640 research outputs found
Demand response from the control of aggregated inverter air conditioners
Inverter air conditioners (ACs) account for a large proportion of air conditioning loads in many countries and, thus, contribute significantly to the peak loads in these areas, especially in summer. On the other hand, as an important category of thermostatically controlled load with thermal energy storage capability, inverter ACs also have the potential to provide considerable flexibility for electric power systems that are faced with increasing challenges posed by high penetration of renewable power generation. This paper focuses on the demand response from the control of the aggregated inverter ACs for load reduction. A virtual energy storage system (VESS) model that encapsulates the room with an inverter AC was established based on the electric model of an inverter AC and the thermodynamic model of a room. Based on the VESS model, a virtual state of charge (VSOC) priority-based load reduction control method with temperature holding and linear recovery strategies was proposed. The VSOC priority based control was designed to decrease the negative impact of load reduction on customers’ thermal comfort from the perspective of the whole AC population. The temperature holding strategy was designed to reduce the electric power of an AC while ensuring that the indoor temperature is always below the allowable limit. The linear recover strategy was proposed to reduce the load rebound after load reduction. Four cases were studied regarding the operation and load reduction of the 100 inverter ACs, and the simulation results verified the models established and the effectiveness and advantages of the proposed load reduction control method
Distributed photovoltaic systems: Utility interface issues and their present status
Major technical issues involving the integration of distributed photovoltaics (PV) into electric utility systems are defined and their impacts are described quantitatively. An extensive literature search, interviews, and analysis yielded information about the work in progress and highlighted problem areas in which additional work and research are needed. The findings from the literature search were used to determine whether satisfactory solutions to the problems exist or whether satisfactory approaches to a solution are underway. It was discovered that very few standards, specifications, or guidelines currently exist that will aid industry in integrating PV into the utility system. Specific areas of concern identified are: (1) protection, (2) stability, (3) system unbalance, (4) voltage regulation and reactive power requirements, (5) harmonics, (6) utility operations, (7) safety, (8) metering, and (9) distribution system planning and design
Distributed photovoltaic systems: Utility interface issues and their present status. Intermediate/three-phase systems
The interface issues between the intermediate-size Power Conditioning Subsystem (PCS) and the utility are considered. A literature review yielded facts about the status of identified issues
Power quality and electromagnetic compatibility: special report, session 2
The scope of Session 2 (S2) has been defined as follows by the Session Advisory Group and the Technical Committee: Power Quality (PQ), with the more general concept of electromagnetic compatibility (EMC) and with some related safety problems in electricity distribution systems.
Special focus is put on voltage continuity (supply reliability, problem of outages) and voltage quality (voltage level, flicker, unbalance, harmonics). This session will also look at electromagnetic compatibility (mains frequency to 150 kHz), electromagnetic interferences and electric and magnetic fields issues. Also addressed in this session are electrical safety and immunity concerns (lightning issues, step, touch and transferred voltages).
The aim of this special report is to present a synthesis of the present concerns in PQ&EMC, based on all selected papers of session 2 and related papers from other sessions, (152 papers in total). The report is divided in the following 4 blocks:
Block 1: Electric and Magnetic Fields, EMC, Earthing systems
Block 2: Harmonics
Block 3: Voltage Variation
Block 4: Power Quality Monitoring
Two Round Tables will be organised:
- Power quality and EMC in the Future Grid (CIGRE/CIRED WG C4.24, RT 13)
- Reliability Benchmarking - why we should do it? What should be done in future? (RT 15
Recommended from our members
An Assessment of PIER Electric Grid Research 2003-2014 White Paper
This white paper describes the circumstances in California around the turn of the 21st century that led the California Energy Commission (CEC) to direct additional Public Interest Energy Research funds to address critical electric grid issues, especially those arising from integrating high penetrations of variable renewable generation with the electric grid. It contains an assessment of the beneficial science and technology advances of the resultant portfolio of electric grid research projects administered under the direction of the CEC by a competitively selected contractor, the University of California’s California Institute for Energy and the Environment, from 2003-2014
The state-of-the-art of dc power distribution systems/components for space applications
This report is a survey of the state of the art of high voltage dc systems and components. This information can be used for consideration of an alternative secondary distribution (120 Vdc) system for the Space Station. All HVdc components have been prototyped or developed for terrestrial, aircraft, and spacecraft applications, and are applicable for general space application with appropriate modification and qualification. HVdc systems offer a safe, reliable, low mass, high efficiency and low EMI alternative for Space Station secondary distribution
Smart Fridge / Dumb Grid? Demand Dispatch for the Power Grid of 2020
In discussions at the 2015 HICSS meeting, it was argued that loads can
provide most of the ancillary services required today and in the future.
Through load-level and grid-level control design, high-quality ancillary
service for the grid is obtained without impacting quality of service delivered
to the consumer. This approach to grid regulation is called demand dispatch:
loads are providing service continuously and automatically, without consumer
interference.
In this paper we ask, what intelligence is required at the grid-level? In
particular, does the grid-operator require more than one-way communication to
the loads? Our main conclusion: risk is not great in lower frequency ranges,
e.g., PJM's RegA or BPA's balancing reserves. In particular, ancillary services
from refrigerators and pool-pumps can be obtained successfully with only
one-way communication. This requires intelligence at the loads, and much less
intelligence at the grid level
- …