237 research outputs found
Hybrid precoding for physical layer multicasting
This work investigates the problem of downlink transmit precoding for
physical layer multicasting with a limited number of radio-frequency (RF)
chains. To tackle the RF hardware constraint, we consider a hybrid precoder
that is partitioned into a high-dimensional RF precoder and a low-dimensional
baseband precoder. Considering a total transmit power constraint over the RF
chains, the goal is to maximize the minimum (max-min) received signal-to-noise
ratio (SNR) among all users. We propose a low complexity algorithm to compute
the RF precoder that achieves near-optimal max-min performance. Moreover, we
derive a simple condition under which the hybrid precoding driven by a limited
number of RF chains incurs no loss of optimality with respect to the fully
digital precoding case. Finally, numerical results validate the effectiveness
of the proposed algorithm and theoretical findings.Comment: Accepted to IEEE Commun. Let
Physical Layer Service Integration in 5G: Potentials and Challenges
High transmission rate and secure communication have been identified as the
key targets that need to be effectively addressed by fifth generation (5G)
wireless systems. In this context, the concept of physical-layer security
becomes attractive, as it can establish perfect security using only the
characteristics of wireless medium. Nonetheless, to further increase the
spectral efficiency, an emerging concept, termed physical-layer service
integration (PHY-SI), has been recognized as an effective means. Its basic idea
is to combine multiple coexisting services, i.e., multicast/broadcast service
and confidential service, into one integral service for one-time transmission
at the transmitter side. This article first provides a tutorial on typical
PHY-SI models. Furthermore, we propose some state-of-the-art solutions to
improve the overall performance of PHY-SI in certain important communication
scenarios. In particular, we highlight the extension of several concepts
borrowed from conventional single-service communications, such as artificial
noise (AN), eigenmode transmission etc., to the scenario of PHY-SI. These
techniques are shown to be effective in the design of reliable and robust
PHY-SI schemes. Finally, several potential research directions are identified
for future work.Comment: 12 pages, 7 figure
Joint Unitary Triangularization for MIMO Networks
This work considers communication networks where individual links can be
described as MIMO channels. Unlike orthogonal modulation methods (such as the
singular-value decomposition), we allow interference between sub-channels,
which can be removed by the receivers via successive cancellation. The degrees
of freedom earned by this relaxation are used for obtaining a basis which is
simultaneously good for more than one link. Specifically, we derive necessary
and sufficient conditions for shaping the ratio vector of sub-channel gains of
two broadcast-channel receivers. We then apply this to two scenarios: First, in
digital multicasting we present a practical capacity-achieving scheme which
only uses scalar codes and linear processing. Then, we consider the joint
source-channel problem of transmitting a Gaussian source over a two-user MIMO
channel, where we show the existence of non-trivial cases, where the optimal
distortion pair (which for high signal-to-noise ratios equals the optimal
point-to-point distortions of the individual users) may be achieved by
employing a hybrid digital-analog scheme over the induced equivalent channel.
These scenarios demonstrate the advantage of choosing a modulation basis based
upon multiple links in the network, thus we coin the approach "network
modulation".Comment: Submitted to IEEE Tran. Signal Processing. Revised versio
- …