A survey of performance enhancement of transmission control protocol (TCP) in wireless ad hoc networks

This Article is provided by the Brunel Open Access Publishing Fund - Copyright @ 2011 Springer OpenTransmission control protocol (TCP), which provides reliable end-to-end data delivery, performs well in traditional wired network environments, while in wireless ad hoc networks, it does not perform well. Compared to wired networks, wireless ad hoc networks have some specific characteristics such as node mobility and a shared medium. Owing to these specific characteristics of wireless ad hoc networks, TCP faces particular problems with, for example, route failure, channel contention and high bit error rates. These factors are responsible for the performance degradation of TCP in wireless ad hoc networks. The research community has produced a wide range of proposals to improve the performance of TCP in wireless ad hoc networks. This article presents a survey of these proposals (approaches). A classification of TCP improvement proposals for wireless ad hoc networks is presented, which makes it easy to compare the proposals falling under the same category. Tables which summarize the approaches for quick overview are provided. Possible directions for further improvements in this area are suggested in the conclusions. The aim of the article is to enable the reader to quickly acquire an overview of the state of TCP in wireless ad hoc networks.This study is partly funded by Kohat University of Science & Technology (KUST), Pakistan, and the Higher Education Commission, Pakistan

Minimizing Spatial and Time Reservation With Collision-Aware DCF in Mobile Ad Hoc Networks

Carrier sensing is widely adopted in wireless communication to protect data transfers from collisions. For example, distributed coordination function (DCF) in IEEE 802.11 standard renders a node to defer its communication if it senses the medium busy. For the duration of deferment, each frame carries, in its MAC header, a 16-bit number in microseconds during which any overhearing node must defer. However, even if the carrier signal is detected, both ongoing and a new communication can be simultaneously successful depending on their relative positions in the network or equivalently, their mutual interference level. Supporting multiple concurrent communications is important in multihop ad hoc networks in order to maximize the network performance. However, it is largely ignored in DCF of the 802.11 standards because it is primarily targeted at single-hop wireless LANs. In addition, in DCF, the time duration information mentioned above is not delivered to all potential interferers, particularly those in the distance. This paper proposes Collision-Aware DCF (CAD) that efficiently utilizes the available channel resource along with the spatial as well as time dimension. First, each node makes its deferment decision adaptively based on the feedback from the communication counterpart and the status of the medium rather than on a simple, fixed carrier sense threshold as DCF. Second, CAD embeds the spatial and time reservation requirements in the PHY header, which is transmitted at the lowest data rate, so that a larger group of neighbors become aware of the ongoing communication and thus avoid collisions. Extensive experiments based on ns-2 network simulator show that CAD consistently outperforms DCF regardless of node mobility, traffic intensity, and channel randomness. For practicality, this paper discusses the implementation of CAD based on the DCF specification

A New Method of User Association in Wireless Mesh Networks

The IEEE 802.11 based wireless mesh networks (WMNs) are becoming the promising technology to provide last-mile broadband Internet access to the users. In order to access the Internet through the pre-deployed WMN, the user has to associate with one of the access points (APs) present in the network. In WMN, it is very common that the user device can have multiple APs in its vicinity. Since the user performance majorly depends on the associated AP, how to select the best AP is always remaining as a challenging research problem in WMN. The traditional method of AP selection is based on received signal strength (RSS) and it is proven inefficient in the literature as the method does not consider AP load, channel conditions, etc. This paper proposes a new method of user association in WMN such that the user selects the AP based on achievable end-to-end throughput measured in the presence of other interfering APs. The proposed association metric is independent of routing protocol and routing metric used in WMN. The simulation results show that our method outperforms the RSS based AP selection method in WMN

RandomCast: An Energy-Efficient Communication Scheme for Mobile Ad Hoc Networks

In mobile ad hoc networks (MANETs), every node overhears every data transmission occurring in its vicinity and thus, consumes energy unnecessarily. However, since some MANET routing protocols such as dynamic source routing (DSR) collect route information via overhearing, they would suffer if they are used in combination with 802.11 PSM. Allowing no overhearing may critically deteriorate the performance of the underlying routing protocol, while unconditional overhearing may offset the advantage of using PSM. This paper proposes a new communication mechanism, called RandomCast, via which a sender can specify the desired level of overhearing, making a prudent balance between energy and routing performance. In addition, it reduces redundant rebroadcasts for a broadcast packet, and thus, saves more energy. Extensive simulation using NS-2 shows that RandomCast is highly energy-efficient compared to conventional 802.11 as well as 802.11 PSM-based schemes, in terms of total energy consumption, energy goodput, and energy balance

A Cross Layer Solution to Address TCP Intra-flow Performance Degradation in Multihop Ad hoc Networks

Incorporating the concept of TCP end-to-end congestion control for wireless networks is one of the primary concerns in designing ad hoc networks since TCP was primarily designed and optimized based on the assumptions for wired networks. In this study, our interest lies on tackling the TCP instability and in particular intra-flow instability problem since due to the nature of applications in multihop ad hoc networks, connection instability or starvation even for a short period of time can have a negative impact on the Quality of Service and may not be acceptable for the end user. Through a detailed analysis, it will be shown that the main causes of TCP intra-flow instability lies in overloading the network by sending more packets than the capacity of the channel. Based on this, the paper proposes a novel cross layer solution called “TCP Contention Control” that dynamically adjusts the amount of outstanding data in the network based on the level of contention experienced by packets as well as the throughput achieved by connections. The simulation results show TCP Contention Control can drastically improve TCP stability over 802.11 multihop ad hoc networks

Cross Layer Aware Adaptive MAC based on Knowledge Based Reasoning for Cognitive Radio Computer Networks

In this paper we are proposing a new concept in MAC layer protocol design for Cognitive radio by combining information held by physical layer and MAC layer with analytical engine based on knowledge based reasoning approach. In the proposed system a cross layer information regarding signal to interference and noise ratio (SINR) and received power are analyzed with help of knowledge based reasoning system to determine minimum power to transmit and size of contention window, to minimize backoff, collision, save power and drop packets. The performance analysis of the proposed protocol indicates improvement in power saving, lowering backoff and significant decrease in number of drop packets. The simulation environment was implement using OMNET++ discrete simulation tool with Mobilty framework and MiXiM simulation library.Comment: 8 page

A survey on wireless ad hoc networks

A wireless ad hoc network is a collection of wireless nodes that can dynamically self-organize into an arbitrary and temporary topology to form a network without necessarily using any pre-existing infrastructure. These characteristics make ad hoc networks well suited for military activities, emergency operations, and disaster recoveries. Nevertheless, as electronic devices are getting smaller, cheaper, and more powerful, the mobile market is rapidly growing and, as a consequence, the need of seamlessly internetworking people and devices becomes mandatory. New wireless technologies enable easy deployment of commercial applications for ad hoc networks. The design of an ad hoc network has to take into account several interesting and difficult problems due to noisy, limited-range, and insecure wireless transmissions added to mobility and energy constraints. This paper presents an overview of issues related to medium access control (MAC), routing, and transport in wireless ad hoc networks and techniques proposed to improve the performance of protocols. Research activities and problems requiring further work are also presented. Finally, the paper presents a project concerning an ad hoc network to easily deploy Internet services on low-income habitations fostering digital inclusion8th IFIP/IEEE International conference on Mobile and Wireless CommunicationRed de Universidades con Carreras en Informática (RedUNCI