motivated by the applications to the optimal mobile sensor positioning within mobile sensor networks, the perturbation-based extremum seeking algorithm has been modifed and extended. It has been assumed that the integrator gain and the perturbation amplitude are time varying (decreasing in time with a proper rate) and that the output is corrupted with measurement noise. The proposed basic, one dimensional, algorithm has been extended to two dimensional, hybrid schemes and directly applied to the planar optimal mobile sensor positioning, where the vehicles can be modeled as velocity actuated point masses, force actuated point masses, or nonholonomic unicycles. The convergence of all the proposed algorithms, with probability one and in the mean square sense, has been proved. Also, the problem of target assignment in multi-agent systems using multi-variable extremum seeking algorithm has been addressed. An algorithm which e®ectively solves the problem has been proposed, based on the local extremum seeking of the specially designed global utility functions which capture the dependance among di®erent, possibly con°icting objectives of the agents. It has been demonstrated how the utility function parameters and agents' initial conditions impact the trajectories and destinations of the agents. All the proposed extremum seeking based algorithms have been illustrated with several simulations

Advanced control and optimisation of DC-DC converters with application to low carbon technologies

Prompted by a desire to minimise losses between power sources and loads, the aim of this Thesis is to develop novel maximum power point tracking (MPPT) algorithms to allow for efficient power conversion within low carbon technologies. Such technologies include: thermoelectric generators (TEG), photovoltaic (PV) systems, fuel cells (FC) systems, wind turbines etc. MPPT can be efficiently achieved using extremum seeking control (ESC) also known as perturbation based extremum seeking control. The basic idea of an ESC is to search for an extrema in a closed loop fashion requiring only a minimum of a priori knowledge of the plant or system or a cost function. In recognition of problems that accompany ESC, such as limit cycles, convergence speed, and inability to search for global maximum in the presence local maxima this Thesis proposes novel schemes based on extensions of ESC. The first proposed scheme is a variance based switching extremum seeking control (VBS-ESC), which reduces the amplitude of the limit cycle oscillations. The second scheme proposed is a state dependent parameter extremum seeking control (SDP-ESC), which allows the exponential decay of the perturbation signal. Both the VBS-ESC and the SDP-ESC are universal adaptive control schemes that can be applied in the aforementioned systems. Both are suitable for local maxima search. The global maximum search scheme proposed in this Thesis is based on extensions of the SDP-ESC. Convergence to the global maximum is achieved by the use of a searching window mechanism which is capable of scanning all available maxima within operating range. The ability of the proposed scheme to converge to the global maximum is demonstrated through various examples. Through both simulation and experimental studies the benefit of the SDP-ESC has been consistently demonstrated

Extremum Seeking for Stefan PDE with Moving Boundary

This paper presents the design and analysis of the extremum seeking for static maps with input passed through a partial differential equation (PDE) of the diffusion type defined on a time-varying spatial domain whose boundary position is governed by an ordinary differential equation (ODE). This is the first effort to pursue an extension of extremum seeking from the heat PDE to the Stefan PDE. We compensate the average-based actuation dynamics by a controller via backstepping transformation for the moving boundary, which is utilized to transform the original coupled PDE-ODE into a target system whose exponential stability of the average equilibrium of the average system is proved. The discussion for the delay-compensated extremum seeking control of the Stefan problem is also presented and illustrated with numerical simulations.Comment: 10 pages and 10 figure

Extremum-Seeking Guidance and Conic-Sector-Based Control of Aerospace Systems

This dissertation studies guidance and control of aerospace systems. Guidance algorithms are used to determine desired trajectories of systems, and in particular, this dissertation examines constrained extremum-seeking guidance. This type of guidance is part of a class of algorithms that drives a system to the maximum or minimum of a performance function, where the exact relation between the function's input and output is unknown. This dissertation abstracts the problem of extremum-seeking to constrained matrix manifolds. Working with a constrained matrix manifold necessitates mathematics other than the familiar tools of linear systems. The performance function is optimized on the manifold by estimating a gradient using a Kalman filter, which can be modified to accommodate a wide variety of constraints and can filter measurement noise. A gradient-based optimization technique is then used to determine the extremum of the performance function. The developed algorithms are applied to aircraft and spacecraft. Control algorithms determine which system inputs are required to drive the systems outputs to follow the trajectory given by guidance. Aerospace systems are typically nonlinear, which makes control more challenging. One approach to control nonlinear systems is linear parameter varying (LPV) control, where well-established linear control techniques are extended to nonlinear systems. Although LPV control techniques work quite well, they require an LPV model of a system. This model is often an approximation of the real nonlinear system to be controlled, and any stability and performance guarantees that are derived using the system approximation are usually void on the real system. A solution to this problem can be found using the Passivity Theorem and the Conic Sector Theorem, two input-output stability theories, to synthesize LPV controllers. These controllers guarantee closed-loop stability even in the presence of system approximation. Several control techniques are derived and implemented in simulation and experimentation, where it is shown that these new controllers are robust to plant uncertainty.PHDAerospace EngineeringUniversity of Michigan, Horace H. Rackham School of Graduate Studieshttps://deepblue.lib.umich.edu/bitstream/2027.42/143993/1/aexwalsh_1.pd