Timing and Carrier Synchronization in Wireless Communication Systems: A Survey and Classification of Research in the Last 5 Years

Timing and carrier synchronization is a fundamental requirement for any wireless communication system to work properly. Timing synchronization is the process by which a receiver node determines the correct instants of time at which to sample the incoming signal. Carrier synchronization is the process by which a receiver adapts the frequency and phase of its local carrier oscillator with those of the received signal. In this paper, we survey the literature over the last 5 years (2010–2014) and present a comprehensive literature review and classification of the recent research progress in achieving timing and carrier synchronization in single-input single-output (SISO), multiple-input multiple-output (MIMO), cooperative relaying, and multiuser/multicell interference networks. Considering both single-carrier and multi-carrier communication systems, we survey and categorize the timing and carrier synchronization techniques proposed for the different communication systems focusing on the system model assumptions for synchronization, the synchronization challenges, and the state-of-the-art synchronization solutions and their limitations. Finally, we envision some future research directions

Frame synchronization for PSAM in AWGN and Rayleigh fading channels

Pilot Symbol Assisted Modulation (PSAM) is a good method to compensate for the channel fading effect in wireless mobile communications. In PSAM, known pilot symbols are periodically inserted into the transmitted data symbol stream and the receiver uses these symbols to derive amplitude and phase reference. One aspect of this procedure, which has not received much attention yet, is the frame synchronization, i.e. the method used by the receiver to locate the time position of the pilot symbols. In this study, two novel non-coherent frame synchronization methods are introduced in which only the magnitude of received signal is used to obtain the timing of the pilot symbol. The methods are evaluated for both AWGN and frequency non-selective slow Rayleigh fading channels. One synchronization technique is derived by standard maximum likelihood (ML) estimation formulation, and the other is obtained by using maximum a Posteriori probability (MAP) with a threshold test. Signal processing in the receiver uses simplifying approximations that rely on relatively high signal-to-noise ratio (SNR) as consistent with the reception of 16-QAM. Computer simulation has been used to test the acquisition time performance and the probability of false acquisition. Several lengths and patterns of pilot symbol sequences were tested where every 10th symbol was a pilot symbol and all other symbols were randomly selected data symbols. When compared with the other published synchronizers, results from this study show better performance in both AWGN and fading channels. Significantly better performance is observed in the presence of receiver frequency offsets

Joint CFO Estimation and Data Detection in OFDM systems

Orthogonal frequency division multiplexing (OFDM) is a multicarrier modulation technique that is widely used in wireless broadband communication systems. The spectral e ciency of OFDM is very high since the subcarriers are spaced as closely as possible while maintaining orthogonality. However, one of the major problems with OFDM that can cause performance degradation is carrier frequency o set (CFO) which impairs the orthogonality among OFDM subcarriers, as a consequence, results in inter-subcarrier interference. In this thesis, an iterative algorithm for joint CFO estimation and data detection in OFDM systems over frequency selective channels is proposed. The proposed algorithm is performing both CFO estimation and data detection in the frequency domain based on the Expectation-Maximization (EM) algorithm. The proposed algorithm can achieve the same bit-error-rate (BER) performance as that of its time-domain counterpart with much lower complexity. Simulation results show that the proposed algorithm can converge after three iterations and an estimate of CFO can be obtained with high accuracy