Adaptive OFDM System Design For Cognitive Radio

Recently, Cognitive Radio has been proposed as a promising technology to improve spectrum utilization. A highly flexible OFDM system is considered to be a good candidate for the Cognitive Radio baseband processing where individual carriers can be switched off for frequencies occupied by a licensed user. In order to support such an adaptive OFDM system, we propose a Multiprocessor System-on-Chip (MPSoC) architecture which can be dynamically reconfigured. However, the complexity and flexibility of the baseband processing makes the MPSoC design a difficult task. This paper presents a design technology for mapping flexible OFDM baseband for Cognitive Radio on a multiprocessor System-on-Chip (MPSoC)

Single-Carrier Modulation versus OFDM for Millimeter-Wave Wireless MIMO

This paper presents results on the achievable spectral efficiency and on the energy efficiency for a wireless multiple-input-multiple-output (MIMO) link operating at millimeter wave frequencies (mmWave) in a typical 5G scenario. Two different single-carrier modem schemes are considered, i.e., a traditional modulation scheme with linear equalization at the receiver, and a single-carrier modulation with cyclic prefix, frequency-domain equalization and FFT-based processing at the receiver; these two schemes are compared with a conventional MIMO-OFDM transceiver structure. Our analysis jointly takes into account the peculiar characteristics of MIMO channels at mmWave frequencies, the use of hybrid (analog-digital) pre-coding and post-coding beamformers, the finite cardinality of the modulation structure, and the non-linear behavior of the transmitter power amplifiers. Our results show that the best performance is achieved by single-carrier modulation with time-domain equalization, which exhibits the smallest loss due to the non-linear distortion, and whose performance can be further improved by using advanced equalization schemes. Results also confirm that performance gets severely degraded when the link length exceeds 90-100 meters and the transmit power falls below 0 dBW.Comment: accepted for publication on IEEE Transactions on Communication

OFDM over IEEE 802.11b hardware for telemedical applications

Using a wireless Local Area Network (WLAN) to transmit live high-quality video suitable for a telemedical application presents many challenges, including ensuring sufficient Quality of Service (QoS) for the end-user to be able to make an accurate diagnosis. One of the many problems that exist when developing such a system is the multipath effect caused by the reflections of the transmitted signals on various surfaces including walls, floors, furniture and people. This degrades the signal quality and reduces the amount of available bandwidth and, thus, the quality of the image. Presently, most of Europe is using the IEEE 802.11b hardware for such applications. As an alternative to the existing modulation of 802.11b, Orthogonal Frequency Division Multiplexing (OFDM) is investigated, especially for use inside hospitals. The advantages of using this modulation over IEEE 802.11b hardware for a telemedicine application are examined by means of simulation using three different simulation packages

Resource Allocation for Power Minimization in the Downlink of THP-based Spatial Multiplexing MIMO-OFDMA Systems

In this work, we deal with resource allocation in the downlink of spatial multiplexing MIMO-OFDMA systems. In particular, we concentrate on the problem of jointly optimizing the transmit and receive processing matrices, the channel assignment and the power allocation with the objective of minimizing the total power consumption while satisfying different quality-of-service requirements. A layered architecture is used in which users are first partitioned in different groups on the basis of their channel quality and then channel assignment and transceiver design are sequentially addressed starting from the group of users with most adverse channel conditions. The multi-user interference among users belonging to different groups is removed at the base station using a Tomlinson-Harashima pre-coder operating at user level. Numerical results are used to highlight the effectiveness of the proposed solution and to make comparisons with existing alternatives.Comment: 12 pages, 6 figures, IEEE Trans. Veh. Techno

Spectral Efficiency of MIMO Millimeter-Wave Links with Single-Carrier Modulation for 5G Networks

Future wireless networks will extensively rely upon bandwidths centered on carrier frequencies larger than 10GHz. Indeed, recent research has shown that, despite the large path-loss, millimeter wave (mmWave) frequencies can be successfully exploited to transmit very large data-rates over short distances to slowly moving users. Due to hardware complexity and cost constraints, single-carrier modulation schemes, as opposed to the popular multi-carrier schemes, are being considered for use at mmWave frequencies. This paper presents preliminary studies on the achievable spectral efficiency on a wireless MIMO link operating at mmWave in a typical 5G scenario. Two different single-carrier modem schemes are considered, i.e. a traditional modulation scheme with linear equalization at the receiver, and a single-carrier modulation with cyclic prefix, frequency-domain equalization and FFT-based processing at the receiver. Our results show that the former achieves a larger spectral efficiency than the latter. Results also confirm that the spectral efficiency increases with the dimension of the antenna array, as well as that performance gets severely degraded when the link length exceeds 100 meters and the transmit power falls below 0dBW. Nonetheless, mmWave appear to be very suited for providing very large data-rates over short distances.Comment: 8 pages, 8 figures, to appear in Proc. 20th International ITG Workshop on Smart Antennas (WSA2016