Optimal read/write memory system components

Two holographic data storage and display systems, voltage gradient ionization system, and linear strain manipulation system are discussed in terms of creating fast, high bit density, storage device. Components described include: novel mounting fixture for photoplastic arrays; corona discharge device; and block data composer

Optical and holographic storage properties of F3, Cu, and Mg-doped lithium niobate

Several samples of iron, copper, and magnesium doped lithium niobate were tested to determine their storage properties which would be applicable to an optical data storage system and an integrated optics data preprocessor which makes use of holographic storage techniques. The parameters of interest were the diffraction efficiency, write power, write time, erase time, erase energy, and write sensitivity. Results of these parameters are presented. It was found that iron doped lithium niobate samples yielded the best results in all parameters except for a few percent higher diffraction efficiency in copper doped samples. The magnesium doped samples were extremely insensitive and are not recommended for use in holographic optical data storage and processing systems

Study of multiple hologram recording in lithium niobate

The results of a number of theoretical and experimental studies relating to multiple hologram recording in lithium niobate are reported. The analysis of holographic gratings stored in lithium niobate has been extended to cover a more realistic range of physical situations. A new successful dynamic (feedback) theory for describing recording, nondestructive reading, erasure, enhancement, and angular sensitivity has been developed. In addition, the possible architectures of mass data storage systems have been studied

An investigation for the development of an integrated optical data preprocessor

The successful fabrication and demonstration of an integrated optical circuit designed to perform a parallel processing operation by utilizing holographic subtraction to simultaneously compare N analog signal voltages with N predetermined reference voltages is summarized. The device alleviates transmission, storage and processing loads of satellite data systems by performing, at the sensor site, some preprocessing of data taken by remote sensors. Major accomplishments in the fabrication of integrated optics components include: (1) fabrication of the first LiNbO3 waveguide geodesic lens; (2) development of techniques for polishing TIR mirrors on LiNbO3 waveguides; (3) fabrication of high efficiency metal-over-photoresist gratings for waveguide beam splitters; (4) demonstration of high S/N holographic subtraction using waveguide holograms; and (5) development of alignment techniques for fabrication of integrated optics circuits. Important developments made in integrated optics are the discovery and suggested use of holographic self-subtraction in LiNbO3, development of a mathematical description of the operating modes of the preprocessor, and the development of theories for diffraction efficiency and beam quality of two dimensional beam defined gratings

Photorefractive properties of lithium niobate crystals doped with manganese

The photorefractive properties of lithium niobate crystals doped with manganese (Mn) have been investigated. It is found that the effect of dark decay due to electron tunneling, which is the limiting factor of the highest practical doping level, is less in LiNbO_3:Mn than in LiNbO_3:Fe , and higher doping levels can be used in LiNbO_3:Mn to achieve larger dynamic range and sensitivity for holographic applications. The highest practical doping level in LiNbO_3:Mn has been found to be ~0.5 wt.% MnCO_3, and refractive-index changes and sensitivities up to 1.5X10^-3 and 1.3 cm/J are measured for extraordinarily polarized light of the wavelength 458 nm. It has been found that, in terms of both dynamic range (or refractive-index change) and sensitivity, the optimal oxidation state is highly oxidized. The distribution coefficient of Mn has been determined to be ~1. Absorption measurements are used to obtain more information about charge-transport parameters. The material is excellently suited for holographic recording with blue light. The hologram quality is outstanding because holographic scattering is much weaker compared with that in, e.g., iron-doped lithium niobate. Thermal fixing has been successfully demonstrated in LiNbO_3:Mn crystals

Storage Density of Shift-Multiplexed Holographic Memory

The storage density of shift-multiplexed holographic memory is calculated and compared with experimentally achieved densities by use of photorefractive and write-once materials. We consider holographic selectivity as well as the recording material s dynamic range (M /#) and required diffraction efficiencies in formulating the calculations of storage densities, thereby taking into account all major factors limiting the raw storage density achievable with shift-multiplexed holographic storage systems. We show that the M /# is the key factor in limiting storage densities rather than the recording material s thickness for organic materials in which the scatter is relatively high. A storage density of 100 bits m2 is experimentally demonstrated by use of a 1-mm-thick LiNbO3 crystal as the recording medium

Alignment sensitivity of holographic three-dimensional disks

We describe the rotational alignment sensitivity of three-dimensional holographic disks. It is shown that the reconstructed image always rotates by the angle by which the disk rotates; however, the center and the radius of rotation change as the recording geometry changes. A comparison among image plane, Fourier plane, and Fresnel holograms is given, and an optimum configuration (in terms of alignment sensitivity) in which the radius of rotation is zero is derived. We present experimental results and also discuss how the rotation alignment sensitivity affects the storage density and the readout–recording speed of the three-dimensional disk. A brief summary of other sources of misalignment is given

Readout fidelity of coaxial holographic digital data page recording in nanoparticle–(thiol–ene) polymer composites

We report on an experimental investigation of nanoparticle-concentration and thiol-to-ene stoichiometric ratio dependences of symbol error rates (SERs) and signal-to-noise ratios (SNRs) of digital data pages recorded at a wavelength of 532 nm in thiol–ene based nanoparticle–polymer composite (NPC) films by using a coaxial holographic digital data storage method. We show that SERs and SNRs at the optimized material condition can be lower than 1 × 10−4 and higher than 10, respectively, without error correction coding. These results show the usefulness of thiol–ene based NPCs as coaxial holographic data storage media