Route recovery schemes for link and node failure and link congestion

Link/Node failure occurs frequently causing service disruption in computer networks. Hardware techniques have been developed to protect the network from Link/Node failure. These techniques work in physical layer, therefore their convergence time is very small. On the other hand, many schemes have been proposed to mitigate the failure influence on the network. These schemes work in upper layers such as the network layer. However, hardware solutions faster than other schemes, but they are expensive. Link/Node failure causes all flows which were using the failed link/node are temporarily interrupted till a new path reestablished. Three recovery algorithms have been proposed that mitigate the changes occur in the network. These changes are link/node failure and link congestion. The algorithms mainly pre-compute a backup next hop for each destination in the network. This path is feasible to accommodate re-routed traffic when a failure occurs without causing congestion or loops. Simulations have been conducted to show the performance of the proposed algorithms using ns2 network simulation tool. The results show fast recovery for all flows were using the link/node failure. Furthermore, the throughput per node also increases due to decrease interruption service time

Efficient Algorithms to Enhance Recovery Schema in Link State Protocols

With the increasing demands for real-time applications traffic in net- works such as video and voice a high convergence time for the existing routing protocols when failure occurred is required. These applications can be very sensitive to packet loss when link/node goes down. In this paper, we propose two algorithms schemas for the link state protocol to reroute the traffic in two states; first, pre-calculated an alternative and disjoint path with the primary one from the source to the destination by re-routing traffic through it, regardless of the locations of failure and the number of failed links. Second, rerouting the traffic via an alternative path from a node whose local link is down without the need to wait until the source node knows about the failure. This is achieved by creating a new backup routing table based on the original routing table which is computed by the dijkstra algorithm. The goal of these algorithms is to reduce loss of packets, end-to-end delay time, improve throughput and avoiding local loop when nodes re-converge the topology in case of failure.Comment: 15 page

Technology-related disasters:a survey towards disaster-resilient software defined networks

Resilience against disaster scenarios is essential to network operators, not only because of the potential economic impact of a disaster but also because communication networks form the basis of crisis management. COST RECODIS aims at studying measures, rules, techniques and prediction mechanisms for different disaster scenarios. This paper gives an overview of different solutions in the context of technology-related disasters. After a general overview, the paper focuses on resilient Software Defined Networks

Modeling and Algorithm for Multiple Spanning Tree Provisioning in Resilient and Load Balanced Ethernet Networks

We propose a multitree based fast failover scheme for Ethernet networks. In our system, only few spanning trees are used to carry working traffic in the normal state. As a failure happens, the nodes adjacent to the failure redirect traffic to the preplanned backup VLAN trees to realize fast failure recovery. In the proposed scheme, a new leaf constraint is enforced on the backup trees. It enables the network being able to provide 100% survivability against any single link and any single node failure. Besides fast failover, we also take load balancing into consideration. We model an Ethernet network as a twolayered graph and propose an Integer Linear Programming (ILP) formulation for the problem. We further propose a heuristic algorithm to provide solutions to large networks. The simulation results show that the proposed scheme can achieve high survivability while maintaining load balancing at the same time. In addition, we have implemented the proposed scheme in an FPGA system. The experimental results show that it takes only few μsec to recover a network failure. This is far beyond the 50 msec requirement used in telecommunication networks for network protection

MPLS based recovery mechanisms

Multi-protocol label switching (MPLS) integrates the label swapping forwarding paradigm with network layer routing. To deliver reliable service, MPLS requires a set of procedures to provide protection of the traffic carried on different paths. This requires that the label switching routers (LSRs) support fault detection, fault notification, and fault recovery mechanisms, and that MPLS signaling supports the configuration of recovery. The purpose of this work is to evaluate the different recovery mechanisms proposed by the IETF, by literature study and simulation experiments