Towards the identification of spatially resolved mechanical properties in tissues and materials: State of the art, current challenges and opportunities in the field of flow measurements

This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the Process Intensification Network, the Institution of Mechanical Engineers, the Heat Transfer Society, HEXAG - the Heat Exchange Action Group, and the Energy Institute, ASME Press, LCN London Centre for Nanotechnology, UCL University College London, UCL Engineering, the International NanoScience Community, www.nanopaprika.eu.This work is focused on optical methods that provide tomographic reconstructions of the structure of materials and tissues. Phase information can also be used to measure 3-D displacement and strain fields with interferometric sensitivity. Different approaches are presented, including recent developments in phase contrast wavelength scanning interferometry and a combination of optical coherence tomography and digital volume correlation to estimate elastic properties of synthetic phantoms and porcine corneas. Inversion algorithms based on finite elements and the Virtual Fields Method (VFM) are used to extract mechanical properties from the knowledge of the applied loads, geometry and measured deformation fields. Current efforts into extending these methods into single shot techniques have the potential of expanding the range of applications to study dynamic events such as micro-flows in engineering and biological systems in which scattering particles are transported in a flow, e.g. tribology, microfluidic devices, cell migration or multiphase flows

Investigation of ducts as a “radar pinhole” for detecting objects through a wall

There is a continuing interest in the through-the-wall capabilities of radar. It has been found that walls behave as a low-pass medium, and therefore through-the-wall radar has been restricted to frequencies in the low GHz range. Unfortunately at these lower frequencies the resolution of the radar system is sacrificed. This thesis investigates the possibility of using a duct as a means of detecting objects through a wall. Ducts have been extensively studied in the past; however there has been limited research of ducts with two open ends. In this thesis the difference between an open-ended duct and a duct with two open ends is investigated through measurement and simulation. For simulation an approximate method is used that treats the duct as a waveguide. It is found that a significant amount of power is transmitted through a duct with two open ends. It is then shown that an object can be detected through a wall by using a duct that has been inserted into the wall. Then the two-way insertion loss of a duct with two open ends is determined through measurement and simulation. It is shown that a duct behaves as a high-pass medium and can be used as a propagation channel through a wall. The insertion loss due to the duct and the insertion loss through a concrete wall are comparedElectrical and Computer Engineerin

Ray-based calculations of backscatter in laser fusion targets

A 1D, steady-state model for Brillouin and Raman backscatter from an inhomogeneous plasma is presented. The daughter plasma waves are treated in the strong damping limit, and have amplitudes given by the (linear) kinetic response to the ponderomotive drive. Pump depletion, inverse-bremsstrahlung damping, bremsstrahlung emission, Thomson scattering off density fluctuations, and whole-beam focusing are included. The numerical code DEPLETE, which implements this model, is described. The model is compared with traditional linear gain calculations, as well as "plane-wave" simulations with the paraxial propagation code pF3D. Comparisons with Brillouin-scattering experiments at the OMEGA Laser Facility [T. R. Boehly et al., Opt. Commun. 133, p. 495 (1997)] show that laser speckles greatly enhance the reflectivity over the DEPLETE results. An approximate upper bound on this enhancement, motivated by phase conjugation, is given by doubling the DEPLETE coupling coefficient. Analysis with DEPLETE of an ignition design for the National Ignition Facility (NIF) [J. A. Paisner, E. M. Campbell, and W. J. Hogan, Fusion Technol. 26, p. 755 (1994)], with a peak radiation temperature of 285 eV, shows encouragingly low reflectivity. Re-absorption of Raman light is seen to be significant in this design.Comment: 16 pages, 19 figure

Computational polarimetric microwave imaging

We propose a polarimetric microwave imaging technique that exploits recent advances in computational imaging. We utilize a frequency-diverse cavity-backed metasurface, allowing us to demonstrate high-resolution polarimetric imaging using a single transceiver and frequency sweep over the operational microwave bandwidth. The frequency-diverse metasurface imager greatly simplifies the system architecture compared with active arrays and other conventional microwave imaging approaches. We further develop the theoretical framework for computational polarimetric imaging and validate the approach experimentally using a multi-modal leaky cavity. The scalar approximation for the interaction between the radiated waves and the target---often applied in microwave computational imaging schemes---is thus extended to retrieve the susceptibility tensors, and hence providing additional information about the targets. Computational polarimetry has relevance for existing systems in the field that extract polarimetric imagery, and particular for ground observation. A growing number of short-range microwave imaging applications can also notably benefit from computational polarimetry, particularly for imaging objects that are difficult to reconstruct when assuming scalar estimations.Comment: 17 pages, 15 figure

Extraction of chemical information of suspensions using radiative transfer theory to remove multiple scattering effects : application to a model two-component system

An approach for removing multiple light scattering effects using the radiative transfer theory (RTE) in order to improve the performance of multivariate calibration models is proposed. This approach is then applied to the problem of building calibration models for predicting the concentration of a scattering (particulate) component. Application of this approach to a simulated four component system showed that it will lead to calibration models which perform appreciably better than when empirically scatter corrected measurements of diffuse transmittance (Td) or reflectance (Rd) are used. The validity of the method was also tested experimentally using a two-component (Polystyrene-water) system. While the proposed method led to a model that performed better than that built using Rd, its performance was worse compared to when Td measurements were used. Analysis indicates that this is because the model built using Td benefits from the strong secondary correlation between particle concentration and pathlength travelled by the photons which occurs due to the system containing only two components. On the other hand, the model arising from the proposed methodology uses essentially only the chemical (polystyrene) signal. Thus this approach can be expected to work better in multi-component systems where the pathlength correlation would not exist

What is the true charge transfer gap in parent insulating cuprates?

A large body of experimental data point towards a charge transfer instability of parent insulating cuprates to be their unique property. We argue that the true charge transfer gap in these compounds is as small as 0.4-0.5\,eV rather than 1.5-2.0\,eV as usually derived from the optical gap measurements. In fact we deal with a competition of the conventional (3d$^9$) ground state and a charge transfer (CT) state with formation of electron-hole dimers which evolves under doping to an unconventional bosonic system. Our conjecture does provide an unified standpoint on the main experimental findings for parent cuprates including linear and nonlinear optical, Raman, photoemission, photoabsorption, and transport properties anyhow related with the CT excitations. In addition we suggest a scenario for the evolution of the CuO$_2$ planes in the CT unstable cuprates under a nonisovalent doping.Comment: 13 pages, 5 figures, submitted to PR

Expression of Interest: The Atmospheric Neutrino Neutron Interaction Experiment (ANNIE)

Submitted for the January 2014 Fermilab Physics Advisory Committee meetingSubmitted for the January 2014 Fermilab Physics Advisory Committee meetingSubmitted for the January 2014 Fermilab Physics Advisory Committee meetingSubmitted for the January 2014 Fermilab Physics Advisory Committee meetingNeutron tagging in Gadolinium-doped water may play a significant role in reducing backgrounds from atmospheric neutrinos in next generation proton-decay searches using megaton-scale Water Cherenkov detectors. Similar techniques might also be useful in the detection of supernova neutrinos. Accurate determination of neutron tagging efficiencies will require a detailed understanding of the number of neutrons produced by neutrino interactions in water as a function of momentum transferred. We propose the Atmospheric Neutrino Neutron Interaction Experiment (ANNIE), designed to measure the neutron yield of atmospheric neutrino interactions in gadolinium-doped water. An innovative aspect of the ANNIE design is the use of precision timing to localize interaction vertices in the small fiducial volume of the detector. We propose to achieve this by using early production of LAPPDs (Large Area Picosecond Photodetectors). This experiment will be a first application of these devices demonstrating their feasibility for Water Cherenkov neutrino detectors

Expression of Interest: The Atmospheric Neutrino Neutron Interaction Experiment (ANNIE)

Neutron tagging in Gadolinium-doped water may play a significant role in reducing backgrounds from atmospheric neutrinos in next generation proton-decay searches using megaton-scale Water Cherenkov detectors. Similar techniques might also be useful in the detection of supernova neutrinos. Accurate determination of neutron tagging efficiencies will require a detailed understanding of the number of neutrons produced by neutrino interactions in water as a function of momentum transferred. We propose the Atmospheric Neutrino Neutron Interaction Experiment (ANNIE), designed to measure the neutron yield of atmospheric neutrino interactions in gadolinium-doped water. An innovative aspect of the ANNIE design is the use of precision timing to localize interaction vertices in the small fiducial volume of the detector. We propose to achieve this by using early production of LAPPDs (Large Area Picosecond Photodetectors). This experiment will be a first application of these devices demonstrating their feasibility for Water Cherenkov neutrino detectors.Comment: Submitted for the January 2014 Fermilab Physics Advisory Committee meetin