Advanced communications technology satellite high burst rate link evaluation terminal communication protocol software user's guide, version 1.0

The Communication Protocol Software was developed at the NASA Lewis Research Center to support the Advanced Communications Technology Satellite High Burst Rate Link Evaluation Terminal (ACTS HBR-LET). The HBR-LET is an experimenters terminal to communicate with the ACTS for various experiments by government, university, and industry agencies. The Communication Protocol Software is one segment of the Control and Performance Monitor (C&PM) Software system of the HBR-LET. The Communication Protocol Software allows users to control and configure the Intermediate Frequency Switch Matrix (IFSM) on board the ACTS to yield a desired path through the spacecraft payload. Besides IFSM control, the C&PM Software System is also responsible for instrument control during HBR-LET experiments, uplink power control of the HBR-LET to demonstrate power augmentation during signal fade events, and data display. The Communication Protocol Software User's Guide, Version 1.0 (NASA CR-189162) outlines the commands and procedures to install and operate the Communication Protocol Software. Configuration files used to control the IFSM, operator commands, and error recovery procedures are discussed. The Communication Protocol Software Maintenance Manual, Version 1.0 (NASA CR-189163, to be published) is a programmer's guide to the Communication Protocol Software. This manual details the current implementation of the software from a technical perspective. Included is an overview of the Communication Protocol Software, computer algorithms, format representations, and computer hardware configuration. The Communication Protocol Software Test Plan (NASA CR-189164, to be published) provides a step-by-step procedure to verify the operation of the software. Included in the Test Plan is command transmission, telemetry reception, error detection, and error recovery procedures

Design study for LANDSAT-D attitude control system

The gimballed Ku-band antenna system for communication with TDRS was studied. By means of an error analysis it was demonstrated that the antenna cannot be open loop pointed to TDRS by an onboard programmer, but that an autotrack system was required. After some tradeoffs, a two-axis, azimuth-elevation type gimbal configuration was recommended for the antenna. It is shown that gimbal lock only occurs when LANDSAT-D is over water where a temporary loss of the communication link to TDRS is of no consequence. A preliminary gimbal control system design is also presented. A digital computer program was written that computes antenna gimbal angle profiles, assesses percent antenna beam interference with the solar array, and determines whether the spacecraft is over land or water, a lighted earth or a dark earth, and whether the spacecraft is in eclipse

DIGITAL CONTROL BOARD FOR PHASED ARRAY ANTENNA BEAM STEERING IN ADAPTIVE COMMUNICATION APPLICATIONS

The application of adaptive communication techniques for mobile communications has attracted considerable interest in the last decade. One example of these techniques is spatial filtering through planar antenna array beam forming. This thesis describes the development of a digital system that adaptively controls a phased array antenna. The radiating structure of the phased antenna array is tetrahedral-shaped and contains four antenna elements on each of its three faces. The overall system comprises of a digital control board with an external computer interface, an RF control board, and the phased antenna array. The RF controls the main lobe direction on the phased array antenna. This thesis describes the design and implementation of the digital control board. The digital control board`s primary responsibilities are implementing inter- faces between the external computer and the RF board, which results in two operational modes: the MATLAB graphical user interface (GUI) mode and the adaptive receive mode. The GUI mode allows users to input parameters that provide interactive control of the phased antenna array by interfacing with an external computer and the RF control board. The adaptive receive mode im- plements an algorithm for an adaptive receive station. This algorithm uses a 58-point scanning technique that locates the maximum receive power direction. Test results show that the digital control board successfully manages the RF board control voltage with an nominal error of less than 1%, which subsequently allows for precise control of the antenna`s active face. Additionally, testing of the GUI demonstrated the successful interactive application of various system control parameters