Performance Enhancement in Copper Twisted Pair Cable Communications

The thesis focuses on the area of copper twisted pair based wireline communications. As one of the most widely deployed communication media, the copper twisted pair cable plays an important role in the communication network cabling infrastructure. This thesis looks to exploit diversity to improve twisted pair channels for data communications in two common application areas, namely Ethernet over Twisted Paris and digital subscriber line over twisted pair based telephone network. The first part of the thesis addresses new approaches to next generation Ethernet over twisted pair cable. The coming challenge for Ethernet over twisted pair cable is to realise a higher data rate beyond the 25/40GBASE-T standard, in relatively short reach scenarios. The straight-forward approaches, such as improving cable quality and extending frequency bandwidth, are unlikely to provide significant improvement in terms of data rate. However, other system diversities, such as spectrum utilization are yet to be fully exploited, so as to meet the desired data rate performance. The current balanced transmission over the structured twisted pair cable and its parallel single-in-single-out channel model is revisited and formulated as a full-duplex multiple-in-multiple-out (MIMO) channel model. With a common ground (provided by the cable shield), the balanced transmission is converted into unbalanced transmission, by replacing the differential-mode excitation with single-ended excitation. In this way, MIMO adoption may offer spectrum utilization advantages due to the doubled number of the channels. The S-parameters of the proposed MIMO channel model is obtained through the full wave electromagnetic simulation of a short CAT7A cable. The channel models are constructed from the resulting S-parameters, also the corresponding theoretical capacity is evaluated by exploiting different diversity scenarios. With higher spectrum efficiency, the orthogonal-frequency-division-multiplexing (OFDM) modulation can significantly improve the theoretical capacity compared with single-carrier modulation, where the channel frequency selectivity is aided. The MIMO can further enhance the capacity by minimising the impact of the crosstalk. When the crosstalk is properly handled under the unbalanced transmission, this thesis shows that the theoretical capacity of the EoTP cable can reach nearly 200GBit/s. In order to further extend the bandwidth capability of twisted pair cables, Phantom Mode transmission is studied, aiming at creating more channels under balanced transmission operation. The second part of the thesis focuses on the research of advanced scheduling algorithms for VDSL2 QoS enhancement. For VDSL2 broadband access networks, multi-user optimisation techniques have been developed, so as to improve the basic data rate performance. Spectrum balancing improves the network performance by optimising users transmit power spectra as the resource allocation, to mitigate the impact from the crosstalk. Aiming at enhancing the performance for the upstream VDSL2 service, where the users QoS demand is not known by all other users, a set of autonomous spectrum balancing algorithms is proposed. These optimise users transmit power spectra locally with only direct channel state information. To prevent selfish behaviour, the concept of a virtual user is introduced to represent the impact on both crosstalk interference and queueing status of other users. Moreover, novel algorithms are developed to determine the parameters and the weight of the virtual user. Another type of resource allocation in the VDSL2 network is crosstalk cancellation by centralised signal coordination. The history of the data queue is considered as a time series, on which different smooth filter characteristics are investigated in order to investigate further performance improvement. The use of filter techniques accounts for both the instantaneous queue length and also the previous data to determine the most efficient dynamic resource allocation. With the help of this smoothed dynamic resource allocation, the network will benefit from both reduced signalling communication and improved delay performance.The proposed algorithms are verified by numerical experiments

Optimal Multi-user Spectrum Management for Digital Subscriber Lines

Crosstalk is a major issue in modern DSL systems such as ADSL and VDSL. Static spectrum management, the traditional way of ensuring spectral compatibility, employs spectral masks which can be overly conservative and lead to poor performance. In this paper we present a centralized algorithm for optimal spectrum management (OSM) in DSL. The algorithm uses a dual decomposition to solve the spectrum management problem in an efficient and computationally tractable way. The algorithm shows significant performance gains over existing DSM techniques, e.g. in an upstream VDSL scenario the centralized OSM algorithm can outperform a distributed DSM algorithm such as iterative waterfilling by up to 380%

Optimal multi-user spectrum balancing for digital subscriber lines

Crosstalk is a major issue in modern digital subscriber line (DSL) systems such as ADSL and VDSL. Static spectrum management, which is the traditional way of ensuring spectral compatibility, employs spectral masks that can be overly conservative and lead to poor performance. This paper presents a centralized algorithm for optimal spectrum balancing in DSL. The algorithm uses the dual decomposition method to optimize spectra in an efficient and computationally tractable way. The algorithm shows significant performance gains over existing dynamic spectrum management (DSM) techniques, e.g., in one of the cases studied, the proposed centralized algorithm leads to a factor-of-four increase in data rate over the distributed DSM algorithm iterative waterfilling

Multi-User Signal and Spectra Coordination for Digital Subscriber Lines

The appetite amongst consumers for ever higher data-rates seems insatiable. This booming market presents a huge opportunity for telephone and cable operators. It also presents a challenge: the delivery of broadband services to millions of customers across sparsely populated areas. Fully fibre-based networks, whilst technically the most advanced solution, are prohibitively expensive to deploy. Digital subscriber lines (DSL) provide an alternative solution. Seen as a stepping-stone to a fully fibre-based network, DSL operates over telephone lines that are already in place, minimizing the cost of deployment. The basic principle behind DSL technology is to increase data-rate by widening the transmission bandwidth. Unfortunately, operating at high frequencies, in a medium originally designed for voice-band transmission, leads to crosstalk between the different DSLs. Crosstalk is typically 10-15 dB larger than the background noise and is the dominant source of performance degradation in DSL. This thesis develops practical multi-user techniques for mitigating crosstalk in DSL. The techniques proposed have low complexity, low latency, and are compatible with existing customer premises equipment (CPE). In addition to being practical, the techniques also yield near-optimal performance, operating close to the theoretical multi-user channel capacity. Multi-user techniques are based on the coordination of the different users in a network, and this can be done on either a spectral or signal level

Partial Crosstalk Cancellation Exploiting Line and Tone Selection in Upstream VDSL

VDSL is the next step in an on-going evolution of DSL systems. In VDSL downstream data rates of up to 52 Mbps are supported by operating over short loop lengths and using frequencies up to 12 MHz. Unfortunately such high frequencies result in crosstalk between pairs within a binder-group. Many crosstalk cancellation techniques have been proposed to address this. Whilst these schemes lead to impressive performance gains their complexity grows with the square of the number of lines within a binder. In binder-groups which can carry up to hundreds of lines this complexity is outside the scope of current implementation. In this paper we investigate partial crosstalk cancellation for upstream VDSL. The majority of the detrimental effects of crosstalk are typically limited to a small sub-set of lines and tones. Furthermore significant crosstalk is often only seen from neighbouring pairs within the binder configuration. We present a number of algorithms which exploit these properties to reduce the complexity of crosstalk cancellation. These algorithms are shown to achieve the majority of the performance gains of full crosstalk cancellation with significantly reduced run-time complexity

Physical Layer Techniques for High Frequency Wireline Broadband Systems

This thesis collects contributions to wireline and wireless communication systems with an emphasis on multiuser and multicarrier physical layer technology. To deliver increased capacity, modern wireline access systems such as G.fast extend the signal bandwidth up from tens to hundreds of MHz. This ambitious development revealed a number of unforeseen hurdles such as the impact of impedance changes in various forms. Impedance changes have a strong effect on the performance of multi-user crosstalk mitigation techniques such as vectoring. The first part of the thesis presents papers covering the identification of one of these problems, a model describing why it occurs and a method to mitigate its effects, improving line stability for G.fast systems.A second part of the thesis deals with the effects of temperature changes on wireline channels. When a vectored (MIMO) wireline system is initialized, channel estimates need to be obtained. This thesis presents contributions on the feasibility of re-using channel coefficients to speed up the vectoring startup procedures, even after the correct coefficients have changed, e.g., due to temperature changes. We also present extensive measurement results showing the effects of temperature changes on copper channels using a temperature chamber and British cables. The last part of the thesis presents three papers on the convergence of physical layer technologies, more specifically the deployment of OFDM-based radio systems using twisted pairs in different ways. In one proposed scenario, the idea of using the access copper lines to deploy small cells inside users' homes is explored. The feasibility of the concept, the design of radio-heads and a practical scheme for crosstalk mitigation are presented in three contributions