Exploiting smallest error to calibrate non-linearity in SAR ADCs

This paper presents a statistics-optimised organisation technique to achieve better element matching in Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) in smart sensor systems. We demonstrate the proposed technique ability to achieve a significant improvement of around 23 dB on Spurious Free Dynamic Range (SFDR) of the ADC than the conventional, testing with a capacitor mismatch σu = 0.2% in a 14 bit SAR ADC system. For the static performance, the max root mean square (rms) value of differential nonlinearity (DNL) reduces from 1.63 to 0.20 LSB and the max rms value of integral nonlinearity (INL) reduces from 2.10 to 0.21 LSB. In addition, it is demonstrated that by applying grouping optimisation and strategy optimisation, the performance boosting on SFDR can be effectively achieved. Such great improvement on the resolution of the ADC only requires an off-line pre-processing digital part

A radiation-hard dual-channel 12-bit 40 MS/s ADC prototype for the ATLAS liquid argon calorimeter readout electronics upgrade at the CERN LHC

The readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider requires a radiation-hard ADC. The design of a radiation-hard dual-channel 12-bit 40 MS/s pipeline ADC for this use is presented. The design consists of two pipeline A/D channels each with four Multiplying Digital-to-Analog Converters followed by 8-bit Successive-Approximation-Register analog-to-digital converters. The custom design, fabricated in a commercial 130 nm CMOS process, shows a performance of 67.9 dB SNDR at 10 MHz for a single channel at 40 MS/s, with a latency of 87.5 ns (to first bit read out), while its total power consumption is 50 mW/channel. The chip uses two power supply voltages: 1.2 and 2.5 V. The sensitivity to single event effects during irradiation is measured and determined to meet the system requirements

Three Realizations and Comparison of Hardware for Piezoresistive Tactile Sensors

Tactile sensors are basically arrays of force sensors that are intended to emulate the skin in applications such as assistive robotics. Local electronics are usually implemented to reduce errors and interference caused by long wires. Realizations based on standard microcontrollers, Programmable Systems on Chip (PSoCs) and Field Programmable Gate Arrays (FPGAs) have been proposed by the authors for the case of piezoresistive tactile sensors. The solution employing FPGAs is especially relevant since their performance is closer to that of Application Specific Integrated Circuits (ASICs) than that of the other devices. This paper presents an implementation of such an idea for a specific sensor. For the purpose of comparison, the circuitry based on the other devices is also made for the same sensor. This paper discusses the implementation issues, provides details regarding the design of the hardware based on the three devices and compares them.This work has been partially funded by the Spanish Government under contracts TEC2006-12376 and TEC2009-14446

Design and Analysis of a Low-Power 8-Bit 500 KS/S SAR ADC for Bio-Medical Implant Devices

This thesis project involves the design and analysis of an 8-bit Successive Approximation Register (SAR) Analog to Digital Convertor (ADC), designed for low- power applications such as bio-medical implants. The sampling rate for this ADC is 500 KS/s. The power consumption for the whole SAR ADC system was measured to be 2.1 uW. The novelty of this project is the proposal of an extremely energy efficient comparator architecture. The result is the design of a final ADC with reasonable sampling speed, accuracy and low power consumption. In this project, all the different subsystems have been designed at the transistor level with 45 nm CMOS technology. The logical circuit was designed using Verilog language. It was then synthesized and integrated in the overall system