Flexibility for Internet Protocol Backbone Network for Airspace Management Agency Using Dense Wave Division Multiplexing (DWDM)

With the increasing emphasis on service quality in the network of Airspace Management Agencyin the world, coupled with the extensive growth in internet traffic globally it has become a necessity to enhance the backbone network of Airspace Agency with flexibility of Internet Protocol using the Dense Wave Division Multiplexing (DWDM). This is to enhance the backbone network with a resilience of IP-DWDM in case of failure. The IP-DWDM network merges the IP and optical layers making network flexibility possible. The measurement, analysis and evaluations of the backbone network were carried out using simulation method. The throughput, latency and data loss were evaluated and analyzed. The result obtained shows that the Dense Wave Division Multiplexing has relatively high throughput, low latency and less packet drop which resulted in high transmission rate over a long distance and low cost in running the network. The paper therefore, proposes the use of embedded flexibility of the network in achieving an increase in the efficiency and utilization of the bandwidth of the interconnecting core routers of the networks

Challenges in the capture and dissemination of measurements from high-speed networks

The production of a large-scale monitoring system for a high-speed network leads to a number of challenges. These challenges are not purely technical but also socio-political and legal. The number of stakeholders in such monitoring activity is large including the network operators, the users, the equipment manufacturers and, of course, the monitoring researchers. The MASTS project (measurement at all scales in time and space) was created to instrument the high-speed JANET Lightpath network and has been extended to incorporate other paths supported by JANET(UK). Challenges the project has faced included: simple access to the network; legal issues involved in the storage and dissemination of the captured information, which may be personal; the volume of data captured and the rate at which these data appear at store. To this end, the MASTS system will have established four monitoring points each capturing packets on a high-speed link. Traffic header data will be continuously collected, anonymised, indexed, stored and made available to the research community. A legal framework for the capture and storage of network measurement data has been developed which allows the anonymised IP traces to be used for research purposes

Journal of Telecommunications in Higher Education

This Issue: Integrating Networks ATM: It\u27s All That Matters ATM Delivers Voice, Data, Video Cabling the Integrated Network Interview: Robert Collet, Data Services & Network Systems BYU: Striving for Excellence in Telecom Service

Converged vs. Dedicated IPSec Encryption Testing in Gigabit Ethernet Networks

In January, 2005, Safenet, Inc. contacted the networking group to investigate the possibility of using our students for the purpose of comparing the performance of dedicated encryption device to an integrated encrypting device. The tests would also include a performance comparison between Data Link Layer (Layer 2) devices and Network Layer (Layer 3) devices. It was decided that the tests would consist of throughput, frame loss, and network latency. Two network topologies were used for the experiments: gigabit Ethernet and SONET OC-48. The equipment to be tested was Safenet’s High Assurance 4000 Gateway (HA4000) for the gigabit Ethernet topology and the SafeNet SSE Encryptor for the SONET topology. The Cisco Catalyst 6509 equipped with the Cisco VPN Accelerator was used for both topologies. An IXIA400T was used to generate the traffic for the performance tests. The procedure was straight forward. Baselines for each of the criteria (throughput, frame loss, and latency) by connecting the Cisco 6509’s back to back for each of the topologies to be tested. Once the baselines were established, the performance tests were performed for each of the encryption technologies and data was collected for each of the criteria

Investigation of EDFA power transients in circuit-switched and packet-switched optical networks

Erbium-doped fibre amplifiers (EDFA’s) are a key technology for the design of all optical communication systems and networks. The superiority of EDFAs lies in their negligible intermodulation distortion across high speed multichannel signals, low intrinsic losses, slow gain dynamics, and gain in a wide range of optical wavelengths. Due to long lifetime in excited states, EDFAs do not oppose the effect of cross-gain saturation. The time characteristics of the gain saturation and recovery effects are between a few hundred microseconds and 10 milliseconds. However, in wavelength division multiplexed (WDM) optical networks with EDFAs, the number of channels traversing an EDFA can change due to the faulty link of the network or the system reconfiguration. It has been found that, due to the variation in channel number in the EDFAs chain, the output system powers of surviving channels can change in a very short time. Thus, the power transient is one of the problems deteriorating system performance. In this thesis, the transient phenomenon in wavelength routed WDM optical networks with EDFA chains was investigated. The task was performed using different input signal powers for circuit switched networks. A simulator for the EDFA gain dynamicmodel was developed to compute the magnitude and speed of the power transients in the non-self-saturated EDFA both single and chained. The dynamic model of the self-saturated EDFAs chain and its simulator were also developed to compute the magnitude and speed of the power transients and the Optical signal-to-noise ratio (OSNR). We found that the OSNR transient magnitude and speed are a function of both the output power transient and the number of EDFAs in the chain. The OSNR value predicts the level of the quality of service in the related network. It was found that the power transients for both self-saturated and non-self-saturated EDFAs are close in magnitude in the case of gain saturated EDFAs networks. Moreover, the cross-gain saturation also degrades the performance of the packet switching networks due to varying traffic characteristics. The magnitude and the speed of output power transients increase along the EDFAs chain. An investigation was done on the asynchronous transfer mode (ATM) or the WDM Internet protocol (WDM-IP) traffic networks using different traffic patterns based on the Pareto and Poisson distribution. The simulator is used to examine the amount and speed of the power transients in Pareto and Poisson distributed traffic at different bit rates, with specific focus on 2.5 Gb/s. It was found from numerical and statistical analysis that the power swing increases if the time interval of theburst-ON/burst-OFF is long in the packet bursts. This is because the gain dynamics is fast during strong signal pulse or with long duration pulses, which is due to the stimulatedemission avalanche depletion of the excited ions. Thus, an increase in output power levelcould lead to error burst which affects the system performance

Hyperscsi : Design and development of a new protocol for storage networking

Ph.DDOCTOR OF PHILOSOPH

Proceedings of the NSSDC Conference on Mass Storage Systems and Technologies for Space and Earth Science Applications

The proceedings of the National Space Science Data Center Conference on Mass Storage Systems and Technologies for Space and Earth Science Applications held July 23 through 25, 1991 at the NASA/Goddard Space Flight Center are presented. The program includes a keynote address, invited technical papers, and selected technical presentations to provide a broad forum for the discussion of a number of important issues in the field of mass storage systems. Topics include magnetic disk and tape technologies, optical disk and tape, software storage and file management systems, and experiences with the use of a large, distributed storage system. The technical presentations describe integrated mass storage systems that are expected to be available commercially. Also included is a series of presentations from Federal Government organizations and research institutions covering their mass storage requirements for the 1990's

Teleoperation of passivity-based model reference robust control over the internet

This dissertation offers a survey of a known theoretical approach and novel experimental results in establishing a live communication medium through the internet to host a virtual communication environment for use in Passivity-Based Model Reference Robust Control systems with delays. The controller which is used as a carrier to support a robust communication between input-to-state stability is designed as a control strategy that passively compensates for position errors that arise during contact tasks and strives to achieve delay-independent stability for controlling of aircrafts or other mobile objects. Furthermore the controller is used for nonlinear systems, coordination of multiple agents, bilateral teleoperation, and collision avoidance thus maintaining a communication link with an upper bound of constant delay is crucial for robustness and stability of the overall system. For utilizing such framework an elucidation can be formulated by preparing site survey for analyzing not only the geographical distances separating the nodes in which the teleoperation will occur but also the communication parameters that define the virtual topography that the data will travel through. This survey will first define the feasibility of the overall operation since the teleoperation will be used to sustain a delay based controller over the internet thus obtaining a hypothetical upper bound for the delay via site survey is crucial not only for the communication system but also the delay is required for the design of the passivity-based model reference robust control. Following delay calculation and measurement via site survey, bandwidth tests for unidirectional and bidirectional communication is inspected to ensure that the speed is viable to maintain a real-time connection. Furthermore from obtaining the results it becomes crucial to measure the consistency of the delay throughout a sampled period to guarantee that the upper bound is not breached at any point within the communication to jeopardize the robustness of the controller. Following delay analysis a geographical and topological overview of the communication is also briefly examined via a trace-route to understand the underlying nodes and their contribution to the delay and round-trip consistency. To accommodate the communication channel for the controller the input and output data from both nodes need to be encapsulated within a transmission control protocol via a multithreaded design of a robust program within the C language. The program will construct a multithreaded client-server relationship in which the control data is transmitted. For added stability and higher level of security the channel is then encapsulated via an internet protocol security by utilizing a protocol suite for protecting the communication by authentication and encrypting each packet of the session using negotiation of cryptographic keys during each session