Bit Loading and Peak Average Power Reduction Techniques for Adaptive Orthogonal Frequency Division Multiplexing Systems

In a frequency-selective channel a large number of resolvable multipaths are present which lead to the fading of the signal. Orthogonal frequency division multiplexing (OFDM) is well-known to be effective against multipath distortion. It is a multicarrier communication scheme, in which the bandwidth of the channel is divided into subcarriers and data symbols are modulated and transmitted on each subcarrier simultaneously. By inserting guard time that is longer than the delay spread of the channel, an OFDM system is able to mitigate intersymbol interference (ISI). Significant improvement in performance is achieved by adaptively loading the bits on the subcarriers based on the channel state information from the receiver. Imperfect channel state information (CSI) arises from noise at the receiver and also due to the time delay in providing the information to the transmitter for the next data transmission. This thesis presents an investigation into the different adaptive techniques for loading the data bits on the subcarriers. The choice of the loading technique is application specific. The spectral efficiency and the bit error rate (BER) performance of adaptive OFDM as well as the implementation complexity of the different loading algorithms is studied by varying any one of the parameters, data rate or BER or total transmit power subject to the constraints on the other two. A novel bit loading algorithm based on comparing the SNR with the threshold in order to minimize the BER is proposed and its performance for different data rates is plotted. Finally, this thesis presents a method for reducing the large peak to average power ratio (PAPR) problem with OFDM which arises when the sinusoidal signals of the subcarriers add constructively. The clipping and the probabilistic approaches were studied. The probabilistic technique shows comparatively better BER performance as well as reduced PAPR ratio but is more complex to implement

Layered Video Transmission on Adaptive OFDM Wireless Systems

Future wireless video transmission systems will consider orthogonal frequency division multiplexing (OFDM) as the basic modulation technique due to its robustness and low complexity implementation in the presence of frequency-selective channels. Recently, adaptive bit loading techniques have been applied to OFDM showing good performance gains in cable transmission systems. In this paper a multilayer bit loading technique, based on the so called "ordered subcarrier selection algorithm," is proposed and applied to a Hiperlan2-like wireless system at 5 GHz for efficient layered multimedia transmission. Different schemes realizing unequal error protection both at coding and modulation levels are compared. The strong impact of this technique in terms of video quality is evaluated for MPEG-4 video transmission

Adaptive Bit Allocation With Reduced Feedback for Wireless Multicarrier Transceivers

With the increasing demand in the wireless mobile applications came a growing need to transmit information quickly and accurately, while consuming more and more bandwidth. To address this need, communication engineers started employing multicarrier modulation in their designs, which is suitable for high data rate transmission. Multicarrier modulation reduces the system's susceptibility to the frequency-selective fading channel, by transforming it into a collection of approximately flat subchannels. As a result, this makes it easier to compensate for the distortion introduced by the channel. This thesis concentrates on techniques for saving bandwidth usage when employing adaptive multicarrier modulation, where subcarrier parameters (bit and energy allocations) are modulated based on the channel state information feedback obtained from previous burst. Although bit and energy allocations can substantially increase error robustness and throughput of the system, the feedback information required at both ends of the transceiver can be large. The objective of this work is to compare different feedback compression techniques that could reduce the amount of feedback information required to perform adaptive bit and energy allocation in multicarrier transceivers. This thesis employs an approach for reducing the number of feedback transmissions by exploiting the time-correlation properties of a wireless channel and placing a threshold check on bit error rate (BER) values. Using quantization and source coding techniques, such as Huffman coding, Run length encoding and LZWalgorithms, the amount of feedback information has been compressed. These calculations have been done for different quantization levels to understand the relationship between quantization levels and system performance. These techniques have been applied to both OFDM and MIMO-OFDM systems

Adaptive Transmission for OFDM

To respond to dynamic channel conditions caused by fading, shadowing, and other time-varying disturbances, orthogonal frequency division multiplexing (OFDM) packet radio systems should adapt transmission parameters on a packet-by-packet basis to maintain or improve performance over the channel. For this to be possible, there are three key ideas that must be addressed: first, how to determine the subchannel conditions; second, which transmission parameters should be adapted; and third, how to adapt those parameters intelligently. In this thesis, we propose a procedure for determining relative subchannel quality without using any traditional channel measurements. Instead, statistics derived solely from subcarrier error counts allow subchannels to be ranked by order of estimated quality; this order can be exploited for adapting transmission parameters. We investigate adaptive subcarrier power allocation, adaptive subcarrier modulation that allows different subcarriers in the same packet to use different modulation formats, and adaptive coding techniques for OFDM in fading channels. Analysis and systems simulation assess the accuracy of the subcarrier ordering as well as the throughput achieved by the proposed adaptive transmission protocol, showing good performance across a wide range of channel conditions

Adaptive OFDM Cooperative Systems

Cooperative communication is a promising technique for wireless communication systems where wireless nodes cooperate together in transmitting their information. Such communication transmission technique, which realizes the multiple antenna arrays in a distributed manner over multiple wireless nodes, succeeds in extending the network coverage, increasing throughput, improving both link reliability and spectral efficiency. Available channel state information at the transmitting nodes can be used to design adaptive transmission schemes for improving the overall system performance. Throughout our work, we adaptively change loaded power and/or bit to the Orthogonal Frequency Division Multiplexing (OFDM) symbol in order to minimize bit error rate or maximize the throughput. In the first part of this dissertation, we consider single-relay OFDM system with amplify-and-forward relaying. We propose three algorithms to minimize the bit error rate under total power constraint and fixed transmission rate. These algorithms are optimal power loading, optimal bit loading and optimal bit and power loading. Through Monte Carlo simulations we study the proposed system performance and discuss the effect of relay location and channel estimation. This study shows that the proposed algorithms result in exploiting the multi-path diversity and achieving extra coding gain. In the second part, we extend the problem to a multi-relay OFDM network but with decode-and-forward relaying. We propose an adaptive power loading algorithm to minimize the bit error rate under total power constraint based on two relay selection strategies. The proposed system leads to achieve both multi-path and cooperative spatial diversity using maximal-ratio combiner for the detection. In the last part, we consider also multi-relay network but with amplify and forward relaying. We optimize the bit loading coefficients to maximize the throughput under target bit error rate constraint. The proposed algorithm is considered more practical since it takes into consideration the channel estimation quality. The considered adaptive system has less complexity compared with other adaptive systems through reducing the feedback amount. Furthermore, the full network channel state information is needed only at the destination

D13.2 Techniques and performance analysis on energy- and bandwidth-efficient communications and networking

Deliverable D13.2 del projecte europeu NEWCOM#The report presents the status of the research work of the various Joint Research Activities (JRA) in WP1.3 and the results that were developed up to the second year of the project. For each activity there is a description, an illustration of the adherence to and relevance with the identified fundamental open issues, a short presentation of the main results, and a roadmap for the future joint research. In the Annex, for each JRA, the main technical details on specific scientific activities are described in detail.Peer ReviewedPostprint (published version