Performance degradation due to multipath noise for narrowband OFDM systems: channel-based analysis and experimental determination

The performance of OFDM systems over a multipath channel can strongly degrade due to the propagation delay spread. The distortion of the received signal over the fast Fourier transform window is referred to as multipath noise. This work aims to analytically determine the performance loss due to multipath noise as a function of OFDM and channel parameters for narrowband OFDM systems. First, it is investigated whether it is possible to describe the multipath noise, varying over different OFDM packets due to the temporal variation of the channel, by an effective noise factor F-delay, from which the loss factor is directly determined. Second, the theory of room electromagnetics is applied to develop a closed-form expression for F-delay as a function of the OFDM and reverberation parameters. This analytical method is validated with excellent agreement. Finally, the loss factor is determined for IEEE 802.11 based on channel measurements in two large conference rooms, providing values up to 19 dB for an 800 ns cyclic prefix length

Enhanced Channel Estimation Based On Basis Expansion Using Slepian Sequences for Time Varying OFDM Systems

The Channel estimation in OFDM has become very important to recover the accurate information from the received data as the next generation of wireless technology has very high data rate along with the very high speed mobile terminals as users. In addition the fast fading channels, ICI, multipath fading channels may completely destroy the data. Also it is required to use less complex method for estimation. We are proposing the method which compares the number of techniques and gives the results in BER Vs SNR graphs. The LS estimation technique is less complex as compared to MMSE estimation but gives fails in accuracy. Using Prolate function we can reduce the complexity in calculation of parameters. If compared with state of art approach where the complexity is O(N)3, the complexity using Prolate function is O(N)2.The function depends upon maximum delay and maximum Doppler frequency spread thus parameter calculation is reduced. The technique dose not calculate particular channel characteristics. Slepian sequences utilizes the bandwidth as the sharp pulses replace the regular rectangular pulses which causes spectral leakage and thus ICI. The simulation of BER Vs SNR using CP and UW with and without Prolate is proposed that increases spectral efficiency with reduced calculations replacing rectangular pulses by Slepian pulses which increase energy concentration by Sharpe pulses thus reduction in inter carrier interference caused by multipath fading. DOI: 10.17762/ijritcc2321-8169.150513

Signal Detection for OFDM-Based Virtual MIMO Systems under Unknown Doubly Selective Channels, Multiple Interferences and Phase Noises

In this paper, the challenging problem of signal detection under severe communication environment that plagued by unknown doubly selective channels (DSCs), multiple narrowband interferences (NBIs) and phase noises (PNs) is investigated for orthogonal frequency division multiplexing based virtual multiple-input multiple-output (OFDM-V-MIMO) systems. Based on the Variational Bayesian Inference framework, a novel iterative algorithm for joint signal detection, DSC, NBI and PN estimations is proposed. Simulation results demonstrate quick convergence of the proposed algorithm, and after convergence, the bit-error-rate performance of the proposed signal detection algorithm is very close to that of the ideal case which assumes perfect channel state information, no PN, and known positions and powers of NBIs plus additive white Gaussian noise. Furthermore, simulation results show that the proposed signal detection algorithm outperforms other state-of-the-art methods.published_or_final_versio

Performance enhancement for LTE and beyond systems

A thesis submitted to the University of Bedfordshire, in partial fulfilment of the requirements for the degree of Doctor of PhilosophyWireless communication systems have undergone fast development in recent years. Based on GSM/EDGE and UMTS/HSPA, the 3rd Generation Partnership Project (3GPP) specified the Long Term Evolution (LTE) standard to cope with rapidly increasing demands, including capacity, coverage, and data rate. To achieve this goal, several key techniques have been adopted by LTE, such as Multiple-Input and Multiple-Output (MIMO), Orthogonal Frequency-Division Multiplexing (OFDM), and heterogeneous network (HetNet). However, there are some inherent drawbacks regarding these techniques. Direct conversion architecture is adopted to provide a simple, low cost transmitter solution. The problem of I/Q imbalance arises due to the imperfection of circuit components; the orthogonality of OFDM is vulnerable to carrier frequency offset (CFO) and sampling frequency offset (SFO). The doubly selective channel can also severely deteriorate the receiver performance. In addition, the deployment of Heterogeneous Network (HetNet), which permits the co-existence of macro and pico cells, incurs inter-cell interference for cell edge users. The impact of these factors then results in significant degradation in relation to system performance. This dissertation aims to investigate the key techniques which can be used to mitigate the above problems. First, I/Q imbalance for the wideband transmitter is studied and a self-IQ-demodulation based compensation scheme for frequencydependent (FD) I/Q imbalance is proposed. This combats the FD I/Q imbalance by using the internal diode of the transmitter and a specially designed test signal without any external calibration instruments or internal low-IF feedback path. The instrument test results show that the proposed scheme can enhance signal quality by 10 dB in terms of image rejection ratio (IRR). In addition to the I/Q imbalance, the system suffers from CFO, SFO and frequency-time selective channel. To mitigate this, a hybrid optimum OFDM receiver with decision feedback equalizer (DFE) to cope with the CFO, SFO and doubly selective channel. The algorithm firstly estimates the CFO and channel frequency response (CFR) in the coarse estimation, with the help of hybrid classical timing and frequency synchronization algorithms. Afterwards, a pilot-aided polynomial interpolation channel estimation, combined with a low complexity DFE scheme, based on minimum mean squared error (MMSE) criteria, is developed to alleviate the impact of the residual SFO, CFO, and Doppler effect. A subspace-based signal-to-noise ratio (SNR) estimation algorithm is proposed to estimate the SNR in the doubly selective channel. This provides prior knowledge for MMSE-DFE and automatic modulation and coding (AMC). Simulation results show that this proposed estimation algorithm significantly improves the system performance. In order to speed up algorithm verification process, an FPGA based co-simulation is developed. Inter-cell interference caused by the co-existence of macro and pico cells has a big impact on system performance. Although an almost blank subframe (ABS) is proposed to mitigate this problem, the residual control signal in the ABS still inevitably causes interference. Hence, a cell-specific reference signal (CRS) interference cancellation algorithm, utilizing the information in the ABS, is proposed. First, the timing and carrier frequency offset of the interference signal is compensated by utilizing the cross-correlation properties of the synchronization signal. Afterwards, the reference signal is generated locally and channel response is estimated by making use of channel statistics. Then, the interference signal is reconstructed based on the previous estimate of the channel, timing and carrier frequency offset. The interference is mitigated by subtracting the estimation of the interference signal and LLR puncturing. The block error rate (BLER) performance of the signal is notably improved by this algorithm, according to the simulation results of different channel scenarios. The proposed techniques provide low cost, low complexity solutions for LTE and beyond systems. The simulation and measurements show good overall system performance can be achieved