Programmable H.263-Based Wireless Video Tranceivers for Interference-Limited Environments

In order to exploit the non-uniformly distributed channel capacity over the cell area, the intelligent 7.3 kBaud programmable videophone transceiver of Table I is proposed, which is capable of exploiting the higher channel capacity of uninterfered, high channel-quality cell areas, while supporting more robust, but lower bitrate operation in more interfered areas. The system employed an enhanced H.263-compatible video codec. Since most existing wireless systems exhibit a constant bitrate, the video codec's bitrate fluctuation was smoothed by a novel adaptive packetisation algorithm, which is capable of supporting Automatic Repeat Request (ARQ) assisted operation in wireless distributive video transmissions, although in the proposed low-latency interactive videophone transceiver we refrained from using ARQ. Instead, corrupted packets are dropped by both the local and remote decoders, in order to prevent error propagation. The minimum required channel signal to interference-plus-noise ratio (SINR) was in the range of 8-28 dB for the various transmission scenarios of Table I, while the corresponding video peak signal-to-noise ratio (PSNR) was in the range of 32-39 dB. The main system features are summarised in Table I. Index Terms - H.263-based video communications, interactive wireless video, QAM-based video transmission, video communications in interference-limited environments, video tranceivers

Error resilient video transcoding for robust inter-network communications using GPRS

A novel fully comprehensive mobile video communications system is proposed in this paper. This system exploits the useful rate management features of the video transcoders and combines them with error resilience for transmissions of coded video streams over general packet radio service (GPRS) mobileaccess networks. The error-resilient video transcoding operation takes place at a centralized point, referred to as a video proxy, which provides the necessary output transmission rates with the required amount of robustness. With the use of this proposed algorithm, error resilience can be added to an already compressed video stream at an intermediate stage at the edge of two or more different networks through two resilience schemes, namely the adaptive intra refresh (AIR) and feedback control signaling (FCS) methods. Both resilience tools impose an output rate increase which can also be prevented with the proposed novel technique in this paper. Thus, an error-resilient video transcoding scheme is presented to give robust video outputs at near target transmission rates that only require the same number of GPRS timeslots as the nonresilient schemes. Moreover, an ultimate robustness is also accomplished with the combination of the two resilience algorithms at the video proxy. Extensive computer simulations demonstrate the effectiveness of the proposed system

Cellular Underwater Wireless Optical CDMA Network: Potentials and Challenges

Underwater wireless optical communications is an emerging solution to the expanding demand for broadband links in oceans and seas. In this paper, a cellular underwater wireless optical code division multiple-access (UW-OCDMA) network is proposed to provide broadband links for commercial and military applications. The optical orthogonal codes (OOC) are employed as signature codes of underwater mobile users. Fundamental key aspects of the network such as its backhaul architecture, its potential applications and its design challenges are presented. In particular, the proposed network is used as infrastructure of centralized, decentralized and relay-assisted underwater sensor networks for high-speed real-time monitoring. Furthermore, a promising underwater localization and positioning scheme based on this cellular network is presented. Finally, probable design challenges such as cell edge coverage, blockage avoidance, power control and increasing the network capacity are addressed.Comment: 11 pages, 10 figure

ISDN at NASA Lewis Research Center

An expository investigation of the potential impact of the Integrated Services Digital Network (ISDN) at NASA Lewis Research Center is described. To properly frame the subject, the paper contains a detailed survey of the components of Narrowband ISDN. The principles and objectives are presented as decreed by the Consultative Committee for International Telephone and Telegraph (CCITT). The various channel types are delineated and their associated service combinations are described. The subscriber-access network functions are explained pictorially via the ISDN reference configuration. A section on switching techniques is presented to enable the reader to understand the emergence of the concept of fast packet switching. This new technology is designed to operate over the high bandwidth, low error rate transmission media that characterizes the LeRC environment. A brief introduction to the next generation of networks is covered with sections on Broadband ISDM (B-ISDN), Asynchronous Transfer Mode (ATM), and Synchronous Optical Networks (SONET). Applications at LeRC are presented, first in terms of targets of opportunity, then in light of compatibility constraints. In-place pilot projects and testing are described that demonstrate actual usage at LeRC

Wireless industrial monitoring and control networks: the journey so far and the road ahead

While traditional wired communication technologies have played a crucial role in industrial monitoring and control networks over the past few decades, they are increasingly proving to be inadequate to meet the highly dynamic and stringent demands of today’s industrial applications, primarily due to the very rigid nature of wired infrastructures. Wireless technology, however, through its increased pervasiveness, has the potential to revolutionize the industry, not only by mitigating the problems faced by wired solutions, but also by introducing a completely new class of applications. While present day wireless technologies made some preliminary inroads in the monitoring domain, they still have severe limitations especially when real-time, reliable distributed control operations are concerned. This article provides the reader with an overview of existing wireless technologies commonly used in the monitoring and control industry. It highlights the pros and cons of each technology and assesses the degree to which each technology is able to meet the stringent demands of industrial monitoring and control networks. Additionally, it summarizes mechanisms proposed by academia, especially serving critical applications by addressing the real-time and reliability requirements of industrial process automation. The article also describes certain key research problems from the physical layer communication for sensor networks and the wireless networking perspective that have yet to be addressed to allow the successful use of wireless technologies in industrial monitoring and control networks

Will SDN be part of 5G?

For many, this is no longer a valid question and the case is considered settled with SDN/NFV (Software Defined Networking/Network Function Virtualization) providing the inevitable innovation enablers solving many outstanding management issues regarding 5G. However, given the monumental task of softwarization of radio access network (RAN) while 5G is just around the corner and some companies have started unveiling their 5G equipment already, the concern is very realistic that we may only see some point solutions involving SDN technology instead of a fully SDN-enabled RAN. This survey paper identifies all important obstacles in the way and looks at the state of the art of the relevant solutions. This survey is different from the previous surveys on SDN-based RAN as it focuses on the salient problems and discusses solutions proposed within and outside SDN literature. Our main focus is on fronthaul, backward compatibility, supposedly disruptive nature of SDN deployment, business cases and monetization of SDN related upgrades, latency of general purpose processors (GPP), and additional security vulnerabilities, softwarization brings along to the RAN. We have also provided a summary of the architectural developments in SDN-based RAN landscape as not all work can be covered under the focused issues. This paper provides a comprehensive survey on the state of the art of SDN-based RAN and clearly points out the gaps in the technology.Comment: 33 pages, 10 figure

Applications of satellite technology to broadband ISDN networks

Two satellite architectures for delivering broadband integrated services digital network (B-ISDN) service are evaluated. The first is assumed integral to an existing terrestrial network, and provides complementary services such as interconnects to remote nodes as well as high-rate multicast and broadcast service. The interconnects are at a 155 Mbs rate and are shown as being met with a nonregenerative multibeam satellite having 10-1.5 degree spots. The second satellite architecture focuses on providing private B-ISDN networks as well as acting as a gateway to the public network. This is conceived as being provided by a regenerative multibeam satellite with on-board ATM (asynchronous transfer mode) processing payload. With up to 800 Mbs offered, higher satellite EIRP is required. This is accomplished with 12-0.4 degree hopping beams, covering a total of 110 dwell positions. It is estimated the space segment capital cost for architecture one would be about $190M whereas the second architecture would be about$250M. The net user cost is given for a variety of scenarios, but the cost for 155 Mbs services is shown to be about $15-22/minute for 25 percent system utilization