Single-Carrier Modulation versus OFDM for Millimeter-Wave Wireless MIMO

This paper presents results on the achievable spectral efficiency and on the energy efficiency for a wireless multiple-input-multiple-output (MIMO) link operating at millimeter wave frequencies (mmWave) in a typical 5G scenario. Two different single-carrier modem schemes are considered, i.e., a traditional modulation scheme with linear equalization at the receiver, and a single-carrier modulation with cyclic prefix, frequency-domain equalization and FFT-based processing at the receiver; these two schemes are compared with a conventional MIMO-OFDM transceiver structure. Our analysis jointly takes into account the peculiar characteristics of MIMO channels at mmWave frequencies, the use of hybrid (analog-digital) pre-coding and post-coding beamformers, the finite cardinality of the modulation structure, and the non-linear behavior of the transmitter power amplifiers. Our results show that the best performance is achieved by single-carrier modulation with time-domain equalization, which exhibits the smallest loss due to the non-linear distortion, and whose performance can be further improved by using advanced equalization schemes. Results also confirm that performance gets severely degraded when the link length exceeds 90-100 meters and the transmit power falls below 0 dBW.Comment: accepted for publication on IEEE Transactions on Communication

Simulation of Few Mode Fiber Communication System Using Adaptive Recursive least Square Algorithm

The constant demand of faster mode of communication has revolutionized the technology related to optical fiber communication system. The large member of global researchers are using space division multiplexing (SDM).The research is motivated by the urgent industrial requirement. This technology has sample of scope of improving the channel space. The few mode fiber (FMF) communication system improvement using adaptive algorithm has few issues which are posing the challenges like intermodal noise due to compiling in a random manner .It has some delay which needs to be taken care of is called as differential mode group delay (DMGD).In this work, Recursive Least Square (RLS) has been promised. This yield the convergence faster but at the cost of complex hardware. The FD-LMS algorithm has been considered as a reference. A step size controlled has been put to work. In the reference work the FD-LMS appears to better than LMS algorithm

A Review on Advancements in Optical Communication System

Communication systems are revolutionized by the tremendous research being done in this direction. The need is the mother of the invention. The need of data transfer in increasing every day. There is the big demand for the fast optical communication systems. The optical fibers have the big potential of carrying the different channels which can transmit the data at amazing speed. In this work we have studied the research done in the field of technological development taking place in fiber communication system. The focus is on the use of fiber link as a modern medium of communication in the optical range.Communication system, Optical data transfer, Channel, Fiber link, Optical range

Doctor of Philosophy

dissertationThe demand for high speed communication has been increasing in the past two decades. Multicarrier communication technology has been suggested to address this demand. Orthogonal frequency-division multiplexing (OFDM) is the most widely used multicarrier technique. However, OFDM has a number of disadvantages in time-varying channels, multiple access, and cognitive radios. On the other hand, filterbank multicarrier (FBMC) communication has been suggested as an alternative to OFDM that can overcome the disadvantages of OFDM. In this dissertation, we investigate the application of filtered multitone (FMT), a subset of FBMC modulation methods, to slow fading and fast fading channels. We investigate the FMT transmitter and receiver in continuous and discrete time domains. An efficient implementation of FMT systems is derived and the conditions for perfect reconstruction in an FBMC communication system are presented. We derive equations for FMT in slow fading channels that allow evaluation of FMT when applied to mobile wireless communication systems. We consider using fractionally spaced per tone channel equalizers with different number of taps. The numerical results are presented to investigate the performance of these equalizers. The numerical results show that single-tap equalizers suffice for typical wireless channels. The equalizer design study is advanced by introducing adaptive equalizers which use channel estimation. We derive equations for a minimum mean square error (MMSE) channel estimator and improve the channel estimation by considering the finite duration of channel impulse response. The results of optimum equalizers (when channel is known perfectly) are compared with those of the adaptive equalizers, and it is found that a loss of 1 dB or less incurs. We also introduce a new form of FMT which is specially designed to handle doubly dispersive channels. This method is called FMT-dd (FMT for doubly dispersive channels). The proposed FMT-dd is applied to two common methods of data symbol orientation in the time-frequency space grid; namely, rectangular and hexagonal lattices. The performance of these methods along with OFDM and the conventional FMT are compared and a significant improvement in performance is observed. The FMT-dd design is applied to real-world underwater acoustic (UWA) communication channels. The experimental results from an at-sea experiment (ACOMM10) show that this new design provides a significant gain over OFDM. The feasibility of implementing a MIMO system for multicarrier UWA communication channels is studied through computer simulations. Our study emphasizes the bandwidth efficiency of multicarrier MIMO communications .We show that the value of MIMO to UWA communication is very limited

Adaptive equalizers for multipath compensation in digital microwave communications

SIGLEAvailable from British Library Document Supply Centre- DSC:D82998 / BLDSC - British Library Document Supply CentreGBUnited Kingdo

Near far resistant detection for CDMA personal communication systems.

The growth of Personal Communications, the keyword of the 90s, has already the signs of a technological revolution. The foundations of this revolution are currently set through the standardization of the Universal Mobile Telecommunication System (UMTS), a communication system with synergistic terrestrial and satellite segments. The main characteristic of the UMTS radio interface, is the provision of ISDN services. Services with higher than voice data rates require more spectrum, thus techniques that utilize spectrum as efficiently as possible are currently at the forefront of the research community interests. Two of the most spectrally efficient multiple access technologies, namely. Code Division Multiple Access (CDMA) and Time Division Multiple Access (TDMA) concentrate the efforts of the European telecommunity.This thesis addresses problems and. proposes solutions for CDMA systems that must comply with the UMTS requirements. Prompted by Viterbi's call for further extending the potential of CDMA through signal processing at the receiving end, we propose new Minimum Mean Square Error receiver architectures. MMSE detection schemes offer significant advantages compared to the conventional correlation based receivers as they are NEar FAr Resistant (NEFAR) over a wide range of interfering power levels. The NEFAR characteristic of these detectors reduces considerably the requirements of the power control loops currently found in commercial CDMA systems. MMSE detectors are also found, to have significant performance gains over other well established interference cancellation techniques like the decorrelating detector, especially in heavily loaded system conditions. The implementation architecture of MMSE receivers can be either Multiple-Input Multiple Output (MIMO) or Single-Input Single-Output. The later offers not only complexity that is comparable to the conventional detector, but also has the inherent advantage of employing adaptive algorithms which can be used to provide both the dispreading and the interference cancellation function, without the knowledge of the codes of interfering users. Furthermore, in multipath fading channels, adaptive MMSE detectors can exploit the multipath diversity acting as RAKE combiners. The later ability is distinctive to MMSE based receivers, and it is achieved in an autonomous fashion, without the knowledge of the multipath intensity profile. The communicator achieves its performance objectives by the synergy of the signal processor and the channel decoder. According to the propositions of this thesis, the form of the signal processor needs to be changed, in order to exploit the horizons of spread spectrum signaling. However, maximum likelihood channel decoding algorithms need not change. It is the way that these algorithms are utilized that needs to be revis ed. In this respect, we identify three major utilization scenarios and an attempt is made to quantify which of the three best matches the requirements of a UMTS oriented CDMA radio interface. Based on our findings, channel coding can be used as a mapping technique from the information bit to a more ''intelligent" chip, matching the ''intelligence" of the signal processor

Estimation and detection techniques for doubly-selective channels in wireless communications

A fundamental problem in communications is the estimation of the channel. The signal transmitted through a communications channel undergoes distortions so that it is often received in an unrecognizable form at the receiver. The receiver must expend significant signal processing effort in order to be able to decode the transmit signal from this received signal. This signal processing requires knowledge of how the channel distorts the transmit signal, i.e. channel knowledge. To maintain a reliable link, the channel must be estimated and tracked by the receiver. The estimation of the channel at the receiver often proceeds by transmission of a signal called the 'pilot' which is known a priori to the receiver. The receiver forms its estimate of the transmitted signal based on how this known signal is distorted by the channel, i.e. it estimates the channel from the received signal and the pilot. This design of the pilot is a function of the modulation, the type of training and the channel. [Continues.

Channel equalization to achieve high bit rates in discrete multitone systems

textMulticarrier modulation (MCM) techniques such as orthogonal frequency division multiplexing (OFDM) and discrete multi-tone (DMT) modulation are attractive for high-speed data communications due to the ease with which MCM can combat channel dispersion. With all the benefits MCM could give, DMT modulation has an extra ability to perform dynamic bit loading, which has the potential to exploit fully the available bandwidth in a slowly time-varying channel. In broadband wireline communications, DMT modulation is standardized for asymmetric digital subscribe line (ADSL) and very-high-bit-rate digital subscriber line (VDSL) modems. ADSL and VDSL standards are used by telephone companies to provide high speed data service to residences and offices. In an ADSL receiver, an equalizer is required to compensate for the channel’s dispersion in the time domain and the channel’s distortion in the frequency domain of the transmitted waveform. This dissertation proposes design methods for linear equalizers to increase the bit rate of the connection. The methods are amenable to implementation on programmable fixed-point digital signal processors, which are employed in ADSL/VDSL transceivers. A conventional ADSL equalizer consists of a time-domain equalizer, a fast Fourier transform, and a frequency domain equalizer. The time domain equalizer (TEQ) is a finite impulse response filter that when coupled with a discretized channel produces an equivalent channel whose impulse response is shorter than that of the discretized channel. This channel shortening is required by the ADSL standards. In this dissertation, I first propose a linear phase TEQ design that exploits symmetry in existing eigen-filter approaches such as minimum mean square error(MMSE), maximum shortening signal to noise ratio (MSSNR) and minimum intersymbol interference (Min-ISI) equalizers. TEQs with symmetric coefficients can reach the same performance as non-symmetric ones with much lower training complexity. Second, I improve Min-ISI design. I reformulate the cost function to make long TEQs design feasible. I remove the dependency of transmission delay in order to reduce the complexity associated with delay optimization. The quantized weighting is introduced to further lower the complexity. I also propose an iterative optimization procedure of Min-ISI that completely avoids Cholesky decomposition hence is better suited for a fixed-point implementation. Finally I propose a dual-path TEQ structure, which designs a standard singleFIR TEQ to achieve good bit rate over the entire transmission bandwidth, and designs another FIR TEQ to improve the bit rate over a subset of subcarriers. Dualpath TEQ can be viewed as a special case of a complex valued filter bank structure that delivers the best bit rate of existing DMT equalizers. However, dual-path TEQ provides a very good tradeoff between achievable bit rate vs. implementation complexity on a programmable digital signal processor.Electrical and Computer Engineerin