Test Modules Design for a SerDes Chip in 130 nm CMOS technology

In this thesis, a DFT architecture is proposed for testing a high-speed SerDes circuit. This architecture suggests the implementation of three testing modules: a comparator, a linear-feedback shift register (LFSR) and a signal driver. By embedding these test modules to the SerDes, the circuit will be able to perform eight different operating modes for testing in addition to the functional mode. With these operating modes, the functionality of all the modules individually and collectively can be tested by the use of multiplexers and BIST.Consejo Nacional de Ciencia y Tecnologí

From FPGA to ASIC: A RISC-V processor experience

This work document a correct design flow using these tools in the Lagarto RISC- V Processor and the RTL design considerations that must be taken into account, to move from a design for FPGA to design for ASIC

Methodology and Ecosystem for the Design of a Complex Network ASIC

Performance of HPC systems has risen steadily. While the 10 Petaflop/s barrier has been breached in the year 2011 the next large step into the exascale era is expected sometime between the years 2018 and 2020. The EXTOLL project will be an integral part in this venture. Originally designed as a research project on FPGA basis it will make the transition to an ASIC to improve its already excelling performance even further. This transition poses many challenges that will be presented in this thesis. Nowadays, it is not enough to look only at single components in a system. EXTOLL is part of complex ecosystem which must be optimized overall since everything is tightly interwoven and disregarding some aspects can cause the whole system either to work with limited performance or even to fail. This thesis examines four different aspects in the design hierarchy and proposes efficient solutions or improvements for each of them. At first it takes a look at the design implementation and the differences between FPGA and ASIC design. It introduces a methodology to equip all on-chip memory with ECC logic automatically without the user’s input and in a transparent way so that the underlying code that uses the memory does not have to be changed. In the next step the floorplanning process is analyzed and an iterative solution is worked out based on physical and logical constraints of the EXTOLL design. Besides, a work flow for collaborative design is presented that allows multiple users to work on the design concurrently. The third part concentrates on the high-speed signal path from the chip to the connector and how it is affected by technological limitations. All constraints are analyzed and a package layout for the EXTOLL chip is proposed that is seen as the optimal solution. The last part develops a cost model for wafer and package level test and raises technological concerns that will affect the testing methodology. In order to run testing internally it proposes the development of a stand-alone test platform that is able to test packaged EXTOLL chips in every aspect

REDUCING POWER DURING MANUFACTURING TEST USING DIFFERENT ARCHITECTURES

Power during manufacturing test can be several times higher than power consumption in functional mode. Excessive power during test can cause IR drop, over-heating, and early aging of the chips. In this dissertation, three different architectures have been introduced to reduce test power in general cases as well as in certain scenarios, including field test. In the first architecture, scan chains are divided into several segments. Every segment needs a control bit to enable capture in a segment when new faults are detectable on that segment for that pattern. Otherwise, the segment should be disabled to reduce capture power. We group the control bits together into one or more control chains. To address the extra pin(s) required to shift data into the control chain(s) and significant post processing in the first architecture, we explored a second architecture. The second architecture stitches the control bits into the chains they control as EECBs (embedded enable capture bits) in between the segments. This allows an ATPG software tool to automatically generate the appropriate EECB values for each pattern to maintain the fault coverage. This also works in the presence of an on-chip decompressor. The last architecture focuses primarily on the self-test of a device in a 3D stacked IC when an existing FPGA in the stack can be programmed as a tester. We show that the energy expended during test is significantly less than would be required using low power patterns fed by an on-chip decompressor for the same very short scan chains