30,965 research outputs found
UHF class E/F2 outphasing transmitter for 12 dB PAPR signals
This paper exploits the degree of freedom provided by the continuous class-E modes in order to reduce the impact of a FET on-state resistance when approximating the zero voltage switching (ZVS) operation along a wide range of resistive loads. A UHF class-E/F2 power amplifier (PA), which includes a lumped element drain terminating network to synthesize the optimal load modulation (LM) trajectory, has been designed to maintain an efficiency as high as possible along an output power control range above 10 dB. Based on this PA, an outphasing scheme in the 700 MHz frequency band has been implemented. It is shown to provide an efficiency higher than 60% up to an output power below 5% (-13 dB) of its peak value (47 W). Under mixed-mode operation and applying digital predistorsion (DPD), a 10 MHz LTE signal with a peak-to-average power ratio (PAPR) as high as 12.2 dB has been linearly reproduced with average efficiency and PAE values of 46.6% and 42.9%, respectively.This work was supported by Spanish Ministry of Science, Innovation and Universities through TEC2017-83343-C4-1-R project, co-funded with FEDER. D. Vegas also thanks for the BES-2015-072203 grant. The support provided by Prof. P. Gilabert and Prof. G. Montoro, UPC, on the GMP-LUT DPD is highly appreciated
Photon State Tomography for Two-Mode Correlated Itinerant Microwave Fields
Continuous variable entanglement between two modes of a radiation field is
usually studied at optical frequencies. As an important step towards the
observation of entanglement between propagating microwave photons we
demonstrate the experimental state reconstruction of two field modes in the
microwave domain. In particular, we generate two-mode correlated states with a
Josephson parametric amplifier and detect all four quadrature components
simultaneously in a two-channel heterodyne setup using amplitude detectors.
Analyzing two-dimensional phase space histograms for all possible pairs of
quadratures allows us to determine the full covariance matrix and reconstruct
the four-dimensional Wigner function. We demonstrate strong correlations
between the quadrature amplitude noise in the two modes. Under ideal conditions
two-mode squeezing below the standard quantum limit should be observable in
future experiments.Comment: 4 pages, 4 figure
RF power generation
This paper reviews the main types of r.f. power amplifiers which are, or may
be, used for particle accelerators. It covers solid-state devices, tetrodes,
inductive output tubes, klystrons, magnetrons, and gyrotrons with power outputs
greater than 10 kW c.w. or 100 kW pulsed at frequencies from 50 MHz to 30 GHz.
Factors affecting the satisfactory operation of amplifiers include cooling,
matching and protection circuits are discussed. The paper concludes with a
summary of the state of the art for the different technologies.Comment: 35 pages, contribution to the CAS - CERN Accelerator School:
Specialised Course on RF for Accelerators; 8 - 17 Jun 2010, Ebeltoft, Denmar
An Octave-Range, Watt-Level, Fully-Integrated CMOS Switching Power Mixer Array for Linearization and Back-Off-Efficiency Improvement
The power mixer array is presented as a novel power generation approach for non-constant envelope signals. It comprises several power mixer units that are dynamically turned on and off to improve the linearity and back-off efficiency. At the circuit level, the power mixer unit can operate as a switching amplifier to achieve high peak power efficiency. Additional circuit level linearization and back-off efficiency improvement techniques are also proposed. To demonstrate the feasibility of this idea, a fully-integrated octave-range CMOS power mixer array is implemented in a 130 nm CMOS process. It is operational between 1.2 GHz and 2.4 GHz and can generate an output power of +31.3 dBm into an external 50 Ω load with a PAE of 42% and a gain compression of only 0.4 dB at 1.8 GHz. It achieves a PAE of 25%, at an average output power of +26.4 dBm, and an EVM of 4.6% with a non-constant-envelope 16 QAM signal. It can also produce arbitrary signal levels down to -70 dBm of output power with the 16 QAM-modulated signal without any RF gain control circuit
Strong and uniform convergence in the teleportation simulation of bosonic Gaussian channels
In the literature on the continuous-variable bosonic teleportation protocol
due to [Braunstein and Kimble, Phys. Rev. Lett., 80(4):869, 1998], it is often
loosely stated that this protocol converges to a perfect teleportation of an
input state in the limit of ideal squeezing and ideal detection, but the exact
form of this convergence is typically not clarified. In this paper, I
explicitly clarify that the convergence is in the strong sense, and not the
uniform sense, and furthermore, that the convergence occurs for any input state
to the protocol, including the infinite-energy Basel states defined and
discussed here. I also prove, in contrast to the above result, that the
teleportation simulations of pure-loss, thermal, pure-amplifier, amplifier, and
additive-noise channels converge both strongly and uniformly to the original
channels, in the limit of ideal squeezing and detection for the simulations.
For these channels, I give explicit uniform bounds on the accuracy of their
teleportation simulations. I then extend these uniform convergence results to
particular multi-mode bosonic Gaussian channels. These convergence statements
have important implications for mathematical proofs that make use of the
teleportation simulation of bosonic Gaussian channels, some of which have to do
with bounding their non-asymptotic secret-key-agreement capacities. As a
byproduct of the discussion given here, I confirm the correctness of the proof
of such bounds from my joint work with Berta and Tomamichel from [Wilde,
Tomamichel, Berta, IEEE Trans. Inf. Theory 63(3):1792, March 2017].
Furthermore, I show that it is not necessary to invoke the energy-constrained
diamond distance in order to confirm the correctness of this proof.Comment: 19 pages, 3 figure
Selective readout and back-action reduction for wideband acoustic gravitational wave detectors
We present the concept of selective readout for broadband resonant mass
gravitational wave detectors. This detection scheme is capable of specifically
selecting the signal from the contributions of the vibrational modes sensitive
to the gravitational waves, and efficiently rejecting the contribution from non
gravitationally sensitive modes. Moreover this readout, applied to a dual
detector, is capable to give an effective reduction of the back-action noise
within the frequency band of interest. The overall effect is a significant
enhancement in the predicted sensitivity, evaluated at the standard quantum
limit for a dual torus detector. A molybdenum detector, 1 m in diameter and
equipped with a wide area selective readout, would reach spectral strain
sensitivities 2x10^{-23}/sqrt{Hz} between 2-6 kHz.Comment: 9 pages, 4 figure
Spatiotemporal self-similar fiber laser
In this Letter, we demonstrate, to the best of our knowledge, the first
spatiotemporally mode-locked fiber laser with self-similar pulse evolution. The
multimode fiber oscillator generates parabolic amplifier similaritons at 1030
nm with 90 mW average power, 2.3 ps duration, and 37.9 MHz repetition rate.
Remarkably, we observe experimentally a near-Gaussian beam quality (M^2<1.4) at
the output of the highly multimode fiber. The output pulses are compressed to
192 fs via an external grating compressor. Numerical simulations are performed
to investigate the cavity dynamics which confirm experimental observations of
self-similar pulse propagation. The reported results open a new direction to
investigate new types of pulse besides beam shaping and nonlinear dynamics in
spatiotemporal mode-locked fiber lasers.Comment: 8 pages, 5 figure
Conditional teleportation using optical squeezers and photon counting
We suggest a scheme of using two-mode squeezed vacuum for conditional
teleportation of quantum states of optical field. Alice mixes the input state
with one of the squeezed modes on another squeezing device and detects the
output photon numbers. The result is then communicated to Bob who shifts the
photon number of his part accordingly. This is a principally realizable
modification of the recent scheme [G.J. Milburn and S.L. Braunstein, Phys. Rev.
A 60, 937 (1999)] where measurements of photon number difference and phase sum
are considered. We show that for some classes of states this method can yield
very high fidelity of teleportation, nevertheless, the success probability may
be limited.Comment: 5 pages, 4 figures; notations simplified, more explicit explanatio
- âŠ