Multiple bit error correcting architectures over finite fields

This thesis proposes techniques to mitigate multiple bit errors in GF arithmetic circuits. As GF arithmetic circuits such as multipliers constitute the complex and important functional unit of a crypto-processor, making them fault tolerant will improve the reliability of circuits that are employed in safety applications and the errors may cause catastrophe if not mitigated. Firstly, a thorough literature review has been carried out. The merits of efficient schemes are carefully analyzed to study the space for improvement in error correction, area and power consumption. Proposed error correction schemes include bit parallel ones using optimized BCH codes that are useful in applications where power and area are not prime concerns. The scheme is also extended to dynamically correcting scheme to reduce decoder delay. Other method that suits low power and area applications such as RFIDs and smart cards using cross parity codes is also proposed. The experimental evaluation shows that the proposed techniques can mitigate single and multiple bit errors with wider error coverage compared to existing methods with lesser area and power consumption. The proposed scheme is used to mask the errors appearing at the output of the circuit irrespective of their cause. This thesis also investigates the error mitigation schemes in emerging technologies (QCA, CNTFET) to compare area, power and delay with existing CMOS equivalent. Though the proposed novel multiple error correcting techniques can not ensure 100% error mitigation, inclusion of these techniques to actual design can improve the reliability of the circuits or increase the difficulty in hacking crypto-devices. Proposed schemes can also be extended to non GF digital circuits

High-speed VLSI implementation of Digit-serial Gaussian normal basis Multiplication over GF(2m)

In this paper, by employing the logical effort technique an efficient and high-speed VLSI implementation of the digit-serial Gaussian normal basis multiplier is presented. It is constructed by using AND, XOR and XOR tree components. To have a low-cost implementation with low number of transistors, the block of AND gates are implemented by using NAND gates based on the property of the XOR gates in the XOR tree. To optimally decrease the delay and increase the drive ability of the circuit the logical effort method as an efficient method for sizing the transistors is employed. By using this method and also a 4-input XOR gate structure, the circuit is designed for minimum delay. The digit-serial Gaussian normal basis multiplier is implemented over two binary finite fields GF(2163) and GF(2233) in 0.18μm CMOS technology for three different digit sizes. The results show that the proposed structures, compared to previous structures, have been improved in terms of delay and area parameters

Efficient and Low-complexity Hardware Architecture of Gaussian Normal Basis Multiplication over GF(2m) for Elliptic Curve Cryptosystems

In this paper an efficient high-speed architecture of Gaussian normal basis multiplier over binary finite field GF(2m) is presented. The structure is constructed by using regular modules for computation of exponentiation by powers of 2 and low-cost blocks for multiplication by normal elements of the binary field. Since the exponents are powers of 2, the modules are implemented by some simple cyclic shifts in the normal basis representation. As a result, the multiplier has a simple structure with a low critical path delay. The efficiency of the proposed structure is studied in terms of area and time complexity by using its implementation on Vertix-4 FPGA family and also its ASIC design in 180nm CMOS technology. Comparison results with other structures of the Gaussian normal basis multiplier verify that the proposed architecture has better performance in terms of speed and hardware utilization

High-speed Hardware Implementations of Point Multiplication for Binary Edwards and Generalized Hessian Curves

In this paper high-speed hardware architectures of point multiplication based on Montgomery ladder algorithm for binary Edwards and generalized Hessian curves in Gaussian normal basis are presented. Computations of the point addition and point doubling in the proposed architecture are concurrently performed by pipelined digit-serial finite field multipliers. The multipliers in parallel form are scheduled for lower number of clock cycles. The structure of proposed digit-serial Gaussian normal basis multiplier is constructed based on regular and low-cost modules of exponentiation by powers of two and multiplication by normal elements. Therefore, the structures are area efficient and have low critical path delay. Implementation results of the proposed architectures on Virtex-5 XC5VLX110 FPGA show that then execution time of the point multiplication for binary Edwards and generalized Hessian curves over GF(2163) and GF(2233) are 8.62µs and 11.03µs respectively. The proposed architectures have high-performance and high-speed compared to other works

Subthreshold circuits: Design, implementation and application

Digital circuits operating in the subthreshold region of the transistor are being used as an ideal option for ultra low power complementary metal-oxide-semiconductor (CMOS) design. The use of subthreshold circuit design in cryptographic systems is gaining importance as a counter measure to power analysis attacks. A power analysis attack is a non-invasive side channel attack in which the power consumption of the cryptographic system can be analyzed to retrieve the encrypted data. A number of techniques to increase the resistance to power attacks have been proposed at algorithmic and hardware levels, but these techniques suffer from large area and power overheads. The main aim of this research is to understand the viability of implementing subthreshold systems for cryptographic applications. Standard cell libraries in subthreshold are designed and a methodology to identify the minimum energy point, aspect ratio, frequency range and operating voltage for CMOS standard cells is defined. As scalar multiplication is the fundamental operation in elliptic curve cryptographic systems, a digit-level gaussian normal basis (GNB) multiplier is implemented using the aforementioned standard cells. A similar standard-cell library is designed for the multiplier to operate in the superthreshold regime. The subthreshold and superthreshold multipliers are then subjected to a differential power analysis attack. Power performance and signal-to-noise ratio (SNR) of both these systems are compared to evaluate the usefulness of the subthreshold design. The power consumption of the subthreshold multiplier is 4.554 uW, the speed of the multiplier is 65.1 KHz and the SNR is 40 dB. The superthreshold multiplier has a power consumption of 4.005 mW, the speed of the multiplier is 330 MHz and the SNR is 200 dB. Reduced power consumption, hence reduced SNR, increases the resistance of the subthreshold multiplier against power analysis attacks. (Refer to PDF for exact formulas)

The 1992 4th NASA SERC Symposium on VLSI Design

Papers from the fourth annual NASA Symposium on VLSI Design, co-sponsored by the IEEE, are presented. Each year this symposium is organized by the NASA Space Engineering Research Center (SERC) at the University of Idaho and is held in conjunction with a quarterly meeting of the NASA Data System Technology Working Group (DSTWG). One task of the DSTWG is to develop new electronic technologies that will meet next generation electronic data system needs. The symposium provides insights into developments in VLSI and digital systems which can be used to increase data systems performance. The NASA SERC is proud to offer, at its fourth symposium on VLSI design, presentations by an outstanding set of individuals from national laboratories, the electronics industry, and universities. These speakers share insights into next generation advances that will serve as a basis for future VLSI design

Reliable Hardware Architectures for Cyrtographic Block Ciphers LED and HIGHT

Cryptographic architectures provide different security properties to sensitive usage models. However, unless reliability of architectures is guaranteed, such security properties can be undermined through natural or malicious faults. In this thesis, two underlying block ciphers which can be used in authenticated encryption algorithms are considered, i.e., LED and HIGHT block ciphers. The former is of the Advanced Encryption Standard (AES) type and has been considered areaefficient, while the latter constitutes a Feistel network structure and is suitable for low-complexity and low-power embedded security applications. In this thesis, we propose efficient error detection architectures including variants of recomputing with encoded operands and signature-based schemes to detect both transient and permanent faults. Authenticated encryption is applied in cryptography to provide confidentiality, integrity, and authenticity simultaneously to the message sent in a communication channel. In this thesis, we show that the proposed schemes are applicable to the case study of Simple Lightweight CFB (SILC) for providing authenticated encryption with associated data (AEAD). The error simulations are performed using Xilinx ISE tool and the results are benchmarked for the Xilinx FPGA family Virtex- 7 to assess the reliability capability and efficiency of the proposed architectures

Classical simulations of Abelian-group normalizer circuits with intermediate measurements

Quantum normalizer circuits were recently introduced as generalizations of Clifford circuits [arXiv:1201.4867]: a normalizer circuit over a finite Abelian group $G$ is composed of the quantum Fourier transform (QFT) over G, together with gates which compute quadratic functions and automorphisms. In [arXiv:1201.4867] it was shown that every normalizer circuit can be simulated efficiently classically. This result provides a nontrivial example of a family of quantum circuits that cannot yield exponential speed-ups in spite of usage of the QFT, the latter being a central quantum algorithmic primitive. Here we extend the aforementioned result in several ways. Most importantly, we show that normalizer circuits supplemented with intermediate measurements can also be simulated efficiently classically, even when the computation proceeds adaptively. This yields a generalization of the Gottesman-Knill theorem (valid for n-qubit Clifford operations [quant-ph/9705052, quant-ph/9807006] to quantum circuits described by arbitrary finite Abelian groups. Moreover, our simulations are twofold: we present efficient classical algorithms to sample the measurement probability distribution of any adaptive-normalizer computation, as well as to compute the amplitudes of the state vector in every step of it. Finally we develop a generalization of the stabilizer formalism [quant-ph/9705052, quant-ph/9807006] relative to arbitrary finite Abelian groups: for example we characterize how to update stabilizers under generalized Pauli measurements and provide a normal form of the amplitudes of generalized stabilizer states using quadratic functions and subgroup cosets.Comment: 26 pages+appendices. Title has changed in this second version. To appear in Quantum Information and Computation, Vol.14 No.3&4, 201