379 research outputs found
Codebook Based Hybrid Precoding for Millimeter Wave Multiuser Systems
In millimeter wave (mmWave) systems, antenna architecture limitations make it
difficult to apply conventional fully digital precoding techniques but call for
low cost analog radio-frequency (RF) and digital baseband hybrid precoding
methods. This paper investigates joint RF-baseband hybrid precoding for the
downlink of multiuser multi-antenna mmWave systems with a limited number of RF
chains. Two performance measures, maximizing the spectral efficiency and the
energy efficiency of the system, are considered. We propose a codebook based RF
precoding design and obtain the channel state information via a beam sweep
procedure. Via the codebook based design, the original system is transformed
into a virtual multiuser downlink system with the RF chain constraint.
Consequently, we are able to simplify the complicated hybrid precoding
optimization problems to joint codeword selection and precoder design (JWSPD)
problems. Then, we propose efficient methods to address the JWSPD problems and
jointly optimize the RF and baseband precoders under the two performance
measures. Finally, extensive numerical results are provided to validate the
effectiveness of the proposed hybrid precoders.Comment: 35 pages, 9 figures, to appear in Trans. on Signal Process, 201
Joint Hybrid Precoder and Combiner Design for mmWave Spatial Multiplexing Transmission
Millimeter-wave (mmWave) communications have been considered as a key
technology for future 5G wireless networks because of the orders-of-magnitude
wider bandwidth than current cellular bands. In this paper, we consider the
problem of codebook-based joint analog-digital hybrid precoder and combiner
design for spatial multiplexing transmission in a mmWave multiple-input
multiple-output (MIMO) system. We propose to jointly select analog precoder and
combiner pair for each data stream successively aiming at maximizing the
channel gain while suppressing the interference between different data streams.
After all analog precoder/combiner pairs have been determined, we can obtain
the effective baseband channel. Then, the digital precoder and combiner are
computed based on the obtained effective baseband channel to further mitigate
the interference and maximize the sum-rate. Simulation results demonstrate that
our proposed algorithm exhibits prominent advantages in combating interference
between different data streams and offer satisfactory performance improvement
compared to the existing codebook-based hybrid beamforming schemes
- …