Routing and Broadcast Development for Minimizing Transmission Interruption in Multi rate Wireless Mesh Networks using Directional Antennas

Using directional antennas to reduce interference and improve throughput in multi hop wireless networks has attracted much attention from the research community in recent years. In this paper, we consider the issue of minimum delay broadcast in multi rate wireless mesh networks using directional antennas. We are given a set of mesh routers equipped with directional antennas, one of which is the gateway node and the source of the broadcast. Our objective is to minimize the total transmission delay for all the other nodes to receive a broadcast packet from the source, by determining the set of relay nodes and computing the number and orientations of beams formed by each relay node. We propose a heuristic solution with two steps. Firstly, we construct a broadcast routing tree by defining a new routing metric to select the relay nodes and compute the optimal antenna beams for each relay node. Then, we use a greedy method to make scheduling of concurrent transmissions without causing beam interference. Extensive simulations have demonstrated that our proposed method can reduce the broadcast delay significantly compared with the methods using omnidirectional antennas and single-rate transmission. In addition, the results also show that our method performs better than the method with fixed antenna beams. Keywords: Multihop, Wireless, Mesh, Omnidirectional 

A Hybrid Model to Extend Vehicular Intercommunication V2V through D2D Architecture

In the recent years, many solutions for Vehicle to Vehicle (V2V) communication were proposed to overcome failure problems (also known as dead ends). This paper proposes a novel framework for V2V failure recovery using Device-to-Device (D2D) communications. Based on the unified Intelligent Transportation Systems (ITS) architecture, LTE-based D2D mechanisms can improve V2V dead ends failure recovery delays. This new paradigm of hybrid V2V-D2D communications overcomes the limitations of traditional V2V routing techniques. According to NS2 simulation results, the proposed hybrid model decreases the end to end delay (E2E) of messages delivery. A complete comparison of different D2D use cases (best & worst scenarios) is presented to show the enhancements brought by our solution compared to traditional V2V techniques.Comment: 6 page

Development of novel backscatter communication systems using a multi-hop framework and distributed beamforming

The goal of this thesis it to develop a wireless networking framework for battery-free devices based on passive, backscatter communication. In contrast to traditional, active communication systems, where the radio signal has to be generated using large amount of energy from batteries, the passive systems reflect the RF signal. The information is encoded by modulating the reflected signal, which consumes significantly less energy than active transmission. The existing passive, backscatter systems have limited communication capabilities. For example, the Radio Frequency Identification (RFID) systems support short-distance, direct communication between active reader and passive tags. The communication range is limited due to power and sensitivity limitations of transmitters and receivers respectively. Moreover, in contrast to a multi-hop ad hoc and sensor networks, the traditional backscatter systems limit themselves to a single-hop topology due to limited capabilities of passive tags and different challenges in passive communication. Existing literature lacks of understanding how such multi-hop, passive, and asymmetric networks can be realized and what are their theoretical limits. This thesis aims at understanding the communication and coverage challenge in backscatter systems and addressing them through: (a) a distributed beamforming that increases the transmission range to a specific tag/location (PAPER I), and (b) a multi-hop framework for the backscatter communication that increases effective communication range (PAPER II). The proposed beamforming methodology employs spatially distributed, passive scattering devices located between transmitter and receiver to increase the RF signal strength. The theoretical limits of such scheme are analyzed mathematically and in simulations with two beamforming approaches being proposed. Furthermore, a novel architecture is proposed for multi-hop backscatter-based networking for a passive RF communication that is not currently present. The paper presents the generic analysis of the system capabilities and demonstrates the feasibility of such multi-hop network. Furthermore, the connectivity models are studied in terms of k-connectivity of such a network of tags --Abstract, page iv

Improving the Performance of Medium Access Control Protocols for Mobile Adhoc Network with Smart Antennas

Requirements for high quality links and great demand for high throughput in Wireless LAN especially Mobile Ad-hoc Network has motivated new enhancements and work in Wireless communications such as Smart Antenna Systems. Smart (adaptive) Antennas enable spatial reuse, increase throughput and they increase the communication range because of the increase directivity of the antenna array. These enhancements quantified for the physical layer may not be efficiently utilized, unless the Media Access Control (MAC) layer is designed accordingly. This thesis implements the behaviours of two MAC protocols, ANMAC and MMAC protocols in OPNET simulator. This method is known as the Physical-MAC layer simulation model. The entire physical layer is written in MATLAB, and MATLAB is integrated into OPNET to perform the necessary stochastic physical layer simulations. The aim is to investigate the performance improvement in throughput and delay of the selected MAC Protocols when using Smart Antennas in a mobile environment. Analytical methods were used to analyze the average throughput and delay performance of the selected MAC Protocols with Adaptive Antenna Arrays in MANET when using spatial diversity. Comparison study has been done between the MAC protocols when using Switched beam antenna and when using the proposed scheme. It has been concluded that the throughput and delay performance of the selected protocols have been improved by the use of Adaptive Antenna Arrays. The throughput and delay performance of ANMAC-SW and ANMAC-AA protocols was evaluated in details against regular Omni 802.11 stations. Our results promise significantly enhancement over Omni 802.11, with a throughput of 25% for ANMAC-SW and 90% for ANMC-AA. ANMAC-AA outperforms ANMAC-SW protocol by 60%. Simulation experiments indicate that by using the proposed scheme with 4 Adaptive Antenna Array per a node, the average throughput in the network can be improved up to 2 to 2.5 times over that obtained by using Switched beam Antennas. The proposed scheme improves the performances of both ANMAC and MMAC protocols but ANMAC outperforms MMAC by 30%

Optimisation of Mobile Communication Networks - OMCO NET

The mini conference “Optimisation of Mobile Communication Networks” focuses on advanced methods for search and optimisation applied to wireless communication networks. It is sponsored by Research & Enterprise Fund Southampton Solent University. The conference strives to widen knowledge on advanced search methods capable of optimisation of wireless communications networks. The aim is to provide a forum for exchange of recent knowledge, new ideas and trends in this progressive and challenging area. The conference will popularise new successful approaches on resolving hard tasks such as minimisation of transmit power, cooperative and optimal routing

Full-duplex wireless communications: challenges, solutions and future research directions

The family of conventional half-duplex (HD) wireless systems relied on transmitting and receiving in different time-slots or frequency sub-bands. Hence the wireless research community aspires to conceive full-duplex (FD) operation for supporting concurrent transmission and reception in a single time/frequency channel, which would improve the attainable spectral efficiency by a factor of two. The main challenge encountered in implementing an FD wireless device is the large power difference between the self-interference (SI) imposed by the device’s own transmissions and the signal of interest received from a remote source. In this survey, we present a comprehensive list of the potential FD techniques and highlight their pros and cons. We classify the SI cancellation techniques into three categories, namely passive suppression, analog cancellation and digital cancellation, with the advantages and disadvantages of each technique compared. Specifically, we analyse the main impairments (e.g. phase noise, power amplifier nonlinearity as well as in-phase and quadrature-phase (I/Q) imbalance, etc.) that degrading the SI cancellation. We then discuss the FD based Media Access Control (MAC)-layer protocol design for the sake of addressing some of the critical issues, such as the problem of hidden terminals, the resultant end-to-end delay and the high packet loss ratio (PLR) due to network congestion. After elaborating on a variety of physical/MAC-layer techniques, we discuss potential solutions conceived for meeting the challenges imposed by the aforementioned techniques. Furthermore, we also discuss a range of critical issues related to the implementation, performance enhancement and optimization of FD systems, including important topics such as hybrid FD/HD scheme, optimal relay selection and optimal power allocation, etc. Finally, a variety of new directions and open problems associated with FD technology are pointed out. Our hope is that this treatise will stimulate future research efforts in the emerging field of FD communication

Performance improvement of ad hoc networks using directional antennas and power control

Au cours de la dernière décennie, un intérêt remarquable a été éprouvé en matière des réseaux ad hoc sans fil capables de s'organiser sans soutien des infrastructures. L'utilisation potentielle d'un tel réseau existe dans de nombreux scénarios, qui vont du génie civil et secours en cas de catastrophes aux réseaux de capteurs et applications militaires. La Fonction de coordination distribuée (DCF) du standard IEEE 802.11 est le protocole dominant des réseaux ad hoc sans fil. Cependant, la méthode DCF n'aide pas à profiter efficacement du canal partagé et éprouve de divers problèmes tels que le problème de terminal exposé et de terminal caché. Par conséquent, au cours des dernières années, de différentes méthodes ont été développées en vue de régler ces problèmes, ce qui a entraîné la croissance de débits d'ensemble des réseaux. Ces méthodes englobent essentiellement la mise au point de seuil de détecteur de porteuse, le remplacement des antennes omnidirectionnelles par des antennes directionnelles et le contrôle de puissance pour émettre des paquets adéquatement. Comparées avec les antennes omnidirectionnelles, les antennes directionnelles ont de nombreux avantages et peuvent améliorer la performance des réseaux ad hoc. Ces antennes ne fixent leurs énergies qu'envers la direction cible et ont une portée d'émission et de réception plus large avec la même somme de puissance. Cette particularité peut être exploitée pour ajuster la puissance d'un transmetteur en cas d'utilisation d'une antenne directionnelle. Certains protocoles de contrôle de puissance directionnel MAC ont été proposés dans les documentations. La majorité de ces suggestions prennent seulement la transmission directionnelle en considération et, dans leurs résultats de simulation, ces études ont l'habitude de supposer que la portée de transmission des antennes omnidirectionnelles et directionnelles est la même. Apparemment, cette supposition n'est pas toujours vraie dans les situations réelles. De surcroît, les recherches prenant l'hétérogénéité en compte dans les réseaux ad hoc ne sont pas suffisantes. Le présent mémoire est dédié à proposer un protocole de contrôle de puissance MAC pour les réseaux ad hoc avec des antennes directionnelles en prenant tous ces problèmes en considération. ______________________________________________________________________________ MOTS-CLÉS DE L’AUTEUR : Réseaux ad hoc, Antennes directives, Contrôle de puissance

Distributed Cooperative Transmission with Unreliable and Untrustworthy Relay Channels

Cooperative transmission is an emerging wireless communication technique that improves wireless channel capacity through multiuser cooperation in the physical layer. It is expected to have a profound impact on network performance and design. However, cooperative transmission can be vulnerable to selfish behaviors and malicious attacks, especially in its current design. In this paper, we investigate two fundamental questions Does cooperative transmission provide new opportunities to malicious parties to undermine the network performance? Are there new ways to defend wireless networks through physical layer cooperation? Particularly, we study the security vulnerabilities of the traditional cooperative transmission schemes and show the performance degradation resulting from the misbehaviors of relay nodes. Then, we design a trust-assisted cooperative scheme that can detect attacks and has self-healing capability. The proposed scheme performs much better than the traditional schemes when there are malicious/selfish nodes or severe channel estimation errors. Finally, we investigate the advantage of cooperative transmission in terms of defending against jamming attacks. A reduction in link outage probability is achieved