Estimation of RVoG Scene Parameters by Means of PolInSAR With TanDEM-X Data: Effect of the Double-Bounce Contribution

This article evaluates the effect of the double-bounce (DB) decorrelation term that appears in single-pass bistatic acquisitions, as in the TanDEM-X system, on the inversion of scene parameters by means of polarimetric SAR interferometry (PolInSAR). The retrieval of all scene parameters involved in the Random Volume over Ground (RVoG) model (i.e., ground topography, vegetation height, extinction, and ground-to-volume ratios) is affected by this term when the radar response from the ground is dominated by the DB. The estimation error in all these parameters is analyzed by means of simulations over a wide range of system configurations and scene variables for both agricultural crops and forest scenarios. Simulations demonstrate that the inclusion of the DB term, which complicates the inversion algorithm, is necessary for the angles of incidence shallower than 30° to achieve an estimation error below 10% in vegetation height and to avoid a significant underestimation in the ground-to-volume ratios. At steep incidences, this decorrelation term does not affect the estimation of vegetation height and ground-to-volume ratios. Regarding the extinction, this parameter is intrinsically not well estimated, since most retrieved values are close to the initial guesses employed for the optimization algorithm, regardless of the use or not of the DB decorrelation term. Finally, these findings are compared with the experimental results from the TanDEM-X data acquired over the rice fields in Spain for the available system parameters (baseline and incidence angle) of the acquired data set.This work was supported in part by the Spanish Ministry of Science, Innovation and Universities, the State Agency of Research (AEI), and in part by the European Funds for Regional Development (EFRD) under Project TEC2017-85244-C2-1-P. The work of Noelia Romero-Puig was supported in part by the Generalitat Valenciana and in part by the European Social Fund (ESF) under Grant ACIF/2018/204

Retrieval of vegetation height in rice fields using polarimetric SAR interferometry with TanDEM-X data

This work presents for the first time a demonstration with satellite data of polarimetric SAR interferometry (PolInSAR) applied to the retrieval of vegetation height in rice fields. Three series of dual-pol interferometric SAR data acquired with large baselines (2–3 km) by the TanDEM-X system during its science phase (April–September 2015) are exploited. A novel inversion algorithm especially suited for rice fields cultivated in flooded soil is proposed and evaluated. The validation is carried out over three test sites located in geographically different areas: Sevilla (SW Spain), Valencia (E Spain), and Ipsala (W Turkey), in which different rice types are present. Results are obtained during the whole growth cycle and demonstrate that PolInSAR is useful to produce accurate height estimates (RMSE 10–20 cm) when plants are tall enough (taller than 25–40 cm), without relying on external reference information.This work has been supported by the Spanish Ministry of Economy and Competitiveness (MINECO) and EU FEDER under project TIN2014-55413-C2-2-P. The research leading to these results has received funding from the European Union Seventh Framework Programme (FP7/2007–2013) under grant agreement 606983, and the Land-SAF (the EUMETSAT Network of Satellite Application Facilities) project. The in-situ measurements in the Ipsala site were conducted with the funding of The Scientific and Technological Research Council of Turkey (TUBITAK, Project No.: 113Y446)

A Review of Crop Height Retrieval Using InSAR Strategies: Techniques and Challenges

This article compares the performance of four different interferometric synthetic aperture radar (SAR) techniques for the estimation of rice crop height by means of bistatic TanDEM-X data. Methods based on the interferometric phase alone, on the coherence amplitude alone, on the complex coherence value, and on polarimetric SAR interferometry (PolInSAR) are analyzed. Validation is conducted with reference data acquired over rice fields in Spain during the Science Phase of the TanDEM-X mission. Single- and dual-polarized data are exploited to also provide further insights into the polarization influence on these approaches. Vegetation height estimates from methodologies based on the interferometric phase show a general underestimation for the HH channel (with a bias that reaches around 25 cm in mid-July for some fields), whereas the VV channel is strongly influenced by noisy phases, especially at large incidences [root-mean-square error (RMSE) = 31 cm]. Results show that these approaches perform better at shallower incidences than the methodologies based on coherence amplitude and on PolInSAR, which obtain the most suitable results at steep incidences, with RMSE values of 17 and 23 cm. On the contrary, at shallower incidences, they are highly affected by very low input coherence levels. Hence, they tend to overestimate vegetation height.This work was supported by the Spanish Ministry of Science and Innovation, in part by the State Agency of Research, and in part by the European Funds for Regional Development under Project TEC2017-85244-C2-1-P. The work of Noelia Romero-Puig was supported in part by the Generalitat Valenciana and in part by the European Social Fund under Grant ACIF/2018/204

Assessment of L-Band SAOCOM InSAR coherence and its comparison with C-Band: A case study over managed forests in Argentina

The objective of this work is to analyze the behavior of short temporal baseline interferomet ric coherence in forested areas for L-band spaceborne SAR data. Hence, an exploratory assessment of the impacts of temporal and spatial baselines on coherence, with emphasis on how these effects vary between SAOCOM-1 L-band and Sentinel-1 C-band data is presented. The interferometric coherence is analyzed according to different imaging parameters. In the case of SAOCOM-1, the impacts of the variation of the incidence angle and the ascending and descending orbits over forested areas are also assessed. Finally, short-term 8-day interferometric coherence maps derived from SAOCOM-1 are especially addressed, since this is the first L-band spaceborne mission that allows us to acquire SAR images with such a short temporal span. The analysis is reported over two forest-production areas in Argentina, one of which is part of the most important region in terms of forest plantations at the national level. In the case of SAOCOM, interferometric configurations are characterized by a lack of control on the spatial baseline, so a zero-baseline orbital tube cannot be guaranteed. Nevertheless, this spatial baseline variability is crucial to exploit volume decorrelation for forest monitoring. The results from this exploratory analysis demonstrates that SAOCOM-1 short temporal baseline interferograms, 8 to 16 days, must be considered in order to mitigate temporal decorrelation effects and to be able to experiment with different spatial baseline configurations, in order to allow appropriate forest monitoring.This research was funded by the project INTERACT PID2020-114623RB-C32 funded by the Spanish MCIN /AEI /10.13039 /501100011033.Peer ReviewedPostprint (published version

A Simple RVoG Test for PolInSAR Data

In this paper, we present a simple algorithm for assessing the validity of the RVoG model for PolInSAR-based inversion techniques. This approach makes use of two important features characterizing a homogeneous random volume over a ground surface, i.e., the independence on polarization states of wave propagation through the volume and the structure of the polarimetric interferometric coherency matrix. These two features have led to two different methods proposed in the literature for retrieving the topographic phase within natural covers, i.e., the well-known line fitting procedure and the observation of the (1, 2) element of the polarimetric interferometric coherency matrix. We show that differences between outputs from both approaches can be interpreted in terms of the PolInSAR modeling based on the Freeman-Durden concept, and this leads to the definition of a RVoG/non-RVoG test. The algorithm is tested with both indoor and airborne data over agricultural and tropical forest areas.This work was supported by the Spanish Ministry of Economy and Competitiveness (MINECO) and EU FEDER under Project TEC2011-28201-C02-02

Polarimetric Synthetic Aperture Radar

This open access book focuses on the practical application of electromagnetic polarimetry principles in Earth remote sensing with an educational purpose. In the last decade, the operations from fully polarimetric synthetic aperture radar such as the Japanese ALOS/PalSAR, the Canadian Radarsat-2 and the German TerraSAR-X and their easy data access for scientific use have developed further the research and data applications at L,C and X band. As a consequence, the wider distribution of polarimetric data sets across the remote sensing community boosted activity and development in polarimetric SAR applications, also in view of future missions. Numerous experiments with real data from spaceborne platforms are shown, with the aim of giving an up-to-date and complete treatment of the unique benefits of fully polarimetric synthetic aperture radar data in five different domains: forest, agriculture, cryosphere, urban and oceans

A Modified Dual-Baseline PolInSAR Method for Forest Height Estimation

This paper investigates the potentials and limitations of a simple dual-baseline PolInSAR (DBPI) method for forest height inversion. This DBPI method follows the classical three-stage inversion method’s idea used in single baseline PolInSAR (SBPI) inversion, but it avoids the assumption of the smallest ground-to-volume amplitude ratio (GVR) by employing an additional baseline to constrain the inversion procedure. In this paper, we present for the first time an assessment of such a method on real PolInSAR data over boreal forest. Additionally, we propose an improvement on the original DBPI method by incorporating the sloped random volume over ground (S-RVoG) model in order to reduce the range terrain slope effect. Therefore, a digital elevation model (DEM) is needed to provide the slope information in the proposed method. Three scenes of P-band airborne PolInSAR data acquired by E-SAR and light detection and ranging (LIDAR) data available in the BioSAR2008 campaign are employed for testing purposes. The performance of the SBPI, DBPI, and modified DBPI methods is compared. The results show that the DBPI method extracts forest heights with an average root mean square error (RMSE) of 4.72 m against LIDAR heights for trees of 18 m height on average. It presents a significant improvement of forest height accuracy over the SBPI method (with a stand-level mean improvement of 42.86%). Concerning the modified DBPI method, it consistently improves the accuracy of forest height inversion over sloped areas. This improvement reaches a stand-level mean of 21.72% improvement (with a mean RMSE of 4.63 m) for slopes greater than 10°.This work was supported in part by National Nature Science Foundation of China under Grant 41531068, 41371335, 41671356, and 41274010, the Spanish Ministry of Economy and Competitiveness and EU FEDER under Project TIN2014-55413-C2-2-P, China Scholarship Council under Grant 201406370079, and Hunan Provincial Department of Education Science Research Key Project 15A074. The BioSAR2008 campaign data is provided by European Space Agency under the ESA EO Project 14751

Forest Structure Retrieval From EcoSAR P-Band Single-Pass Interferometry

EcoSAR is a single-pass (dual antenna) digital beamforming, P-band radar system that is designed for remote sensing of dense forest structure. Forest structure retrievals require the measurement related to the vertical dimension, for which several techniques have been developed over the years. These techniques use polarimetric and interferometric aspects of the SAR data, which can be collected using EcoSAR. In this paper we describe EcoSAR system in light of its interferometric capabilities and investigate forest structure retrieval techniques

Application of the Trace Coherence to HH-VV PolInSAR TanDEM-X Data for Vegetation Height Estimation

This article investigates, for the first time, the inclusion of the operator Trace Coherence (TrCoh) in polarimetric and interferometric synthetic aperture radar (SAR) methodologies for the estimation of biophysical parameters of vegetation. A modified inversion algorithm based on the well-known Random Volume over Ground (RVoG) model, which employs the TrCoh, is described and evaluated. In this regard, a different set of coherence extrema is used as input for the retrieval stage. In addition, the proposed methodology improves the inversion algorithm by employing analytical solutions rather than approximations. Validation is carried out exploiting single-pass HH-VV bistatic TanDEM-X data, together with reference data acquired over a paddy rice area in Spain. The added value of the TrCoh and the convenience of the use of analytical solutions are assessed by comparing with the conventional polarimetric SAR interferometry (PolInSAR) algorithm. Results demonstrate that the modified proposed methodology is computationally more effective than current methods on this dataset. For the same scene, the steps required for inversion are computed in 6 min with the conventional method, while it only takes 6 s with the proposed approach. Moreover, vegetation height estimates exhibit a higher accuracy with the proposed method in all fields under evaluation. The root-mean-squared error reached with the modified method improves by 7 cm with respect to the conventional algorithm.This work was supported in part by the Spanish Ministry of Science and Innovation, in part by the State Agency of Research (AEI), and in part by the European Funds for Regional Development (EFRD) under Project TEC2017-85244-C2-1-P. The work of Noelia Romero-Puig was supported in part by Generalitat Valenciana and in part by the European Social Fund (ESF) under Grant ACIF/2018/204