565 research outputs found

    Filter-And-Forward Distributed Beamforming in Relay Networks with Frequency Selective Fading

    Full text link
    A new approach to distributed cooperative beamforming in relay networks with frequency selective fading is proposed. It is assumed that all the relay nodes are equipped with finite impulse response (FIR) filters and use a filter-and-forward (FF) strategy to compensate for the transmitter-to-relay and relay-to-destination channels. Three relevant half-duplex distributed beamforming problems are considered. The first problem amounts to minimizing the total relay transmitted power subject to the destination quality-of-service (QoS) constraint. In the second and third problems, the destination QoS is maximized subject to the total and individual relay transmitted power constraints, respectively. For the first and second problems, closed-form solutions are obtained, whereas the third problem is solved using convex optimization. The latter convex optimization technique can be also directly extended to the case when the individual and total power constraints should be jointly taken into account. Simulation results demonstrate that in the frequency selective fading case, the proposed FF approach provides substantial performance improvements as compared to the commonly used amplify-and-forward (AF) relay beamforming strategy.Comment: Submitted to IEEE Trans. on Signal Processing on 8 July 200

    Software Defined Radio Implementation of Carrier and Timing Synchronization for Distributed Arrays

    Full text link
    The communication range of wireless networks can be greatly improved by using distributed beamforming from a set of independent radio nodes. One of the key challenges in establishing a beamformed communication link from separate radios is achieving carrier frequency and sample timing synchronization. This paper describes an implementation that addresses both carrier frequency and sample timing synchronization simultaneously using RF signaling between designated master and slave nodes. By using a pilot signal transmitted by the master node, each slave estimates and tracks the frequency and timing offset and digitally compensates for them. A real-time implementation of the proposed system was developed in GNU Radio and tested with Ettus USRP N210 software defined radios. The measurements show that the distributed array can reach a residual frequency error of 5 Hz and a residual timing offset of 1/16 the sample duration for 70 percent of the time. This performance enables distributed beamforming for range extension applications.Comment: Submitted to 2019 IEEE Aerospace Conferenc

    Timing estimation and resynchronization for amplify-and-forward communication systems

    Get PDF
    This paper proposes a general framework to effectively estimate the unknown timing and channel parameters, as well as design efficient timing resynchronization algorithms for asynchronous amplify-and-forward (AF) cooperative communication systems. In order to obtain reliable timing and channel parameters, a least squares (LS) estimator is proposed for initial estimation and an iterative maximum-likelihood (ML) estimator is derived to refine the LS estimates. Furthermore, a timing and channel uncertainty analysis based on the CramrRao bounds (CRB) is presented to provide insights into the system uncertainties resulted from estimation. Using the parameter estimates and uncertainty information in our analysis, timing resynchronization algorithms that are robust to estimation errors are designed jointly at the relays and the destination. The proposed framework is developed for different AF systems with varying degrees of timing misalignment and channel uncertainties and is numerically shown to provide excellent performances that approach the synchronized case with perfect channel information. © 2006 IEEE.published_or_final_versio

    Power Allocation in Wireless Relay Networks

    Get PDF
    This thesis is mainly concerned with power allocation issues in wireless relay networks where a single or multiple relays assist transmission from a single or multiple sources to a destination. First, a network model with a single source and multiple relays is considered, in which both cases of orthogonal and non--orthogonal relaying are investigated. For the case of orthogonal relaying, two power allocation schemes corresponding to two partial channel state information (CSI) assumptions are proposed. Given the lack of full and perfect CSI, appropriate signal processing at the relays and/or destination is also developed. The performance behavior of the system with power allocation between the source and the relays is also analyzed. For the case of non-orthogonal relaying, it is demonstrated that optimal power allocation is not sufficiently effective. Instead, a relay beamforming scheme is proposed. A comprehensive comparison between the orthogonal relaying with power allocation scheme and the non-orthogonal relaying with beamforming scheme is then carried out, which reveals several interesting conclusions with respect to both error performance and system throughput. In the second part of the thesis, a network model with multiple sources and a single relay is considered. The transmission model is applicable for uplink channels in cellular mobile systems in which multiple mobile terminals communicate with the base station with the help of a single relay station. Single-carrier frequency division multiple access (SC-FDMA) technique with frequency domain equalization is adopted in order to avoid the amplification of the multiple access interference at the relay. Minimizing the transmit power at the relay and optimizing the fairness among the sources in terms of throughput are the two objectives considered in implementing power allocation schemes. The problems are visualized as water-filling and water-discharging models and two optimal power allocation schemes are proposed, accordingly. Finally, the last part of the thesis is extended to a network model with multiple sources and multiple relays. The orthogonal multiple access technique is employed in order to avoid multiple access interference. Proposed is a joint optimal beamforming and power allocation scheme in which an alternative optimization technique is applied to deal with the non-convexity of the power allocation problem. Furthermore, recognizing the high complexity and large overhead information exchange when the number of sources and relays increases, a relay selection scheme is proposed. Since each source is supported by at most one relay, the feedback information from the destination to each relay can be significantly reduced. Using an equal power allocation scheme, relay selection is still an NP-hard combinatorial optimization problem. Nevertheless, the proposed sub-optimal scheme yields a comparable performance with a much lower computational complexity and can be well suited for practical systems
    corecore