Full Duplex CMOS Transceiver with On-Chip Self-Interference Cancelation

abstract: The demand for the higher data rate in the wireless telecommunication is increasing rapidly. Providing higher data rate in cellular telecommunication systems is limited because of the limited physical resources such as telecommunication frequency channels. Besides, interference with the other users and self-interference signal in the receiver are the other challenges in increasing the bandwidth of the wireless telecommunication system. Full duplex wireless communication transmits and receives at the same time and the same frequency which was assumed impossible in the conventional wireless communication systems. Full duplex wireless communication, compared to the conventional wireless communication, doubles the channel efficiency and bandwidth. In addition, full duplex wireless communication system simplifies the reusing of the radio resources in small cells to eliminate the backhaul problem and simplifies the management of the spectrum. Finally, the full duplex telecommunication system reduces the costs of future wireless communication systems. The main challenge in the full duplex wireless is the self-interference signal at the receiver which is very large compared to the receiver noise floor and it degrades the receiver performance significantly. In this dissertation, different techniques for the antenna interface and self-interference cancellation are proposed for the wireless full duplex transceiver. These techniques are designed and implemented on CMOS technology. The measurement results show that the full duplex wireless is possible for the short range and cellular wireless communication systems.Dissertation/ThesisDoctoral Dissertation Engineering 201

A Passive STAR Microwave Circuit for 1-3 GHz Self-Interference Cancellation

Simultaneous transmit and receive (STAR) allows full-duplex operation of a radio, which leads to doubled capacity for a given bandwidth. A circulator with high-isolation between transmit and receive ports, and low-loss from the antenna to receive port is typically required for achieving STAR. Conventional circulators do not offer wideband performance. Although wideband circulators have been proposed using parametric, switched delay-line/capacitor, and N-path filter techniques using custom integrated circuits, these magnet-free devices have non-linearity, noise, aliasing, and switching noise injection issues. In this paper, a STAR front-end based on passive linear microwave circuit is proposed. Here, a dummy antenna located inside a miniature RF-silent absorption chamber allows circulator-free STAR using simple COTS components. The proposed approach is highly-linear, free from noise, does not require switching or parametric modulation circuits, and has virtually unlimited bandwidth only set by the performance of COTS passive microwave components. The trade-off is relatively large size of the miniature RF-shielded chamber, making this suitable for base-station side applications. Preliminary results show the measured performance of Tx/Rx isolation between 25-60 dB in the 1.0-3.0 GHz range, and 50-60 dB for the 2.4-2.7 GHz range.Comment: 4 figures, 4 page

Digitally-Assisted RF-Analog Self Interference Cancellation for Wideband Full-Duplex Radios

The ever-increasing demand for more data from users is pushing the development of alternative wireless technologies to improve upon network capacity. Full-Duplex radios provide an exciting opportunity to theoretically double the available spectral efficiency of wireless networks by simultaneously transmitting and receiving signals in the same frequency band. The main challenge that is presented in the implementation of a full-duplex radio is the high power transmitter leaking to the sensitive receiver chain and masking the desired receive signal to be decoded. This transmitter leakage is referred to as self interference and it is required that this self interference signal be cancelled below the receiver noise floor to achieve the full benefits of a full-duplex radio. Cancellation of the self interference signal is realized through several techniques, categorized as passive suppression, digital cancellation, and analog cancellation. These methods all have their challenges in achieving the full amount of cancellation necessary and therefore all three techniques are typically employed in the system. In this thesis, a novel digitally assisted radio frequency (RF) analog self interference canceller is proposed to suppress the self interference signal before the receiver chain for wide modulation bandwidth signals. This canceller augments minimum complexity RF-analog interference cancellation hardware that uses an RF vector multiplier in combination with a flexible digital rational function finite impulse response filter. The simple topology reduces the number of impairments added to the system through the analog components and identifies the parameters of the proposed filter in a deterministic and single iteration algorithm. The hardware proof-of-concept prototype is built using off-the-shelf RF-analog components and demonstrates excellent cancellation performance. Using four TX test signals with modulation bandwidths of 20~MHz, 40~MHz, 80~MHz, and 120~MHz, the self interference canceller achieves a minimum of 50~dB, 47~dB, 42~dB, and 40~dB of cancellation respectively. This thesis reviews the previously proposed self interference cancellation topologies, system non-idealities that provide challenges for full-duplex implementation, and the realization of the proposed RF-analog self interference canceller

Frequency-Domain Hammerstein Self-Interference Canceller for In-Band Full-Duplex OFDM Systems

In-band full-duplex communications have been spotlighted because they can double the spectral efficiency of the current wireless communication systems. However, it is necessary to mitigate the self-interference (SI). Currently, several time-domain and frequency-domain SI cancellers have been proposed. Timedomain SI cancellers are based on the parallel Hammerstein (PH) model, and they have good flexibility with high computational cost. In contrast, frequency-domain SI cancellers can achieve high cancellation performance with low computational cost but they have less flexibility than time-domain PH based SI cancellers. In this paper, we propose a frequency-domain SI canceller based on the PH model. The proposed scheme estimates the frequency response of the SI channel and regenerates SI signals by the overlap-save method. Therefore, the computational complexity of the proposed scheme is less than time-domain PH based SI canceller. The performance of the proposed scheme is assessed by equivalent baseband signal simulations of a fullduplex transceiver. As a result, the proposed scheme achieves high SI cancellation as the time-domain PH based SI canceller with low computational cost. In addition, the convergence performance of the proposed scheme is faster than the time-domain scheme

High Performance Local Oscillator Design for Next Generation Wireless Communication

Local Oscillator (LO) is an essential building block in modern wireless radios. In modern wireless radios, LO often serves as a reference of the carrier signal to modulate or demod- ulate the outgoing or incoming data. The LO signal should be a clean and stable source, such that the frequency or timing information of the carrier reference can be well-defined. However, as radio architecture evolves, the importance of LO path design has become much more important than before. Of late, many radio architecture innovations have exploited sophisticated LO generation schemes to meet the ever-increasing demands of wireless radio performances. The focus of this thesis is to address challenges in the LO path design for next-generation high performance wireless radios. These challenges include (1) Congested spectrum at low radio frequency (RF) below 5GHz (2) Continuing miniaturization of integrated wireless radio, and (3) Fiber-fast (>10Gb/s) mm-wave wireless communication. The thesis begins with a brief introduction of the aforementioned challenges followed by a discussion of the opportunities projected to overcome these challenges. To address the challenge of congested spectrum at frequency below 5GHz, novel ra- dio architectures such as cognitive radio, software-defined radio, and full-duplex radio have drawn significant research interest. Cognitive radio is a radio architecture that opportunisti- cally utilize the unused spectrum in an environment to maximize spectrum usage efficiency. Energy-efficient spectrum sensing is the key to implementing cognitive radio. To enable energy-efficient spectrum sensing, a fast-hopping frequency synthesizer is an essential build- ing block to swiftly sweep the carrier frequency of the radio across the available spectrum. Chapter 2 of this thesis further highlights the challenges and trade-offs of the current LO gen- eration scheme for possible use in sweeping LO-based spectrum analysis. It follows by intro- duction of the proposed fast-hopping LO architecture, its implementation and measurement results of the validated prototype. Chapter 3 proposes an embedded phase-shifting LO-path design for wideband RF self-interference cancellation for full-duplex radio. It demonstrates a synergistic design between the LO path and signal to perform self-interference cancellation. To address the challenge of continuing miniaturization of integrated wireless radio, ring oscillator-based frequency synthesizer is an attractive candidate due to its compactness. Chapter 4 discussed the difficulty associated with implementing a Phase-Locked Loop (PLL) with ultra-small form-factor. It further proposes the concept sub-sampling PLL with time- based loop filter to address these challenges. A 65nm CMOS prototype and its measurement result are presented for validation of the concept. In shifting from RF to mm-wave frequencies, the performance of wireless communication links is boosted by significant bandwidth and data-rate expansion. However, the demand for data-rate improvement is out-pacing the innovation of radio architectures. A >10Gb/s mm-wave wireless communication at 60GHz is required by emerging applications such as virtual-reality (VR) headsets, inter-rack data transmission at data center, and Ultra-High- Definition (UHD) TV home entertainment systems. Channel-bonding is considered to be a promising technique for achieving >10Gb/s wireless communication at 60GHz. Chapter 5 discusses the fundamental radio implementation challenges associated with channel-bonding for 60GHz wireless communication and the pros and cons of prior arts that attempted to address these challenges. It is followed by a discussion of the proposed 60GHz channel- bonding receiver, which utilizes only a single PLL and enables both contiguous and non- contiguous channel-bonding schemes. Finally, Chapter 6 presents the conclusion of this thesis

Basis Function Selection of Frequency-Domain Hammerstein Self-Interference Canceller for In-Band Full-Duplex Wireless Communications

This paper presents a basis function selection technique of a frequency-domain Hammerstein digital selfinterference canceller for in-band full-duplex communications. The power spectral density (PSD) of the nonlinear selfinterference signal is theoretically analyzed in detail, and a nonlinear self-interference PSD estimation method is developed. The proposed selection technique decides on the basis functions necessary for cancellation and relaxes the computational cost of the frequency-domain Hammerstein canceller based on the estimated PSD of the self-interference of each basis function. Furthermore, the convergence performance of the canceller is improved by the proposed selection technique. Simulation results are then presented, showing that the proposed technique can achieve similar cancellation performance compared with the original frequency-domain Hammerstein canceller and a time-domain nonlinear canceller. Additionally, it is shown that the proposed technique improves the computational cost and the convergence performance of the original frequency-domain Hammerstein canceller

Techniques for Achieving High Isolation in RF Domain for Simultaneous Transmit and Receive

With the growth of wireless data traffic, additional spectrum is required to meet consumer demands. Consequently, innovative approaches are needed for efficient management of the available limited spectrum. To double the achievable spectral efficiency, a transceiver can be designed to receive and transmit signals simultaneously (STAR) across the same frequency band. However, due to the coupling of the high power transmitted signal into the collocated receiver, the receiver\u27s performance is degraded. For successful STAR realization, the coupled high-power transmit (Tx) signal should be suppressed by 100-120 dB over the entire operational bandwidth. So far, most STAR implementations are narrowband, and not useful for ultra wideband (UWB) communications. In this paper, we present a review of novel approaches employed to achieve improved cancellation across wide bandwidths in RF and propagation domains. Both single and multi-antenna systems are considered. Measurements show an average cancellation of 50 dB using two stages of RF signal cancellation