Design and theoretical analysis of advanced power based positioning in RF system

Accurate locating and tracking of people and resources has become a fundamental requirement for many applications. The global navigation satellite systems (GNSS) is widely used. But its accuracy suffers from signal obstruction by buildings, multipath fading, and disruption due to jamming and spoof. Hence, it is required to supplement GPS with inertial sensors and indoor localization schemes that make use of WiFi APs or beacon nodes. In the GPS-challenging or fault scenario, radio-frequency (RF) infrastructure based localization schemes can be a fallback solution for robust navigation. For the indoor/outdoor transition scenario, we propose hypothesis test based fusion method to integrate multi-modal localization sensors. In the first paper, a ubiquitous tracking using motion and location sensor (UTMLS) is proposed. As a fallback approach, power-based schemes are cost-effective when compared with the existing ToA or AoA schemes. However, traditional power-based positioning methods suffer from low accuracy and are vulnerable to environmental fading. Also, the expected accuracy of power-based localization is not well understood but is needed to derive the hypothesis test for the fusion scheme. Hence, in paper 2-5, we focus on developing more accurate power-based localization schemes. The second paper improves the power-based range estimation accuracy by estimating the LoS component. The ranging error model in fading channel is derived. The third paper introduces the LoS-based positioning method with corresponding theoretical limits and error models. In the fourth and fifth paper, a novel antenna radiation-pattern-aware power-based positioning (ARPAP) system and power contour circle fitting (PCCF) algorithm are proposed to address antenna directivity effect on power-based localization. Overall, a complete LoS signal power based positioning system has been developed that can be included in the fusion scheme --Abstract, page iv

Location-dependent information extraction for positioning

This paper presents an overview of current research investigations within the WHERE-2 Project with respect to location-dependent information extraction and how this information can be used towards the benefit of positioning. It is split into two main sections; the first one relies on non-radio means such as inertial sensors and prior knowledge about the environment geometry, which can be used in the form of map constraints to improve user positioning precision in indoor environments. The second section presents how location-specific radio information can be exploited in a more sophisticated way into advanced positioning algorithms. The intended solutions include exploitation of the slow fading dynamics in addition to the fast-fading parameters, adaptation of the system to its environment on both network and terminal sides and also how specific environmental properties such as the dielectric wall parameters can be extracted and thereafter used for more accurate fingerprinting database generation using Ray Tracing modelling methods. Most of the techniques presented herein rely on real-life measurements or experiments

CARAMEL: results on a secure architecture for connected and autonomous vehicles detecting GPS spoofing attacks

The main goal of the H2020-CARAMEL project is to address the cybersecurity gaps introduced by the new technological domains adopted by modern vehicles applying, among others, advanced Artificial Intelligence and Machine Learning techniques. As a result, CARAMEL enhances the protection against threats related to automated driving, smart charging of Electric Vehicles, and communication among vehicles or between vehicles and the roadside infrastructure. This work focuses on the latter and presents the CARAMEL architecture aiming at assessing the integrity of the information transmitted by vehicles, as well as at improving the security and privacy of communication for connected and autonomous driving. The proposed architecture includes: (1) multi-radio access technology capabilities, with simultaneous 802.11p and LTE-Uu support, enabled by the connectivity infrastructure; (2) a MEC platform, where, among others, algorithms for detecting attacks are implemented; (3) an intelligent On-Board Unit with anti-hacking features inside the vehicle; (4) a Public Key Infrastructure that validates in real-time the integrity of vehicle’s data transmissions. As an indicative application, the interaction between the entities of the CARAMEL architecture is showcased in case of a GPS spoofing attack scenario. Adopted attack detection techniques exploit robust in-vehicle and cooperative approaches that do not rely on encrypted GPS signals, but only on measurements available in the CARAMEL architecture.This work was supported by the European Union’s H2020 research and innovation programme under the CARAMEL project (Grant agreement No. 833611). The work of Christian Vitale, Christos Laoudias and Georgios Ellinas was also supported by the European Union’s Horizon 2020 Research and Innovation Programme under Grant 739551 (KIOS CoE) and from the Republic of Cyprus through the Directorate General for European Programmes, Coordination, and Development. The work of Jordi Casademont and Pouria Sayyad Khodashenas was also supported by FEDER and Secretaria d’Universitats i Recerca del Departament d’Empresa i Coneixement de la Generalitat de Catalunya through projects Fem IoT and SGR 2017-00376 and by the ERDFPeer ReviewedPostprint (author's final draft

GNSS/5G Hybridization for urban navigation

Over the past few years, the need for positioning, and thus the number of positioning services in general, has been in constant growth. This need for positioning has been increasingly focused on constrained environments, such as urban or indoor environments, where GNSS is known to have significant limitations: multipath as well as the lack of Line-of-Sight satellite visibility degrades the GNSS positioning solution and makes it unsuitable for some urban or indoor applications. In order to improve the GNSS positioning performance in constrained environments, many solutions are already available: hybridization with additional sensors or the use of signals of opportunity for example. Concerning SoO, mobile communication signals, such as the 4G Long Term Evolution or 5G, are naturally envisioned for positioning. Indeed, a significant number of users are expected to be “connected-users” and 5G systems offers promising opportunities. 5G technology is being standardized at 3GPP; the first complete release of 5G specifications, Release-15, was provided to the community in June 2018. 5G is an emerging technology and its positioning performance, as well as a potential generic receiver scheme to conduct positioning operations, is still under analysis. In order to study the potential capabilities provided by 5G systems and to develop a 5Gbased generic positioning module scheme, the first fundamental step is to develop mathematical models of the processed 5G signals at each stage of the receiver for realistic propagation channel models: the mathematical expression of the useful received 5G signal as well as the AWG (Additive White Gaussian) noise statistics. In the Ph.D., the focus is given to the correlation operation which is the basic function implemented by typical ranging modules for 4G LTE signals, DVB signals, and GNSS. In fact, the knowledge of the correlation output mathematical model could allow for the development of optimal 5G signal processing techniques for ranging positioning. Previous efforts were made to provide mathematical models of received signals at the different receiver signal processing stages for signals with similar structures to 5G signals – Orthogonal ²Frequency Division Multiplexing (OFDM) signals as defined in 3GPP standard. OFDM signal-type correlator output mathematical model and acquisition techniques were derived. Moreover, tracking techniques were proposed, analyzed and tested based on the correlator output mathematical model. However, these models were derived by assuming a constant propagation channel over the duration of the correlation. Unfortunately, when the Channel Impulse Response (CIR) provided by a realistic propagation channel is not considered to be constant over the duration of the correlation, the correlator output mathematical models are slightly different from the mathematical models proposed in the literature

A Framework for UWB-Based Communication and Location Tracking Systems for Wireless Sensor Networks

Ultra wideband (UWB) radio technology is nowadays one of the most promising technologies for medium-short range communications. It has a wide range of applications including Wireless Sensor Networks (WSN) with simultaneous data transmission and location tracking. The combination of location and data transmission is important in order to increase flexibility and reduce the cost and complexity of the system deployment. In this scenario, accuracy is not the only evaluation criteria, but also the amount of resources associated to the location service, as it has an impact not only on the location capacity of the system but also on the sensor data transmission capacity. Although several studies can be found in the literature addressing UWB-based localization, these studies mainly focus on distance estimation and position calculation algorithms. Practical aspects such as the design of the functional architecture, the procedure for the transmission of the associated information between the different elements of the system, and the need of tracking multiple terminals simultaneously in various application scenarios, are generally omitted. This paper provides a complete system level evaluation of a UWB-based communication and location system for Wireless Sensor Networks, including aspects such as UWB-based ranging, tracking algorithms, latency, target mobility and MAC layer design. With this purpose, a custom simulator has been developed, and results with real UWB equipment are presented too

Distributed localisation algorithm for wireless ad hoc networks of moving nodes

Existing ad hoc network localisation solutions rely either on external location references or network-wide exchange of information and centralised processing and computation of location estimates. Without these, nodes are not able to estimate the relative locations of other nodes within their communication range. This thesis defines a new distributed localisation algorithm for ad hoc networks of moving nodes. The Relative Neighbour Localisation (RNL) algorithm works without any external localisation signal or systems and does not assume centralised information processing. The idea behind the location estimates produced by the RNL algorithm is the relationship between the relative locations of two nodes, their mobility parameters and the signal strengths measured between them. The proposed algorithm makes use of the data available to each node to produce a location estimate. The signal strength each node is capable of measuring is used as one algorithm input. The other input is the velocity vector of the neighbouring node, composed of its speed and direction of movement, which each node is assumed to periodically broadcast. The relationship between the signal strength and the mobility parameters on one, and the relative location on the other side can be analytically formulated in an ideal case. The limitations of a realistic scenario complicate this relationship, making it very difficult to formulate analytically. An empirical approach is thus used. The angle and the distance estimates are individually computed, together forming a two-dimensional location estimate. The performance of the algorithm was analysed in detail using simulation, showing a median estimate error of under 10m, and its application was tested through design and evaluation of a distributed sensing coverage algorithm, showing RNL location estimates can provide 90% of the coverage achievable with true locations being known

Application of rasch model on resilience in higher education: an examination of validity and reliability of Malaysian academician happiness index (MAHI)

This preliminary study was conducted to examine and verify the validity and reliability of the instrument on the Malaysian Academician Happiness Index (MAHI) on resilience. MAHI could be seen as a tool to measure the level of happiness and stress of academicians before determining how resilient the academicians were. Resilience can be defined as a mental ability of a person to recover quickly from illness or depression. MAHI instrument consisted of 66 items. The instrument was distributed to 40 academicians from three groups of universities which were the Focus University, Comprehensive University and Research University is using a survey technique. The instrument was developed to measure three main constructs which were the organization, individual and social that would affect the happiness and stress levels of academicians. This preliminary study employed the Rasch Measurement Model uses Winsteps software version 3.69.1.11. to examine the validity and reliability of the items. The results of the analysis of the MAHI instrument showed that the item reliability was 0.87, person reliability was 0.83 and value of Alpha Cronbach was 0.84. Meanwhile, misfit analysis showed that only there was one item with 1.46 logit that could be considered for dropping or needed improvement. Therefore, it highlighted that most of the items met the constructs’ need and can be used as a measurement indicator of MAHI. The implication of this instrument can help Malaysian academicians to be more resilient in facing challenges in the future

Contextual Beamforming: Exploiting Location and AI for Enhanced Wireless Telecommunication Performance

The pervasive nature of wireless telecommunication has made it the foundation for mainstream technologies like automation, smart vehicles, virtual reality, and unmanned aerial vehicles. As these technologies experience widespread adoption in our daily lives, ensuring the reliable performance of cellular networks in mobile scenarios has become a paramount challenge. Beamforming, an integral component of modern mobile networks, enables spatial selectivity and improves network quality. However, many beamforming techniques are iterative, introducing unwanted latency to the system. In recent times, there has been a growing interest in leveraging mobile users' location information to expedite beamforming processes. This paper explores the concept of contextual beamforming, discussing its advantages, disadvantages and implications. Notably, the study presents an impressive 53% improvement in signal-to-noise ratio (SNR) by implementing the adaptive beamforming (MRT) algorithm compared to scenarios without beamforming. It further elucidates how MRT contributes to contextual beamforming. The importance of localization in implementing contextual beamforming is also examined. Additionally, the paper delves into the use of artificial intelligence schemes, including machine learning and deep learning, in implementing contextual beamforming techniques that leverage user location information. Based on the comprehensive review, the results suggest that the combination of MRT and Zero forcing (ZF) techniques, alongside deep neural networks (DNN) employing Bayesian Optimization (BO), represents the most promising approach for contextual beamforming. Furthermore, the study discusses the future potential of programmable switches, such as Tofino, in enabling location-aware beamforming