Distributed joint flow-radio and channel assignment using partially overlapping channels in multi-radio wireless mesh networks

Equipping mesh nodes with multiple radios that support multiple wireless channels is considered a promising solution to overcome the capacity limitation of single-radio wireless mesh networks. However, careful and intelligent radio resource management is needed to take full advantage of the extra radios on the mesh nodes. Flow-radio assignment and channel assignment procedures should obey the physical constraints imposed by the radios as well as the topological constraints imposed by routing. Varying numbers of wireless channels are available for the channel assignment procedure for different wireless communication standards. To further complicate the problem, the wireless communication standard implemented by the radios of the wireless mesh network may define overlapping as well as orthogonal channels, as in the case of the IEEE 802.11b/g family of standards. This paper presents Distributed Flow-Radio Channel Assignment, a distributed joint flow-radio and channel assignment scheme and the accompanying distributed protocol in the context of multi-channel multi-radio wireless mesh networks. The scheme’s performance is evaluated on small networks for which the optimal flow-radio and channel configuration can be computed, as well as on large random topologies. © 2015, Springer Science+Business Media New York

Channel assignment and routing for multi-radio wireless mesh networks

Ankara : The Department of Computer Engineering and the Institute of Engineering and Science of Bilkent University, 2008.Thesis (Master's) -- Bilkent University, 2008.Includes bibliographical references leaves 52-56.Wireless Mesh Network is a promising technology since it extends the range of wireless coverage by multi-hop transmission between routers. However, in multihop networks the total throughput decreases with increasing number of nodes and hops. To increase the total throughput, some mesh routers are equipped with multiple radios to use the available bandwidth of multiple non-overlapping channels. However, channel assignment should be done carefully to effectively use this available bandwidth. Moreover, the optimal channel assignment algorithm is NP-hard. In this thesis, we propose a joint channel assignment and routing solution to effectively use the available bandwidth for multi-radio wireless mesh networks with given network topology and traffic profile. Initially, we predict the final routes of the flows and estimate the loads on the links using these path predictions and given traffic profile. Then three different heuristics determine the assignment order of the links. Then the least busy channel among the available channels is assigned to the link. Finally, our routing algorithm routes the flows such that the selected path is the least busy path among the alternatives. We evaluated our channel assignment and routing algorithm using ns-2 simulator which supports multiple channels and multiple radios per node and we compared our results with single channel WMNs, and different algorithms for multi-radio multi-channel WMNs. The results show that our joint algorithm successfully achieves up to 5 times more throughput than single channel WMN with using just 2 radios and 3 channels. Our algorithms also out-performs other compared channel assignment algorithms for multi-radio multi-channel WMNs.Özdemiray, Ahmet MuratM.S

Distributed joint flow-radio and channel assignment using partially overlapping channels in multi-radio wireless mesh networks

Equipping mesh nodes with multiple radios that support multiple wireless channels is considered a promising solution to overcome the capacity limitation of single-radio wireless mesh networks. However, careful and intelligent radio resource management is needed to take full advantage of the extra radios on the mesh nodes. Flow-radio assignment and channel assignment procedures should obey the physical constraints imposed by the radios as well as the topological constraints imposed by routing. Varying numbers of wireless channels are available for the channel assignment procedure for different wireless communication standards. To further complicate the problem, the wireless communication standard implemented by the radios of the wireless mesh network may define overlapping as well as orthogonal channels, as in the case of the IEEE 802.11b/g family of standards. This paper presents Distributed Flow-Radio Channel Assignment, a distributed joint flow-radio and channel assignment scheme and the accompanying distributed protocol in the context of multi-channel multi-radio wireless mesh networks. The scheme’s performance is evaluated on small networks for which the optimal flow-radio and channel configuration can be computed, as well as on large random topologies. © 2015, Springer Science+Business Media New York

Interface placement in constructing widest spanning tree for multi-channel multi-interface wireless mesh networks

Proceedings of the IEEE Wireless Communications and Networking Conference, 2009, p. 2560-2564Widest spanning tree is a broadcast tree with its bottleneck link bandwidth maximized. It provides a cost effective broadcasting solution in multi-channel multi-interface wireless mesh networks. To find the widest spanning tree, existing algorithms jointly consider channel assignment, routing and scheduling while assuming the number of network interface cards (NICs) at each node is given. In this paper, we treat the number of NICs at each node as a design parameter, whereas the total number of NICs in the system is given. By properly placing more NICs to more "critical" nodes, the bandwidth of the spanning tree can be further increased. To this end, a new Integer Linear Programming (ILP) is formulated for solving the widest spanning tree problem based on joint optimization of interface placement, channel assignment, routing and scheduling. Numerical results show that interface placement provides a significant boost to the bandwidth of the widest spanning tree found. © 2009 IEEE.published_or_final_versio

Interface placement in constructing widest spanning tree for multi-channel multi-interface wireless mesh networks

Proceedings of the IEEE Wireless Communications and Networking Conference, 2009, p. 2560-2564Widest spanning tree is a broadcast tree with its bottleneck link bandwidth maximized. It provides a cost effective broadcasting solution in multi-channel multi-interface wireless mesh networks. To find the widest spanning tree, existing algorithms jointly consider channel assignment, routing and scheduling while assuming the number of network interface cards (NICs) at each node is given. In this paper, we treat the number of NICs at each node as a design parameter, whereas the total number of NICs in the system is given. By properly placing more NICs to more "critical" nodes, the bandwidth of the spanning tree can be further increased. To this end, a new Integer Linear Programming (ILP) is formulated for solving the widest spanning tree problem based on joint optimization of interface placement, channel assignment, routing and scheduling. Numerical results show that interface placement provides a significant boost to the bandwidth of the widest spanning tree found. © 2009 IEEE.published_or_final_versio

Joint multicast routing and channel assignment in multiradio multichannel wireless mesh networks using simulated annealing

This is the post-print version of the article - Copyright @ 2008 Springer-VerlagThis paper proposes a simulated annealing (SA) algorithm based optimization approach to search a minimum-interference multicast tree which satisfies the end-to-end delay constraint and optimizes the usage of the scarce radio network resource in wireless mesh networks. In the proposed SA multicast algorithm, the path-oriented encoding method is adopted and each candidate solution is represented by a tree data structure (i.e., a set of paths). Since we anticipate the multicast trees on which the minimum-interference channel assignment can be produced, a fitness function that returns the total channel conflict is devised. The techniques for controlling the annealing process are well developed. A simple yet effective channel assignment algorithm is proposed to reduce the channel conflict. Simulation results show that the proposed SA based multicast algorithm can produce the multicast trees which have better performance in terms of both the total channel conflict and the tree cost than that of a well known multicast algorithm in wireless mesh networks.This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) of UK under Grant EP/E060722/1

Joint QoS multicast routing and channel assignment in multiradio multichannel wireless mesh networks using intelligent computational methods

Copyright @ 2010 Elsevier B.V. All rights reserved.In this paper, the quality of service multicast routing and channel assignment (QoS-MRCA) problem is investigated. It is proved to be a NP-hard problem. Previous work separates the multicast tree construction from the channel assignment. Therefore they bear severe drawback, that is, channel assignment cannot work well with the determined multicast tree. In this paper, we integrate them together and solve it by intelligent computational methods. First, we develop a unified framework which consists of the problem formulation, the solution representation, the fitness function, and the channel assignment algorithm. Then, we propose three separate algorithms based on three representative intelligent computational methods (i.e., genetic algorithm, simulated annealing, and tabu search). These three algorithms aim to search minimum-interference multicast trees which also satisfy the end-to-end delay constraint and optimize the usage of the scarce radio network resource in wireless mesh networks. To achieve this goal, the optimization techniques based on state of the art genetic algorithm and the techniques to control the annealing process and the tabu search procedure are well developed separately. Simulation results show that the proposed three intelligent computational methods based multicast algorithms all achieve better performance in terms of both the total channel conflict and the tree cost than those comparative references.This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) of UK under Grant EP/E060722/1

Joint multicast routing and channel assignment in multiradio multichannel wireless mesh networks using tabu search

Copyright @ 2009 IEEE Computer SocietyThis paper proposes a tabu search (TS) based optimization approach to search a minimum-interference multicast tree which satisfies the end-to-end delay constraint and optimizes the usage of the scarce radio network resource in wireless mesh networks. The path-oriented encoding method is adopted and each candidate solution is represented by a tree data structure (i.e., a set of paths). Since we expect the multicast trees on which the minimum-interference channel assignment can be produced, a fitness function that returns the total channel conflict is devised. The techniques for controlling the tabu search procedure are well developed. A simple yet effective channel assignment algorithm is proposed to reduce the channel conflict. Simulation results show that the proposed TS multicast algorithm can produce the multicast trees which have better performance in terms of both the total channel conflict and the tree cost than that of a well known multicast algorithm in wireless mesh networks.This work was supported by the Engineering and Physical Sciences Research Council (EPSRC) of UK under Grant EP/E060722/1

A genetic-inspired joint multicast routing and channel assignment algorithm in wireless mesh networks

Copyright @ 2008 IEEEThis paper proposes a genetic algorithm (GA) based optimization approach to search a minimum-interference multicast tree which satis¯es the end-to-end delay constraint and optimizes the usage of the scarce radio network resource in wireless mesh networks. The path-oriented en- coding method is used and each chromosome is represented by a tree data structure (i.e., a set of paths). Since we expect the multicast trees on which the minimum-interference channel assignment can be produced, a fitness function that returns the total channel conflict is devised. Crossover and mutation are well designed to adapt to the tree structure. A simple yet effective channel assignment algorithm is proposed to reduce the channel conflict. Simulation results show that the proposed GA based multicast algorithm achieves better performance in terms of both the total channel conflict and the tree cost than that of a well known algorithm