Low-Density Parity-Check Coded High-order Modulation Schemes

In this thesis, we investigate how to support reliable data transmissions at high speeds in future communication systems, such as 5G/6G, WiFi, satellite, and optical communications. One of the most fundamental problems in these communication systems is how to reliably transmit information with a limited number of resources, such as power and spectral. To obtain high spectral efficiency, we use coded modulation (CM), such as bit-interleaved coded modulation (BICM) and delayed BICM (DBICM). To be specific, BICM is a pragmatic implementation of CM which has been largely adopted in both industry and academia. While BICM approaches CM capacity at high rates, the capacity gap between BICM and CM is still noticeable at lower code rates. To tackle this problem, DBICM, as a variation of BICM, introduces a delay module to create a dependency between multiple codewords, which enables us to exploit extrinsic information from the decoded delayed sub-blocks to improve the detection of the undelayed sub-blocks. Recent work shows that DBICM improves capacity over BICM. In addition, BICM and DBICM schemes protect each bit-channel differently, which is often referred to as the unequal error protection (UEP) property. Therefore, bit mapping designs are important for constructing pragmatic BICM and DBICM. To provide reliable communication, we have jointly designed bit mappings in DBICM and irregular low-density parity-check (LDPC) codes. For practical considerations, spatially coupled LDPC (SC-LDPC) codes have been considered as well. Specifically, we have investigated the joint design of the multi-chain SC-LDPC and the BICM bit mapper. In addition, the design of SC-LDPC codes with improved decoding threshold performance and reduced rate loss has been investigated in this thesis as well. The main body of this thesis consists of three parts. In the first part, considering Gray-labeled square M-ary quadrature amplitude modulation (QAM) constellations, we investigate the optimal delay scheme with the largest spectrum efficiency of DBICM for a fixed maximum number of delayed time slots and a given signal-to-noise ratio. Furthermore, we jointly optimize degree distributions and channel assignments of LDPC codes using protograph-based extrinsic information transfer charts. In addition, we proposed a constrained progressive edge growth-like algorithm to jointly construct LDPC codes and bit mappings for DBICM, taking the capacity of each bit-channel into account. Simulation results demonstrate that the designed LDPC-coded DBICM systems significantly outperform LDPC-coded BICM systems. In the second part, we proposed a windowed decoding algorithm for DBICM, which uses the extrinsic information of both the decoded delayed and undelayed sub-blocks, to improve the detection for all sub-blocks. We show that the proposed windowed decoding significantly outperforms the original decoding, demonstrating the effectiveness of the proposed decoding algorithm. In the third part, we apply multi-chain SC-LDPC to BICM. We investigate various connections for multi-chain SC-LDPC codes and bit mapping designs and analyze the performance of the multi-chain SC-LDPC codes over the equivalent binary erasure channels via density evolution. Numerical results demonstrate the superiority of the proposed design over existing connected-chain ensembles and over single-chain ensembles with the existing bit mapping design

Advanced receivers and waveforms for UAV/Aircraft aeronautical communications

Nowadays, several studies are launched for the design of reliable and safe communications systems that introduce Unmanned Aerial Vehicle (UAV), this paves the way for UAV communication systems to play an important role in a lot of applications for non-segregated military and civil airspaces. Until today, rules for integrating commercial UAVs in airspace still need to be defined, the design of secure, highly reliable and cost effective communications systems still a challenging task. This thesis is part of this communication context. Motivated by the rapid growth of UAV quantities and by the new generations of UAVs controlled by satellite, the thesis aims to study the various possible UAV links which connect UAV/aircraft to other communication system components (satellite, terrestrial networks, etc.). Three main links are considered: the Forward link, the Return link and the Mission link. Due to spectrum scarcity and higher concentration in aircraft density, spectral efficiency becomes a crucial parameter for largescale deployment of UAVs. In order to set up a spectrally efficient UAV communication system, a good understanding of transmission channel for each link is indispensable, as well as a judicious choice of the waveform. This thesis begins to study propagation channels for each link: a mutipath channels through radio Line-of-Sight (LOS) links, in a context of using Meduim Altitude Long drones Endurance (MALE) UAVs. The objective of this thesis is to maximize the solutions and the algorithms used for signal reception such as channel estimation and channel equalization. These algorithms will be used to estimate and to equalize the existing muti-path propagation channels. Furthermore, the proposed methods depend on the choosen waveform. Because of the presence of satellite link, in this thesis, we consider two low-papr linear waveforms: classical Single-Carrier (SC) waveform and Extented Weighted Single-Carrier Orthogonal Frequency-Division Multiplexing (EW-SC-OFDM) waveform. channel estimation and channel equalization are performed in the time-domain (SC) or in the frequency-domain (EW-SC-OFDM). UAV architecture envisages the implantation of two antennas placed at wings. These two antennas can be used to increase diversity gain (channel matrix gain). In order to reduce channel equalization complexity, the EWSC- OFDM waveform is proposed and studied in a muti-antennas context, also for the purpose of enhancing UAV endurance and also increasing spectral efficiency, a new modulation technique is considered: Spatial Modulation (SM). In SM, transmit antennas are activated in an alternating manner. The use of EW-SC-OFDM waveform combined to SM technique allows us to propose new modified structures which exploit exces bandwidth to improve antenna bit protection and thus enhancing system performances

OFDM techniques for multimedia data transmission

Orthogonal Frequency Division Multiplexing (OFDM) is an efficient parallel data transmission scheme that has relatively recently become popular in both wired and wireless communication systems for the transmission of multimedia data. OFDM can be found at the core of well known systems such as digital television/radio broadcasting, ADSL internet and wireless LANs. Research into the OFDM field continually looks at different techniques to attempt to make this type of transmission more efficient. More recent works in this area have considered the benefits of using wavelet transforms in place of the Fourier transforms traditionally used in OFDM systems and other works have looked at data compression as a method of increasing throughput in these types of transmission systems. The work presented in this thesis considers the transmission of image and video data in traditional OFDM transmission and discusses the strengths and weaknesses of this method. This thesis also proposes a new type of OFDM system that combines transmission and data compression into one block. By merging these two processes into one the complexity of the system is reduced, therefore promising to increase system efficiency. The results presented in this thesis show the novel compressive OFDM method performs well in channels with a low signal-to-noise ratio. Comparisons with traditional OFDM with lossy compression show a large improvement in the quality of the data received with the new system when used in these noisy channel environments. The results also show superior results are obtained when transmitting image and video data using the new method, the high correlative properties of images are ideal for effective transmission using the new technique. The new transmission technique proposed in this thesis also gives good results when considering computation time. When compared to MATLAB simulations of a traditional DFT-based OFDM system with a separate compression block, the proposed transmission method was able to reduce the computation time by between a half to three-quarters. This decrease in computational complexity also contributes to transmission efficiency when considering the new method

The development of a novel modem structure for connection of rural to diginet

Includes bibliographical references.This thesis investigates the use of partial response signalling as a modulation scheme in a modem structure. The modem structure consists of transmitter modulation and receiver demodulation sections only. The modem is designed to operate at data rates of 2400, 4800 and 9600 bps. The signalling format replaces the CCITT Recommendation V.29 format. The transmitted signal is required to conform to the bandwidth limitations of CCITT Recommendation M.1020 leased telephone circuits

Investigation into synchronization for partial response signals and the development of a clock recovery scheme for 49QPRS signals

ThesisData communication is used increasingly in modern society. It is against this background that research is conducted worldwide toward the improvement of existing, as well as the development of new, improved communication techniques. Correlative encoding of data before transmission IS a very frequency-effective communication technique. The extent to which any communication technique is used, however, is dependent on a wide variety of factors. This study regarding the synchronisation of 49QPRS signals was undertaken with this in mind. Since digital signal processing (DSP) is used increasingly in modern communication systems, both a data transmitter and receiver were implemented by making use of this technique. Not only would this result in a system with all the desirable characteristics inherent to DSP, but, by making limited changes to the supporting software, the evaluation of a wide variety of alternatives became feasible. During the study a system making use of a pilot tone at one third the frequency of the carrier frequency was developed. The receiver recovers this signal by means of DSP techniques and its frequency is tripled. The phase of this recovered signal is crosscorrelated every 650 ~s in time with a locally generated signal of the correct frequency - and the phase of the locally generated signal is adjusted accordingly. It was found that the accuracy and stability of the locally generated signal were such that sufficient synchronisation was obtained in this manner. The quality of synchronisation is a function of the level of the pilot tone and if this tone should decrease to below a certain value, unacceptably large phase adjustments have to be made. This results in a senous degradation of the spectral purity of the recovered signal. However, the system as described exhibits extremely good noise immunity. During the development of the clock frequency recovery system, a baseband filter with a unique frequency response was defined. Making use of this, in conjunction with a limited amount of pre-processing, and an absolute value rectifier, recovery of the clock frequency becomes possible. In order to limit the amount of processing by the receiver, the baseband filter was implemented in its entirety in the transmitter. The recovered signal showed a moderate amount of amplitude variation, but an extremely stable synchronising signal could be derived from this. During the study both levels of synchronisation required by a hypothetical 49QPRS data communication system were therefore investigated fully and solutions found

Smart Antenna-Aided Multicarrier Transceivers for Mobile Communications

In spite of an immense interest from both the academic and the industrial communities, a practical multipleinput multiple-output (MIMO) transceiver architecture, capable of approaching channel capacity boundaries in realistic channel conditions remains largely an open problem. Consequently, in this treatise I derive an advanced iterative, so called turbo multi-antenna-multi-carrier (MAMC) receiver architecture. Following the philosophy of turbo processing, our turbo spacial division multiplexed (SDM)-orthogonal frequency division multiplexed (OFDM) receiver comprises a succession of soft-input-soft-output detection modules, which iteratively exchange soft bit-related information and thus facilitate a substantial improvement of the overall system performance. In this treatise, I explore two major aspects of the turbo wireless mobile receiver design. Firstly, I consider the problem of soft-decision-feedback aided acquisition of the propagation conditions experienced by the transmitted signal and secondly, I explore the issue of the soft-input-soft-output detection of the spatially-multiplexed information-carrying signals

A Combined Equaliser and Decoder for Maximum Likelihood Decoding of Convolutional Codes in the presence of ISI. Incorporation into GSM 3GPP Standard

The dissertation describes a new approach in combining the equalising and decoding operations in wireless telecommunications, namely MS decoder. It provides performance results (SNR) and carries out simulations based on GSM 3GPP standard

Digital signal processing for fiber-optic communication systems

As the available bandwidth of optical fibers has been almost fully exploited, Digital Signal Processing (DSP) comes to rescue and is a critical technology underpinning the next generation advanced fiber-optic systems. Literally, it contributes two principal enforcements with respect to information communication. One is the implementation of spectrally-efficient modulation schemes, and the other is the guarantee of the recovery of information from the spectrally-efficient optical signals after channel transmission. The dissertation is dedicated to DSP techniques for the advanced fiber-optic systems. It consists of two main research topics. The first topic is about Fast-orthogonal frequency-division multiplexing (OFDM) — a variant OFDM scheme whose subcarrier spacing is half of that of conventional OFDM. The second one is about Fresnel transform with the derivation of an interesting discrete Fresnel transform (DFnT), and the proposal of orthogonal chirp-division multiplexing (OCDM), which is fundamentally underlain by the Fresnel transform. In the first part, equalization and signal recovery problems result from the halved subcarrier spacing in both double-sideband (DSB) and single-sideband (SSB) modulated Fast-OFDM systems are studied, respectively. By exploiting the relation between the multiplexing kernels of Fast-OFDM systems and Fourier transform, equalization algorithms are proposed for respective Fast-OFDM systems for information recovery. Detailed analysis is also provided. With the proposed algorithms, the DSB Fast-OFDM was experimentally implemented by intensity-modulation and direct detection in the conventional 1.55-μm and the emerging 2-μm fiber-optic systems, and the SSB Fast-OFDM was first implemented in coherent fiber-optic system with a spectral efficiency of 6 bit/s/Hz at 36 Gbps, for the first time. In the second part, Fresnel transform from optical Fresnel diffraction is studied. The discrete Fresnel transform (DFnT) is derived, as an interesting transformation that would be potentially useful for DSP. Its properties are proved. One of the attractive properties, the convolution-preservation property states that the DFnT of a circular convolution of two sequences is equal to the DFnT of either one convolving with the other. One application of DFnT is practically utilized in the proposal of OCDM. In the OCDM system, a large number of orthogonal chirped waveforms are multiplexed for high-speed communication, achieving the maximum spectral efficiency of chirp spread spectrum systems, in the same way as OFDM attains the maximum spectral efficiency of frequency-division multiplexing. Owing to the unique time-frequency properties of chirped waveforms, OCDM outperforms OFDM and single-carrier systems, and is more resilient against the noise effect, especially, when time-domain and frequency-domain distortions are severe. Experiments were carried out to validate the feasibility and advantages of the proposed OCDM systems