Relaying systems with reciprocity mismatch : impact analysis and calibration

Cooperative beamforming can provide significant performance improvement for relaying systems with the help of the channel state information (CSI). In time-division duplexing (TDD) mode, the estimated CSI will deteriorate due to the reciprocity mismatch. In this work, we examine the impact and the calibration of the reciprocity mismatch in relaying systems. To evaluate the impact of the reciprocity mismatch for all devices, the closed-form expression of the achievable rate is first derived. Then, we analyze the performance loss caused by the reciprocity mismatch at sources, relays, and destinations respectively to show that the mismatch at relays dominates the impact. To compensate the performance loss, a two-stage calibration scheme is proposed for relays. Specifically, relays perform the intra-calibration based on circuits independently. Further, the inter-calibration based on the discrete Fourier transform (DFT) codebook is operated to improve the calibration performance by cooperation transmission, which has never been considered in previous work. Finally, we derive the achievable rate after relays perform the proposed reciprocity calibration scheme and investigate the impact of estimation errors on the system performance. Simulation results are presented to verify the analytical results and to show the performance of the proposed calibration approach

High Capacity Fiber-Connected Wireless MIMO Communication

There will be more and more users while beyond-5G (B5G) and 6G bring more wireless applications. Current cellular communication networks assign specific serving boundaries for each radio, which becomes a limitation when too many users work with one radio simultaneously. By physically distributing radios. user’s service can be more uniform. Radio-over-fiber is a promising enabling technology for distributed antenna systems.To have several tens of Gbit/s data rate, we need to apply millimeter-wave (mm-wave) frequency band in radio-over-fiber (RoF). However, mm-wave signals have weak penetration and high propagation loss. Hence, beamforming and/or multiple-input-multiple-output (MIMO) technology become necessary for mm-wave RoF to overcome those drawbacks.This thesis introduces an automatic distributed MIMO (D-MIMO) testbed with a statistical MIMO capacity analysis for an indoor use case. Raytracing-based simulations also predicts the indoor case to make a comparison. The statistical MIMO capacity analysis shows that D-MIMO has a higher and more uniform capacity than co-located MIMO (C-MIMO) in measurements and simulations.Next, a mm-wave sigma-delta-over-fiber (SDoF) link architecture is proposed for MIMO applications. In the implementation of this link, a QSFP28 fiber link connects a central unit with a remote radio unit with four bandpass sigma-delta-modulation (BPSDM) bitstreams. The remote radio unit generates four mm-wave signals from four BPSDM signals and feeds a linear array antenna. The measurement characterizes the remote radio head at each stage and concludes that this proposed link can reach 800 Msym/s data rate with -0.5 dBm output bandpower.Furthermore, the proposed link is demonstrated with digital beamforming and multi-user MIMO (MU-MIMO) functionalities. The digital beamforming function reaches 700 Msym/s with -25 dB error vector magnitude (EVM) results by improving the received bandpower in comparison to (single-input-single-output) SISO results. The MU-MIMO function serves two independent users at 500 Msym/s symbol rate and satisfies 3GPP requirements at 1 m over-the-air distance.In conclusion, this thesis proves that D-MIMO has a higher and more uniform capacity than C-MIMO by statistical analysis from measurements and simulations. The proposed novel mm-wave SDoF link can pave the way for future D-MIMO applications

Multi-Antenna Techniques for Next Generation Cellular Communications

Future cellular communications are expected to offer substantial improvements for the pre- existing mobile services with higher data rates and lower latency as well as pioneer new types of applications that must comply with strict demands from a wider range of user types. All of these tasks require utmost efficiency in the use of spectral resources. Deploying multiple antennas introduces an additional signal dimension to wireless data transmissions, which provides a significant alternative solution against the plateauing capacity issue of the limited available spectrum. Multi-antenna techniques and the associated key enabling technologies possess unquestionable potential to play a key role in the evolution of next generation cellular systems. Spectral efficiency can be improved on downlink by concurrently serving multiple users with high-rate data connections on shared resources. In this thesis optimized multi-user multi-input multi-output (MIMO) transmissions are investigated on downlink from both filter design and resource allocation/assignment points of view. Regarding filter design, a joint baseband processing method is proposed specifically for high signal-to-noise ratio (SNR) conditions, where the necessary signaling overhead can be compensated for. Regarding resource scheduling, greedy- and genetic-based algorithms are proposed that demand lower complexity with large number of resource blocks relative to prior implementations. Channel estimation techniques are investigated for massive MIMO technology. In case of channel reciprocity, this thesis proposes an overhead reduction scheme for the signaling of user channel state information (CSI) feedback during a relative antenna calibration. In addition, a multi-cell coordination method is proposed for subspace-based blind estimators on uplink, which can be implicitly translated to downlink CSI in the presence of ideal reciprocity. Regarding non-reciprocal channels, a novel estimation technique is proposed based on reconstructing full downlink CSI from a select number of dominant propagation paths. The proposed method offers drastic compressions in user feedback reports and requires much simpler downlink training processes. Full-duplex technology can provide up to twice the spectral efficiency of conventional resource divisions. This thesis considers a full-duplex two-hop link with a MIMO relay and investigates mitigation techniques against the inherent loop-interference. Spatial-domain suppression schemes are developed for the optimization of full-duplex MIMO relaying in a coverage extension scenario on downlink. The proposed methods are demonstrated to generate data rates that closely approximate their global bounds

Full-Duplex Wireless for 6G: Progress Brings New Opportunities and Challenges

The use of in-band full-duplex (FD) enables nodes to simultaneously transmit and receive on the same frequency band, which challenges the traditional assumption in wireless network design. The full-duplex capability enhances spectral efficiency and decreases latency, which are two key drivers pushing the performance expectations of next-generation mobile networks. In less than ten years, in-band FD has advanced from being demonstrated in research labs to being implemented in standards and products, presenting new opportunities to utilize its foundational concepts. Some of the most significant opportunities include using FD to enable wireless networks to sense the physical environment, integrate sensing and communication applications, develop integrated access and backhaul solutions, and work with smart signal propagation environments powered by reconfigurable intelligent surfaces. However, these new opportunities also come with new challenges for large-scale commercial deployment of FD technology, such as managing self-interference, combating cross-link interference in multi-cell networks, and coexistence of dynamic time division duplex, subband FD and FD networks.Comment: 21 pages, 15 figures, accepted to an IEEE Journa

System capacity enhancement for 5G network and beyond

A thesis submitted to the University of Bedfordshire, in fulfilment of the requirements for the degree of Doctor of PhilosophyThe demand for wireless digital data is dramatically increasing year over year. Wireless communication systems like Laptops, Smart phones, Tablets, Smart watch, Virtual Reality devices and so on are becoming an important part of people’s daily life. The number of mobile devices is increasing at a very fast speed as well as the requirements for mobile devices such as super high-resolution image/video, fast download speed, very short latency and high reliability, which raise challenges to the existing wireless communication networks. Unlike the previous four generation communication networks, the fifth-generation (5G) wireless communication network includes many technologies such as millimetre-wave communication, massive multiple-input multiple-output (MIMO), visual light communication (VLC), heterogeneous network (HetNet) and so forth. Although 5G has not been standardised yet, these above technologies have been studied in both academia and industry and the goal of the research is to enhance and improve the system capacity for 5G networks and beyond by studying some key problems and providing some effective solutions existing in the above technologies from system implementation and hardware impairments’ perspective. The key problems studied in this thesis include interference cancellation in HetNet, impairments calibration for massive MIMO, channel state estimation for VLC, and low latency parallel Turbo decoding technique. Firstly, inter-cell interference in HetNet is studied and a cell specific reference signal (CRS) interference cancellation method is proposed to mitigate the performance degrade in enhanced inter-cell interference coordination (eICIC). This method takes carrier frequency offset (CFO) and timing offset (TO) of the user’s received signal into account. By reconstructing the interfering signal and cancelling it afterwards, the capacity of HetNet is enhanced. Secondly, for massive MIMO systems, the radio frequency (RF) impairments of the hardware will degrade the beamforming performance. When operated in time duplex division (TDD) mode, a massive MIMO system relies on the reciprocity of the channel which can be broken by the transmitter and receiver RF impairments. Impairments calibration has been studied and a closed-loop reciprocity calibration method is proposed in this thesis. A test device (TD) is introduced in this calibration method that can estimate the transmitters’ impairments over-the-air and feed the results back to the base station via the Internet. The uplink pilots sent by the TD can assist the BS receivers’ impairment estimation. With both the uplink and downlink impairments estimates, the reciprocity calibration coefficients can be obtained. By computer simulation and lab experiment, the performance of the proposed method is evaluated. Channel coding is an essential part of a wireless communication system which helps fight with noise and get correct information delivery. Turbo codes is one of the most reliable codes that has been used in many standards such as WiMAX and LTE. However, the decoding process of turbo codes is time-consuming and the decoding latency should be improved to meet the requirement of the future network. A reverse interleave address generator is proposed that can reduce the decoding time and a low latency parallel turbo decoder has been implemented on a FPGA platform. The simulation and experiment results prove the effectiveness of the address generator and show that there is a trade-off between latency and throughput with a limited hardware resource. Apart from the above contributions, this thesis also investigated multi-user precoding for MIMO VLC systems. As a green and secure technology, VLC is achieving more and more attention and could become a part of 5G network especially for indoor communication. For indoor scenario, the MIMO VLC channel could be easily ill-conditioned. Hence, it is important to study the impact of the channel state to the precoding performance. A channel state estimation method is proposed based on the signal to interference noise ratio (SINR) of the users’ received signal. Simulation results show that it can enhance the capacity of the indoor MIMO VLC system