64 research outputs found
A review of gallium nitride LEDs for multi-gigabit-per-second visible light data communications
The field of visible light communications (VLC) has gained significant interest over the last decade, in both fibre and free-space embodiments. In fibre systems, the availability of low cost plastic optical fibre (POF) that is compatible with visible data communications has been a key enabler. In free-space applications, the availability of hundreds of THz of the unregulated spectrum makes VLC attractive for wireless communications. This paper provides an overview of the recent developments in VLC systems based on gallium nitride (GaN) light-emitting diodes (LEDs), covering aspects from sources to systems. The state-of-the-art technology enabling bandwidth of GaN LEDs in the range of >400 MHz is explored. Furthermore, advances in key technologies, including advanced modulation, equalisation, and multiplexing that have enabled free-space VLC data rates beyond 10 Gb/s are also outlined
Millimetre-Wave Fibre-Wireless Technologies for 5G Mobile Fronthaul
The unprecedented growth in mobile data traffic, driven primarily by bandwidth rich applications and high definition video is accelerating the development of fifth generation (5G) mobile network. As mobile access network evolves towards centralisation, mobile fronthaul (MFH) architecture becomes essential in providing high capacity, ubiquitous and yet affordable services to subscribers. In order to meet the demand for high data rates in the access, Millimetre-wave (mmWave) has been highlighted as an essential technology in the development of 5G-new radio (5G-NR). In the present MFH architecture which is typically based on common public radio interface (CPRI) protocol, baseband signals are digitised before fibre transmission, featuring high overhead data and stringent synchronisation requirements. A direct application of mmWave 5G-NR to CPRI digital MFH, where signal bandwidth is expected to be up to 1GHz will be challenging, due to the increased complexity of the digitising interface and huge overhead data that will be required for such bandwidth. Alternatively, radio over fibre (RoF) technique can be employed in the transportation of mmWave wireless signals via the MFH link, thereby avoiding the expensive digitisation interface and excessive overhead associated with its implementation. Additionally, mmWave carrier can be realised with the aid of photonic components employed in the RoF link, further reducing the system complexity. However, noise and nonlinearities inherent to analog transmission presents implementation challenges, limiting the system dynamic range. Therefore, it is important to investigate the effects of these impairments in RoF based MFH architecture.
This thesis presents extensive research on the impact of noise and nonlinearities on 5G candidate waveforms, in mmWave 5G fibre wireless MFH. Besides orthogonal frequency division multiplexing (OFDM), another radio access technology (RAT) that has received significant attention is filter bank multicarrier (FBMC), particularly due to its high spectral containment and excellent performance in asynchronous transmission. Hence, FBMC waveform is adopted in this work to study the impact of noise and nonlinearities on the mmWave fibre-wireless MFH architecture. Since OFDM is widely deployed and it has been adopted for 5G-NR, the performance of OFDM and FBMC based 5G mmWave RAT in fibre wireless MFH architecture is compared for several implementations and transmission scenarios.
To this extent, an end to end transmission testbed is designed and implemented using industry standard VPI Transmission Maker® to investigate five mmWave upconversion techniques. Simulation results show that the impact of noise is higher in FBMC when the signal to-noise (SNR) is low, however, FBMC exhibits better performance compared to OFDM as the SNR improved. More importantly, an evaluation of the contribution of each noise component to the overall system SNR is carried out. It is observed in the investigation that noise contribution from the optical carriers employed in the heterodyne upconversion of intermediate frequency (IF) signals to mmWave frequency dominate the system noise. An adaptive modulation technique is employed to optimise the system throughput based on the received SNR. The throughput of FBMC based system reduced significantly compared to OFDM, due to laser phase noise and chromatic dispersion (CD). Additionally, it is shown that by employing frequency domain averaging technique to enhance the channel estimation (CE), the throughput of FBMC is significantly increased and consequently, a comparable performance is obtained for both waveforms.
Furthermore, several coexistence scenarios for multi service transmission are studied, considering OFDM and FBMC based RATs to evaluate the impact inter band interference (IBI), due to power amplifier (PA) nonlinearity on the system performance. The low out of band (OOB) emission in FBMC plays an important role in minimising IBI to adjacent services. Therefore, FBMC requires less guardband in coexistence with multiple services in 5G fibre-wireless MFH. Conversely, OFDM introduced significant OOB to adjacent services requiring large guardband in multi-service coexistence transmission scenario.
Finally, a novel transmission scheme is proposed and investigated to simultaneously generate multiple mmWave signals using laser heterodyning mmWave upconversion technique. With appropriate IF and optical frequency plan, several mmWave signals can be realised. Simulation results demonstrate successful simultaneous realisation of 28GHz, 38GHz, and 60GHz mmWave signals
PAPR reduction in multicarrier modulation techniques based visible light communication systems
Visible light communication (VLC) is an optical wireless communication (OWC) technology that has the potential to provide high data rate transmission for indoor applications.
VLC is a promising alternative technology with a large and unlicensed spectrum to complement the congested radio frequency (RF) based communication in order to meet the exponential growth and popularity of smart devices, data intensive services and applications.
The use of low-cost commercially available front-end devices further highlights the attraction of VLC system. However, nonlinear dynamic range of front-end devices and optical channel impairments limit full exploitation of VLC available modulation bandwidth. To fully benefit from the inherent resources and mitigate these limitations, multicarrier modulation (MCM) techniques are adopted. However, these techniques are affected by high peak-to-average power ratio (PAPR) which imposes constraints on the limited dynamic range of the front-end devices and the average radiated optical power. The main focus throughout this thesis is to reduce the high PAPR of MCM modulation techniques-based VLC system by implementing pilot-assisted (PA) technique. Additionally, performance of PAPR reduced modulation techniques is investigated through analytical, simulation, and experimentally.
This thesis first presents background of VLC system principles including the front-end devices, VLC channel, system impairments and challenges, and employed solutions. The principles, limitations, and performance of MCM modulation variants that are implemented in this work are presented. Moreover, principles of PAPR challenge in MCM based VLC, PAPR evaluation, impact on the transmitted signal as well as the existing PAPR reduction techniques are discussed. Looking at the gap, a PA is implemented as PAPR reduction technique which is presented in this work including its implementation and performance.
Following that, multiple experimental studies on PAPR reduction of PA technique are presented. Two experimental demonstrations on the efficacy of PA PAPR reduction for PAM-DMT and DCO-OFDM based VLC using a single blue LED are presented. These studies are comparing the bit-error-rate (BER) performance of the proposed systems with conventional counterparts over a range of sampling rate. This shows that, the proposed systems perform better than conventional systems without PAPR reduction. The results are validated through simulation. Other two experimental studies on the previous systems with parameters optimisation and available modulation bandwidth utilisation are presented, which show that the proposed systems outperform the conventional systems in terms of BER. This is followed by investigating the PA PAPR reduction effect on the achievable data rate of a wavelength division multiplexing (WDM) based VLC system using three different LEDs for PAPR reduced DCO-OFDM and PAM-DMT systems. The proposed systems have achieved more than 8% data rate higher than that of conventional systems without BER performance degradation.
Finally, analytical investigation of clipping noise that leads to distortion in a VLC system due to front-end devices limitations is presented. To mitigate the clipping noise, PAPR of the system is reduced by the PA technique. The analytical BER performance of the system with PAPR reduction is verified through simulation and then compared to that of the conventional system without PAPR reduction at similar clipping levels. The PA proposed system shows better BER performance at all clipping levels
Digital signal processing techniques for peak-to-average power ratio mitigation in MIMO–OFDM systems
The focus of this thesis is to mitigate the very large peak-to-average
transmit power ratios (PAPRs) inherent to conventional orthogonal
frequency division multiplexing (OFDM) systems, particularly in the
context of transmission over multi-input multi-output (MIMO) wireless
broadband channels. This problem is important as a large PAPR
generally needs an expensive radio frequency (RF) power amplifier at
the transmitter due to the requirement for linear operation over a wide
amplitude range and such a cost would be compounded when multiple
transmit antennas are used. Advanced signal processing techniques
which can reduce PAPR whilst retain the integrity of digital transmission
therefore have considerable potential for application in emergent
MIMO–OFDM wireless systems and form the technical contributions
of this study. [Continues.
High speed energy efficient incoherent optical wireless communications
The growing demand for wireless communication capacity and the overutilisation of the conventional
radio frequency (RF) spectrum have inspired research into using alternative spectrum
regions for communication. Using optical wireless communications (OWC), for example, offers
significant advantages over RF communication in terms of higher bandwidth, lower implementation
costs and energy savings. In OWC systems, the information signal has to be
real and non-negative. Therefore, modifications to the conventional communication algorithms
are required. Multicarrier modulation schemes like orthogonal frequency division multiplexing
(OFDM) promise to deliver a more efficient use of the communication capacity through adaptive
bit and energy loading techniques. Three OFDM-based schemes – direct-current-biased OFDM
(DCO-OFDM), asymmetrically clipped optical OFDM(ACO-OFDM), and pulse-amplitude modulated
discrete multitone (PAM-DMT) – have been introduced in the literature.
The current work investigates the recently introduced scheme subcarrier-index modulation OFDM
as a potential energy-efficient modulation technique with reduced peak-to-average power ratio
(PAPR) suitable for applications in OWC. A theoretical model for the analysis of SIM-OFDMin a
linear additive white Gaussian noise (AWGN) channel is provided. A closed-form solution for the
PAPR in SIM-OFDM is also proposed. Following the work on SIM-OFDM, a novel inherently
unipolar modulation scheme, unipolar orthogonal frequency division multiplexing (U-OFDM), is
proposed as an alternative to the existing similar schemes: ACO-OFDMand PAM-DMT. Furthermore,
an enhanced U-OFDMsignal generation algorithm is introduced which allows the spectral
efficiency gap between the inherently unipolar modulation schemes – U-OFDM, ACO-OFDM,
PAM-DMT – and the conventionally used DCO-OFDM to be closed. This results in an OFDM-based
modulation approach which is electrically and optically more efficient than any other
OFDM-based technique proposed so far for intensity modulation and direct detection (IM/DD)
communication systems.
Non-linear distortion in the optical front-end elements is one of the major limitations for high-speed
communication in OWC. This work presents a generalised approach for analysing nonlinear
distortion in OFDM-based modulation schemes. The presented technique leads to a closed-form
analytical solution for an arbitrary memoryless distortion of the information signal and has
been proven to work for the majority of the known unipolar OFDM-based modulation techniques
- DCO-OFDM, ACO-OFDM, PAM-DMT and U-OFDM.
The high-speed communication capabilities of novel Gallium Nitride based μm-sized light emitting
diodes (μLEDs) are investigated, and a record-setting result of 3.5Gb/s using a single 50-μm
device is demonstrated. The capabilities of using such devices at practical transmission distances
are also investigated, and a 1 Gb/s link using a single device is demonstrated at a distance of up
to 10m. Furthermore, a proof-of-concept experiment is realised where a 50-μm LED is successfully
modulated using U-OFDM and enhanced U-OFDM to achieve notable energy savings in
comparison to DCO-OFDM
Physical Layer Techniques for Indoor Wireless Visible Light Communications
The growing demand for bandwidth-hungry applications and increasing number of smart interconnected devices has increased the data traffic on radio access networks. Subsequently, the saturating spectral efficiencies in crowded radio frequency spectrum has impelled the researchers to exploit the optical spectrum for communications. In particular, many developments in the visible light communication (VLC) as a combined lighting and communications system have taken place.
Despite abundant optical bandwidth, the data transmission rates and power efficiencies in VLC are partly limited by the electrical channel bandwidth and the type of signalling sets which can be used in this intensity modulated, direct detected system. In order to improve the power and spectral efficiencies, this thesis focuses on physical layer (PHY) techniques. The state-of-the-art single channel modulations (SCM) based on M-PAM, multi-channel modulations (MCM) based on OFDM, and IEEE standardised multi-colour modulations are investigated comprehensively through simulations and theoretical analysis, over representative VLC channels considering the optical properties of front-end devices.
The bit error performances and spectral efficiencies of DC-biased and non DC-biased MCM systems are compared. A new vector coding based MCM is proposed to optimally utilise the channel state information at the transmitter as an alternative to optical OFDM. The throughputs, peak-to-average power ratios and DC-bias requirements of SCM and MCM systems are investigated which show that the lower DC-bias requirements reduce power consumed for the same throughput in SCM systems when compared to MCM systems. A new quad-chromatic colour shift keying (CSK) system is proposed which reduces power requirements and complexity, enhances throughput and realises a four-dimensional signalling to outperform the IEEE standardised tri-chromatic CSK system.
For improved power efficiency and throughput of VLC PHY, use of rate-adaptive binary convolutional coding and Viterbi decoding is proposed along with frequency domain channel equalisation to mitigate temporal dispersion over representative VLC channels
PAPR Reduction in Multicarrier Communication Systems Using Efficient Pulse Shaping Technique
Emerging multicarrier modulation schemes have been considered for the fifth generation (5G) communication systems. However, existing designs often suffer from a high peak-to-average power ratio (PAPR) in the transmitted signal. This thesis aims to (i) design pulse shaping filters to reduce the PAPR using computationally efficient optimisation approach (ii) investigate the performance of the multicarrier systems employing the designed filter and (iii) study the power utilisation efficiency of the nonlinear amplifier with the use of the designed filters
- …