Wireless broadband access: WiMAX and beyond - Investigation of bandwidth request mechanisms under point-to-multipoint mode of WiMAX networks

The WiMAX standard specifies a metropolitan area broadband wireless access air interface. In order to support QoS for multimedia applications, various bandwidth request and scheduling mechanisms are suggested in WiMAX, in which a subscriber station can send request messages to a base station, and the base station can grant or reject the request according to the available radio resources. This article first compares two fundamental bandwidth request mechanisms specified in the standard, random access vs. polling under the point-to-multipoint mode, a mandatory transmission mode. Our results demonstrate that random access outperforms polling when the request rate is low. However, its performance degrades significantly when the channel is congested. Adaptive switching between random access and polling according to load can improve system performance. We also investigate the impact of channel noise on the random access request mechanism

Performance evaluation of fixed WiMax physical layer under high fading channels

This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University.A radio channel characteristic modelling is essential in every network planning. This project deals with the performance of WiMax networks in an outdoor environment while using fading channel models. The radio channels characteristics are analyzed by simulations have been done using Matlab programming. Stanford University Interim(SUI) Channels set was proposed to simulate the fixed broadband wireless access channel environments where IEEE 802.16d is to be deployed. It has six channel models that are grouped into three categories according to three typical different outdoor Terrains, in order to give a comprehensive study of fading channels on the overall performance of the system, WiMax system has been tested under SUI channels that modified into account for 30o directional antennas, with 90% cell coverage and with 99.9% reliability in its geographical covered area. Furthermore, in order to combat the fading which occurs in urban areas and improve the capacity and the throughput of the system, multiples antennas at both ends of communication link are used, the transmission gain obtained when using multiple antennas instead of only a single antenna. Space-time coding and maximum ratio combining for more than one transmit and receive antenna is implemented to allow performance investigations in various MIMO scenarios. It has been concluded that uses multiple antennas at the receiver offers a significant improvement of 3 dB of gain in the channel SNR. This thesis also contain implementation of all compulsory features of the WiMax OFDM physical layer specified in IEEE 802.16-2004 using Matlab coding. In order to combat the temporal variations in quality on a multipath fading channel, an adaptive modulation technique is used. This technique employs multiple modulation schemes to instantaneously adapt to the variations in the channel SNR, thus maximizing the system throughput and improving BER performance. WiMax transceiver has been tested with and without encoding and studied the effect of encoding on multipath channel. Testing the system with flexible channel bandwidth has been part of this thesis. Finally it has been explained in this thesis the affect of increasing the size of cyclic prefix on overall performance of WiMax system

A Performance Analysis Framework for WiFi/WiMAX Heterogeneous Metropolitan Networks Based on Cross-Layer Design

The communication between network nodes within different protocol domains is often regarded simply as a black box with unknown configuration conditions in the path. We address network heterogeneity using a white box approach and focus on its interconnection processes. To achieve this purpose, a Performance Analysis Framework (PAF) is proposed which is composed of the formalization of the latter using process algebra (PA) and the corresponding teletraffic performance models. In this contribution, we target the IEEE 802.16 and IEEE 802.11 protocols. For the teletraffic models, we extend previous models for such scenario with the inclusion of the following protocol operational parameters (metrics): bit error rate (BER), packet error ratio (PER), and packet length (pl). From the framework teletraffic models, the optimal packet length (OPL), end to end throughput, delay, and packet loss are obtained. The PAF outperforms previous modeling solutions in terms of delay and throughput relative to NS3 simulation results. </jats:p

Performance evaluation of broadband fixed wireless system based on IEEE 802.16

Fixed Wireless Access systems operating below 11 GHz have the potential to provide broadband wireless access for non line-of-sight operation. In this paper the performance of a typical broadband fixed wireless system based on the IEEE 802.16-2004 specifications is determined. A scenario for business applications with outdoor customer premises equipment is investigated in the 3.5 GHz frequency band. Different path loss models and terrain types are considered. Coverage and throughput in a sector are determined for this business scenario

A baseband wireless spectrum hypervisor for multiplexing concurrent OFDM signals

The next generation of wireless and mobile networks will have to handle a significant increase in traffic load compared to the current ones. This situation calls for novel ways to increase the spectral efficiency. Therefore, in this paper, we propose a wireless spectrum hypervisor architecture that abstracts a radio frequency (RF) front-end into a configurable number of virtual RF front ends. The proposed architecture has the ability to enable flexible spectrum access in existing wireless and mobile networks, which is a challenging task due to the limited spectrum programmability, i.e., the capability a system has to change the spectral properties of a given signal to fit an arbitrary frequency allocation. The proposed architecture is a non-intrusive and highly optimized wireless hypervisor that multiplexes the signals of several different and concurrent multi-carrier-based radio access technologies with numerologies that are multiple integers of one another, which are also referred in our work as radio access technologies with correlated numerology. For example, the proposed architecture can multiplex the signals of several Wi-Fi access points, several LTE base stations, several WiMAX base stations, etc. As it able to multiplex the signals of radio access technologies with correlated numerology, it can, for instance, multiplex the signals of LTE, 5G-NR and NB-IoT base stations. It abstracts a radio frequency front-end into a configurable number of virtual RF front ends, making it possible for such different technologies to share the same RF front-end and consequently reduce the costs and increasing the spectral efficiency by employing densification, once several networks share the same infrastructure or by dynamically accessing free chunks of spectrum. Therefore, the main goal of the proposed approach is to improve spectral efficiency by efficiently using vacant gaps in congested spectrum bandwidths or adopting network densification through infrastructure sharing. We demonstrate mathematically how our proposed approach works and present several simulation results proving its functionality and efficiency. Additionally, we designed and implemented an open-source and free proof of concept prototype of the proposed architecture, which can be used by researchers and developers to run experiments or extend the concept to other applications. We present several experimental results used to validate the proposed prototype. We demonstrate that the prototype can easily handle up to 12 concurrent physical layers

Motorized cart

Motorized cart is known as an effective tool and timeless that help people carry heavy loads. For farmers, it has an especially vital tool for moving goods. Oil palm farmers typically uses the wheelbarrow to move the oil palm fruit (Figure 10.1). However, there is a lack of equipment that should be further enhanced in capabilities. Motorized carts that seek to add automation to wheelbarrow as it is to help people save manpower while using it. At present, oil palm plantation industry is among the largest in Malaysia. However, in an effort to increase the prestige of the industry to a higher level there are challenges to be faced. Shortage of workers willing to work the farm for harvesting oil palm has given pain to manage oil palm plantations. Many have complained about the difficulty of hiring foreign workers and a high cost. Although there are tools that can be used to collect or transfer the proceeds of oil palm fruits such as carts available. However, these tools still have the disadvantage that requires high manpower to operate. Moreover, it is not suitable for all land surfaces and limited cargo space. Workload and manpower dependence has an impact on farmers' income