Fenton and Photo-Fenton like at neutral pH for the removal of emerging contaminants in water and wastewater effluents

[eng] In the last decades, the scientific community has been involved in the research of new kinds of contaminants generally known as of “emerging concern” (CECs). The harmfulness of CECs, even at small concentrations as well as, property of bioaccumulation and persistence, makes them extremely dangerous for the human health. The scientific community is constantly researching about novel treatments able to achieve the removal of these contaminants. Advanced Oxidation Processes (AOPs) are considered one of the most useful treatments to achieve CECs degradation. Among the AOPs, Fenton and photo‐Fenton processes are particularly powerful, cheap and easily managed. Nevertheless, some setting requirements of Fenton processes have limited their application at industrial scale. One of the most important limits is the necessity to operate a tight control of the pH in order to avoid iron precipitation (optimum pH~2.8). Unfortunately, the optimum pH for Fenton reaction is essentially far from the normal values of the wastewater treatment plant (WWTP) effluents. Scientific community is then working on the improvement of the operating conditions of Fenton processes in order to improve the applicability in wastewater treatment. These modifications are essentially focused on the possibility to perform the treatment at circumneutral pH (Fenton and photo‐ Fenton like processes). Fenton like processes can be carried out in heterogeneous or homogeneous way according to the phase of the catalyst into the solution. In this study was firstly confirmed the suitability of Fenton based processes in recalcitrant compounds removal. Fenton, UV‐A photo‐Fenton and UV‐C photo‐Fenton were, in fact, applied for atrazine removal from secondary effluent (SE) of municipal wastewater treatment plant (MWWTP). UV‐A and UV‐C photo‐Fenton allowed remove 50% and 100% of the initial atrazine content respectively. The main objective of this thesis was then the assessment of photo‐Fenton’s suitability for recalcitrant contaminant at circumneutral pH. Thus, homogeneous photo‐Fenton like at neutral pH was applied for sulfamethoxazole (SMX) removal. In order to avoid iron precipitation, chelating agents were used to keep soluble the iron at circumneutral pH. The chelating ability of four chelating agents (ethylenediaminetetraacetic acid‐EDTA, nitrilotriacetic acid‐NTA, oxalic acid and tartaric acid) was tested. Then, once determined the optimum molar ratio L:Fe for iron chelation (1.5:1 for EDTA and NTA, 10:1 for tartaric acid and 20:1 for oxalic acid), their catalytic activity was evaluated when employed in photo‐Fenton like for SMX removal. The highest SMX percentage removal, together with the minimum chelating agents required and the better property of biodegradability and low toxicity, demonstrated the suitability of NTA for the purpose. A further study on the stability of the chelates under reaction was carried out. The operating conditions adopted for the treatment significantly influence the stability of the chelate solution. Thus, in order to proper control the parameter set up the behavior of chelates has been study under thermal, oxidative and photochemical stress. It was demonstrated as the temperature control can represent an interesting tool to extend the chelates lifetime under oxidative and photochemical stress. By adopting different H2O2 doses, a linear correlation between doses and chelate decomposition could be identified. The better suitability of UV‐A irradiation, against UV‐C and Xe lamp, to preserve the iron chelate solution was demonstrated. Moreover, the influence of the influent characteristics on the process efficiency needed to be also considered. Thus, different water matrices were used for the experiments. The efficiency of photo‐Fenton like catalyzed by Fe(III)‐NTA has been compared when applied to different aqueous matrixes (Milli‐Q water, tap water, secondary effluent wastewater and well water). It was demonstrated as the ions content, especially Ca2+ and Mg2+, significantly compromise the process of chelation. High alkalinities and organic matter, instead, mainly influenced the phase of process, when acting as radicals scavengers, reduced the amount available for SMX oxidation. Some strategies were then adopted to promote SMX removal. Between them, Mn2+ mediated photo‐Fenton like showed somehow possibility for improvement. Highest removal rate was in fact exhibited in the first minutes of reaction when adding Mn2+ to the solution in ratio molar Mn:Fe 0.5:1. The conclusive study of the thesis regarded the assessment of the Br‐ presence on the efficiency achievable in recalcitrant compounds removal when applying UV/PS/Fe2+ for removal of benzophenone‐4 (BZ4), nitrobenzene (NB), nitrobenzoic acid (NBA), atrazine (ATZ) and ampicilline (AMP). Br‐ demostrated to be a strong inhibitor in the removal of all the considered contaminants except for NB when, the removal was instead enhanced in bromide containing water

Investigations into the Occurrence, Formation and Fate of N-Nitrosodimethylamine (NDMA) in Air and Water

abstract: N-Nitrosodimethylamine (NDMA), a probable human carcinogen, has been found in clouds and fogs at concentration up to 500 ng/L and in drinking water as disinfection by-product. NDMA exposure to the general public is not well understood because of knowledge gaps in terms of occurrence, formation and fate both in air and water. The goal of this dissertation was to contribute to closing these knowledge gaps on potential human NDMA exposure through contributions to atmospheric measurements and fate as well as aqueous formation processes. Novel, sensitive methods of measuring NDMA in air were developed based on Solid Phase Extraction (SPE) and Solid Phase Microextraction (SPME) coupled to Gas Chromatography-Mass Spectrometry (GC-MS). The two measuring techniques were evaluated in laboratory experiments. SPE-GC-MS was applicable in ambient air sampling and NDMA in ambient air was found in the 0.1-13.0 ng/m3 range. NDMA photolysis, the main degradation atmospheric pathway, was studied in the atmospheric aqueous phase. Water soluble organic carbon (WSOC) was found to have more impact than inorganic species on NDMA photolysis by competing with NDMA for photons and therefore could substantially increase the NDMA lifetime in the atmosphere. The optical properties of atmospheric WSOC were investigated in aerosol, fog and cloud samples and showed WSOC from atmospheric aerosols has a higher mass absorption efficiency (MAE) than organic matter in fog and cloud water, resulting from a different composition, especially in regards of volatile species, that are not very absorbing but abundant in fogs and clouds. NDMA formation kinetics during chloramination were studied in aqueous samples including wastewater, surface water and ground water, at two monochloramine concentrations. A simple second order NDMA formation model was developed using measured NDMA and monochloramine concentrations at select reaction times. The model fitted the NDMA formation well (R2 >0.88) in all water matrices. The proposed model was then optimized and applied to fit the data of NDMA formation from natural organic matter (NOM) and model precursors in previously studies. By determining the rate constants, the model was able to describe the effect of water conditions such as DOC and pH on NDMA formation.Dissertation/ThesisDoctoral Dissertation Chemistry 201

Environmental Fate of Emerging Organic Micro-Contaminants

The toxicity and fate of pharmaceuticals and other emerging micro-organic contaminants in the natural and built environments have been the focus of much research over the last twenty years. Particular focus has recently centred on the fate of antimicrobial chemicals, including antibiotics and antifungals. The occurrence of such chemicals in the environment is thought to contribute to the selection of resistance in exposed microorganisms.This Special Issue (SI) brings together a broad range of recent advances in the field of emerging micro-organic contaminants, ranging from medicinal contaminants to industrial chemicals in the environment. Notably, these range from chemical extraction and large-scale analysis to adverse effects on non-target aquatic organisms and potential risk to humans via contaminated foodstuffs. Additionally, this Special Issue also presents novel contaminant treatment/degradation methods of both physical and biological nature