Energy-Efficient User Access Control and Resource Allocation in HCNs with Non-Ideal Circuitry

In this paper, we study the energy-efficient user access control (UAC) based on resource allocation (RA) in heterogeneous cellular networks (HCNs) with the required downlink data rate under non-ideal power amplifiers (PAs) and circuit power. It is proved that the energy consumption minimization is achieved when the typical user accesses only one base station (BS), while the other BSs remain in idle mode on the transmission resource allocated to this user. For this purpose, we reformulate the original non-convex optimization problem into a series of convex optimization problems where, in each case, the transmit power and duration of the accessed BS are determined. Then, the BS with the minimal energy consumption is selected for transmission. Considering the approximate situation, it is showed that the optimal transmit duration of the accessed BS can be estimated in closed form. The benefits of our proposed UAC and RA schemes are validated using numerical simulations, which also characterize the effect that non-ideal PAs have on the total energy consumption of different transmission schemes.Comment: 6 pages, 4 figures, 2017 9th International Conference on Wireless Communications and Signal Processing (WCSP

Wireless Power Transfer and Data Collection in Wireless Sensor Networks

In a rechargeable wireless sensor network, the data packets are generated by sensor nodes at a specific data rate, and transmitted to a base station. Moreover, the base station transfers power to the nodes by using Wireless Power Transfer (WPT) to extend their battery life. However, inadequately scheduling WPT and data collection causes some of the nodes to drain their battery and have their data buffer overflow, while the other nodes waste their harvested energy, which is more than they need to transmit their packets. In this paper, we investigate a novel optimal scheduling strategy, called EHMDP, aiming to minimize data packet loss from a network of sensor nodes in terms of the nodes' energy consumption and data queue state information. The scheduling problem is first formulated by a centralized MDP model, assuming that the complete states of each node are well known by the base station. This presents the upper bound of the data that can be collected in a rechargeable wireless sensor network. Next, we relax the assumption of the availability of full state information so that the data transmission and WPT can be semi-decentralized. The simulation results show that, in terms of network throughput and packet loss rate, the proposed algorithm significantly improves the network performance.Comment: 30 pages, 8 figures, accepted to IEEE Transactions on Vehicular Technolog

Massive MIMO for Full-Duplex Cellular Two-Way Relay Network: A Spectral Efficiency Study

© 2017 IEEE. This paper presents the new analysis of the applications of massive multiple-input-multiple-output (MIMO) in full-duplex (FD) cellular two-way relay networks, and sheds valuable insights on the interactions between massive MIMO, and relay and duplex modes. Practical scenarios are considered, where massive MIMO is deployed at the base station and the relay station. Based on generic relay modes, namely, antenna-selection-based decode-and-forward (DF) relay and signal-space alignment based amplify-and-forward (AF) relay, closed-form expressions for the asymptotic signal-to-interference-plus-noise ratios (SINRs) are derived. The difference between AF and DF in the FD mode is quantified, and so is that between FD and half-duplex (HD) under the two relay modes. With massive MIMO, the superiority of DF in the FD mode is confirmed in terms of spectral efficiency. The sufficient conditions for the FD mode to outperform the HD mode are identified. The effectiveness of massive MIMO in terms of self-loop interference cancellation and inter-user interference suppression is proved. All these insightful findings are corroborated by simulations

Reliability performance analysis of half-duplex and full-duplex schemes with self-energy recycling

Abstract. Radio frequency energy harvesting (EH) has emerged as a promising option for improving the energy efficiency of current and future networks. Self-energy recycling (sER), as a variant of EH, has also appeared as a suitable alternative that allows to reuse part of the transmitted energy via an energy loop. In this work we study the benefits of using sER in terms of reliability improvements and compare the performance of full-duplex (FD) and half-duplex (HD) schemes when using multi-antenna techniques at the base station side. We also assume a model for the hardware energy consumption, making the analysis more realistic since most works only consider the energy spent on transmission. In addition to spectral efficiency enhancements, results show that FD performs better than HD in terms of reliability. We maximize the outage probability of the worst link in the network using a dynamic FD scheme where a small base station (SBS) determines the optimal number of antennas for transmission and reception. This scheme proves to be more efficient than classical HD and FD modes. Results show that the use of sER at the SBS introduces changes on the distribution of antennas for maximum fairness when compared to the setup without sER. Moreover, we determine the minimum number of active radio frequency chains required at the SBS in order to achieve a given reliability target

Integrated Data and Energy Communication Network: A Comprehensive Survey

OAPA In order to satisfy the power thirsty of communication devices in the imminent 5G era, wireless charging techniques have attracted much attention both from the academic and industrial communities. Although the inductive coupling and magnetic resonance based charging techniques are indeed capable of supplying energy in a wireless manner, they tend to restrict the freedom of movement. By contrast, RF signals are capable of supplying energy over distances, which are gradually inclining closer to our ultimate goal – charging anytime and anywhere. Furthermore, transmitters capable of emitting RF signals have been widely deployed, such as TV towers, cellular base stations and Wi-Fi access points. This communication infrastructure may indeed be employed also for wireless energy transfer (WET). Therefore, no extra investment in dedicated WET infrastructure is required. However, allowing RF signal based WET may impair the wireless information transfer (WIT) operating in the same spectrum. Hence, it is crucial to coordinate and balance WET and WIT for simultaneous wireless information and power transfer (SWIPT), which evolves to Integrated Data and Energy communication Networks (IDENs). To this end, a ubiquitous IDEN architecture is introduced by summarising its natural heterogeneity and by synthesising a diverse range of integrated WET and WIT scenarios. Then the inherent relationship between WET and WIT is revealed from an information theoretical perspective, which is followed by the critical appraisal of the hardware enabling techniques extracting energy from RF signals. Furthermore, the transceiver design, resource allocation and user scheduling as well as networking aspects are elaborated on. In a nutshell, this treatise can be used as a handbook for researchers and engineers, who are interested in enriching their knowledge base of IDENs and in putting this vision into practice

A Tutorial on Interference Exploitation via Symbol-Level Precoding: Overview, State-of-the-Art and Future Directions

IEEE Interference is traditionally viewed as a performance limiting factor in wireless communication systems, which is to be minimized or mitigated. Nevertheless, a recent line of work has shown that by manipulating the interfering signals such that they add up constructively at the receiver side, known interference can be made beneficial and further improve the system performance in a variety of wireless scenarios, achieved by symbol-level precoding (SLP). This paper aims to provide a tutorial on interference exploitation techniques from the perspective of precoding design in a multi-antenna wireless communication system, by beginning with the classification of constructive interference (CI) and destructive interference (DI). The definition for CI is presented and the corresponding mathematical characterization is formulated for popular modulation types, based on which optimization-based precoding techniques are discussed. In addition, the extension of CI precoding to other application scenarios as well as for hardware efficiency is also described. Proof-of-concept testbeds are demonstrated for the potential practical implementation of CI precoding, and finally a list of open problems and practical challenges are presented to inspire and motivate further research directions in this area