Femtocell Networks: A Survey

The surest way to increase the system capacity of a wireless link is by getting the transmitter and receiver closer to each other, which creates the dual benefits of higher quality links and more spatial reuse. In a network with nomadic users, this inevitably involves deploying more infrastructure, typically in the form of microcells, hotspots, distributed antennas, or relays. A less expensive alternative is the recent concept of femtocells, also called home base-stations, which are data access points installed by home users get better indoor voice and data coverage. In this article, we overview the technical and business arguments for femtocells, and describe the state-of-the-art on each front. We also describe the technical challenges facing femtocell networks, and give some preliminary ideas for how to overcome them.Comment: IEEE Communications Magazine, vol. 46, no.9, pp. 59-67, Sept. 200

LTE-verkon suorituskyvyn parantaminen CDMA2000:sta LTE:hen tehdyn muutoksen jälkeen

CDMA2000 technology has been widely used on 450 MHz band. Recently the equipment availability and improved performance offered by LTE has started driving the operators to migrate their networks from CDMA2000 to LTE. The migration may cause the network performance to be in suboptimal state. This thesis presents four methods to positively influence LTE network performance after CDMA2000 to LTE migration, especially on 450 MHz band. Furthermore, three of the four presented methods are evaluated in a live network. The measured three methods were cyclic prefix length, handover parameter optimization and uplink coordinated multipoint (CoMP) transmission. The objective was to determine the effectiveness of each method. The research methods included field measurements and network KPI collection. The results show that normal cyclic prefix length is enough for LTE450 although the cell radius may be up to 50km. Only special cases exist where cyclic prefix should be extended. Operators should consider solving such problems individually instead of widely implementing extended cyclic prefix. Handover parameter optimization turned out to be an important point of attention after CDMA2000 to LTE migration. It was observed that if the handover parameters are not concerned, significant amount of unnecessary handovers may happen. It was evaluated that about 50% of the handovers in the network were unnecessary in the initial situation. By adjusting the handover parameter values 47,28 % of the handovers per user were removed and no negative effects were detected. Coordinated multipoint transmission has been widely discussed to be an effective way to improve LTE network performance, especially at the cell edges. Many challenges must be overcome before it can be applied to downlink. Also, implementing it to function between cells in different eNBs involve challenges. Thus, only intra-site uplink CoMP transmission was tested. The results show that the performance improvements were significant at the cell edges as theory predicted.CDMA2000 teknologiaa on laajalti käytetty 450 MHz:n taajuusalueella. Viime aikoina LTE:n tarjoamat halvemmat laitteistot ja parempi suorituskyky ovat kannustaneet operaattoreita muuttamaan verkkoaan CDMA2000:sta LTE:hen. Kyseinen muutos saattaa johtaa epäoptimaaliseen tilaan verkon suorituskyvyn kannalta. Tämä työ esittelee neljä menetelmää, joilla voidaan positiivisesti vaikuttaa LTE-verkon suorituskykyyn CDMA2000:ste LTE:hen tehdyn muutoksen jälkeen erityisesti 450 MHz:n taajuusalueella. Kolmea näistä menetelmistä arvioidaan tuotantoverkossa. Nämä kolme menetelmää ovat suojavälin pituus, solunvaihtoparametrien optimointi ja ylälinkin koordinoitu monipistetiedonsiirto. Tavoite oli määrittää kunkin menetelmän vaikutus. Tutkimusmenetelmiin kuului kenttämittaukset ja verkon suorituskykymittareiden analyysi. Tutkimustulosten perusteella voidaan sanoa, että normaali suojaväli on riittävän pitkä LTE450:lle vaikka solujen säde on jopa 50km. Vain erikoistapauksissa tarvitaan pidennettyä suojaväliä. Operaattoreiden tulisi ratkaista tällaiset tapaukset yksilöllisesti sen sijaan, että koko verkossa käytettäisiin pidennettyä suojaväliä. Solunvaihtoparametrien optimointi osoittautui tärkeäksi huomion aiheeksi CDMA2000:sta LTE:hen tehdyn muutoksen jälkeen. Turhia solunvaihtoja saattaa tapahtua merkittäviä määriä, mikäli parametreihin ei kiinnitetä huomiota. Lähtötilanteessa noin 50 % testiverkon solunvaihdoista arvioitiin olevan turhia. Solunvaihtoparametreja muuttamalla 47,28 % solunvaihdoista per käyttäjä saatiin poistettua ilman, että mitään haittavaikutuksia olisi huomattu. Koordinoidun monipistetiedonsiirron on laajalti sanottu olevan tehokas tapa parantaa LTE-verkon suorituskykyä, etenkin solujen reunoilla. Monia haasteita pitää ratkaista, enne kuin sitä voidaan käyttää alalinkin tiedonsiirtoon. Lisäksi sen käyttöön eri tukiasemien solujen välillä liittyy haasteita. Tästä syystä monipistetiedonsiirtoa voitiin testata vain ylälinkin suuntaan ja vain yhden tukiaseman välisten solujen kesken. Tulokset osoittivat, että suorituskyky parani merkittävästi solun reunalla

Timing and Carrier Synchronization in Wireless Communication Systems: A Survey and Classification of Research in the Last 5 Years

Timing and carrier synchronization is a fundamental requirement for any wireless communication system to work properly. Timing synchronization is the process by which a receiver node determines the correct instants of time at which to sample the incoming signal. Carrier synchronization is the process by which a receiver adapts the frequency and phase of its local carrier oscillator with those of the received signal. In this paper, we survey the literature over the last 5 years (2010–2014) and present a comprehensive literature review and classification of the recent research progress in achieving timing and carrier synchronization in single-input single-output (SISO), multiple-input multiple-output (MIMO), cooperative relaying, and multiuser/multicell interference networks. Considering both single-carrier and multi-carrier communication systems, we survey and categorize the timing and carrier synchronization techniques proposed for the different communication systems focusing on the system model assumptions for synchronization, the synchronization challenges, and the state-of-the-art synchronization solutions and their limitations. Finally, we envision some future research directions

AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing

The enormous success of advanced wireless devices is pushing the demand for higher wireless data rates. Denser spectrum reuse through the deployment of more access points per square mile has the potential to successfully meet the increasing demand for more bandwidth. In theory, the best approach to density increase is via distributed multiuser MIMO, where several access points are connected to a central server and operate as a large distributed multi-antenna access point, ensuring that all transmitted signal power serves the purpose of data transmission, rather than creating "interference." In practice, while enterprise networks offer a natural setup in which distributed MIMO might be possible, there are serious implementation difficulties, the primary one being the need to eliminate phase and timing offsets between the jointly coordinated access points. In this paper we propose AirSync, a novel scheme which provides not only time but also phase synchronization, thus enabling distributed MIMO with full spatial multiplexing gains. AirSync locks the phase of all access points using a common reference broadcasted over the air in conjunction with a Kalman filter which closely tracks the phase drift. We have implemented AirSync as a digital circuit in the FPGA of the WARP radio platform. Our experimental testbed, comprised of two access points and two clients, shows that AirSync is able to achieve phase synchronization within a few degrees, and allows the system to nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC and higher layer aspects of a practical deployment. To the best of our knowledge, AirSync offers the first ever realization of the full multiuser MIMO gain, namely the ability to increase the number of wireless clients linearly with the number of jointly coordinated access points, without reducing the per client rate.Comment: Submitted to Transactions on Networkin

Multiple-Access Technology of Choice In 3GPP LTE

Third-Generation Partnership Project (3GPP) standardizes an Evolved UMTS Terrestrial Radio Access Network (E-UTRAN) as air interface in its release 8 LTE. Orthogonal Frequency Division Multiple Access(OFDMA) and Single Carrier-Frequency Division Multiple Access(SC-FDMA)are key technologies for the air interface of mobile broadband systems.It is evident that mobile broadband access technologies are reaching a commonality in the air interface and networking architecture; they are being converged to an IP-based network architecture with OFDMA based air interface technology. The air interface of E-UTRAN is based on OFDMA in downlink and SC-FDMA in the uplink, making it possible to efficiently utilize bandwidth due to the orthogonally between sub-carriers and by assigning subsets of sub-carriers to individual users which allows for simultaneous data rate transmission from several users and differentiated quality of service for each user. In this paper, wehighlight the technologies behindOFDMA and SC-FDMA and also carry out performance comparison of the two air interface technologies. We brieflydescribe the 3GPP LTE standard, and its implementation using OFDMA and SC-FDMA technology