The Myth of Spatial Reuse with Directional Antennas in Indoor Wireless Networks

Abstract. Interference among co-channel users is a fundamental prob-lem in wireless networks, which prevents nearby links from operating concurrently. Directional antennas allow the radiation patterns of wire-less transmitters to be shaped to form directed beams. Conventionally, such beams are assumed to improve the spatial reuse (i.e. concurrency) in indoor wireless networks. In this paper, we use experiments in an indoor office setting of Wifi Access points equipped with directional antennas, to study their potential for interference mitigation and spatial reuse. In contrast to conventional wisdom, we observe that the interference mit-igation benefits of directional antennas are minimal. On analyzing our experimental traces we observe that directional links do not reduce inter-ference to nearby links due to the lack of signal confinement due to indoor multipath fading. We then use the insights derived from our study to de-velop an alternative approach that provides better interference reduction in indoor networks compared to directional links. Key words: Indoor wireless networks, directional antennas, spatial reuse

Millimeter-wave Wireless LAN and its Extension toward 5G Heterogeneous Networks

Millimeter-wave (mmw) frequency bands, especially 60 GHz unlicensed band, are considered as a promising solution for gigabit short range wireless communication systems. IEEE standard 802.11ad, also known as WiGig, is standardized for the usage of the 60 GHz unlicensed band for wireless local area networks (WLANs). By using this mmw WLAN, multi-Gbps rate can be achieved to support bandwidth-intensive multimedia applications. Exhaustive search along with beamforming (BF) is usually used to overcome 60 GHz channel propagation loss and accomplish data transmissions in such mmw WLANs. Because of its short range transmission with a high susceptibility to path blocking, multiple number of mmw access points (APs) should be used to fully cover a typical target environment for future high capacity multi-Gbps WLANs. Therefore, coordination among mmw APs is highly needed to overcome packet collisions resulting from un-coordinated exhaustive search BF and to increase the total capacity of mmw WLANs. In this paper, we firstly give the current status of mmw WLANs with our developed WiGig AP prototype. Then, we highlight the great need for coordinated transmissions among mmw APs as a key enabler for future high capacity mmw WLANs. Two different types of coordinated mmw WLAN architecture are introduced. One is the distributed antenna type architecture to realize centralized coordination, while the other is an autonomous coordination with the assistance of legacy Wi-Fi signaling. Moreover, two heterogeneous network (HetNet) architectures are also introduced to efficiently extend the coordinated mmw WLANs to be used for future 5th Generation (5G) cellular networks.Comment: 18 pages, 24 figures, accepted, invited paper

Future benefits and applications of intelligent on-board processing to VSAT services

The trends and roles of VSAT services in the year 2010 time frame are examined based on an overall network and service model for that period. An estimate of the VSAT traffic is then made and the service and general network requirements are identified. In order to accommodate these traffic needs, four satellite VSAT architectures based on the use of fixed or scanning multibeam antennas in conjunction with IF switching or onboard regeneration and baseband processing are suggested. The performance of each of these architectures is assessed and the key enabling technologies are identified

Optimal Data Scheduling of Clients Serviced using Beamforming Antennas in Mobile Scenarios

The use of beamforming antennas has received significant attention over the last decade. I consider beamforming applied to dynamic operations such as networked UAV hubs which interconnect with users on the ground. The key problem involves understanding how to optimally manage the users' data requirements while considering mobility and a dynamic radio environment serviced by one or more hubs with beamforming antenna capability. In this work I break the problem down into scheduling, tracking and ultimately execution. I develop a regularized linear programming based scheduling algorithm along with developing a very efficient scheduling with uncertainty receding horizon based relaxation and implement them along with a capacity tracking estimation algorithm. Finally I show the results of successfully implementing this system in hardware using Fidelity Comtech's Phocus Array FCI-3100X. This implementation shows that the problem overview presented in this work provides a solid basis and defines the key components needed for a reliable electronic beamforming antenna system able to successfully service dispersed users in a mobile environment. It also shows the tools developed, refined, and integrated with respect to tracking, scheduling, and practical modifications

TD-SCDMA Relay Networks

PhDWhen this research was started, TD-SCDMA (Time Division Synchronous Code Division Multiple Access) was still in the research/ development phase, but now, at the time of writing this thesis, it is in commercial use in 10 large cities in China including Beijing and Shang Hai. In all of these cities HSDPA is enabled. The roll-out of the commercial deployment is progressing fast with installations in another 28 cities being underway now. However, during the pre-commercial TD-SCDM trail in China, which started from year 2006, some interference problems have been noticed especially in the network planning and initialization phases. Interference is always an issue in any network and the goal of the work reported in this thesis is to improve network coverage and capacity in the presence of interference. Based on an analysis of TD-SCDMA issues and how network interference arises, this thesis proposes two enhancements to the network in addition to the standard N-frequency technique. These are (i) the introduction of the concentric circle cell concept and (ii) the addition of a relay network that makes use of other users at the cell boundary. This overall approach not only optimizes the resilience to interference but increases the network coverage without adding more Node Bs. Based on the cell planning parameters from the research, TD-SCDMA HSDPA services in dense urban area and non-HSDPA services in rural areas were simulated to investigate the network performance impact after introducing the relay network into a TD-SCDMA network. The results for HSDPA applications show significant improvement in the TDSCDMA relay network both for network capacity and network interference aspects compared to standard TD-SCDMA networks. The results for non- HSDPA service show that although the network capacity has not changed after adding in the relay network (due to the code limitation in TD-SCDMA), the TD-SCDMA relay network has better interference performance and greater coverage

Usean gigabitin langaton tiedonsiirto 60 GHz:lla: keilanmuodostus ja mittauksia

Usage of wireless communication systems has been growing steadily during the past decades as more and more services and users are starting to utilize various cloud based systems. Need for higher data rates and the exponential increase of users are becoming significant difficulties for the current wireless communication systems. To tackle this problem, frequency bands of several gigahertz have been suggested for the next generation of local and personal communication systems (WLAN/WPAN). The extremely large unlicensed band at 60 GHz is an attractive option to provide multi-gigabit data rates over short distances. However, even at short distances systems have to compensate the poor link budget which is due to increased frequency and bandwidth. To mitigate these losses, highly directional communication with antenna arrays and beamforming is proposed. IEEE 802.11ad standard is one of the most promising millimeter wave standards to offer multi-gigabit data rates for WLAN/WPAN use. In comparison to the legacy IEEE 802.11 standards, the IEEE 802.11ad introduces completely new medium access control (MAC) and physical (PHY) layers due to highly directional communication. This thesis studies the IEEE 802.11ad standard, focusing on the renewed MAC and PHY layers, beamforming mechanisms, and overall performance in a home environment. While previous academic work has included measurements at 60 GHz, these measurements have been limited to laboratory and office areas which do not realistically model an actual end-user environment. Additionally, the measurement equipment in these research papers has not explicitly implemented the IEEE 802.11ad standard. Hence, measurements in this thesis are conducted with a prototype implementing the mandatory parts of the standard resulting in a more thorough realization of the performance. The results indicate that the prototype performs well in a home environment. Overall, theoretical PHY data rates of above 2 Gbps are to be expected in most cases if operated in similar environment

Layer 2 Path Selection Protocol for Wireless Mesh Networks with Smart Antennas

In this thesis the possibilities of smart antenna systems in wireless mesh networks are examined. With respect to the individual smart antenna tradeoffs, a routing protocol (Modified HWMP, MHWMP) for IEEE 802.11s mesh networks is presented, that exploits the full range of benefits provided by smart antennas: MHWMP actively switches between the PHY-layer transmission/reception modes (multiplexing, beamforming and diversity) according to the wireless channel conditions. Spatial multiplexing and beamforming are used for unicast data transmissions, while antenna diversity is employed for efficient broadcasts. To adapt to the directional channel environment and to take full benefit of the PHY capabilities, a respective MAC scheme is employed. The presented protocol is tested in extensive simulation and the results are examined.:1 Introduction 2 Wireless Mesh Networks 3 IEEE 802.11s 4 Smart Antenna Concepts 5 State of the Art: Wireless Mesh Networks with Smart Antennas 6 New Concepts 7 System Model 8 Results and Discussion 9 Conclusion and Future Wor

A Review of Indoor Millimeter Wave Device-based Localization and Device-free Sensing Technologies and Applications

The commercial availability of low-cost millimeter wave (mmWave) communication and radar devices is starting to improve the penetration of such technologies in consumer markets, paving the way for large-scale and dense deployments in fifth-generation (5G)-and-beyond as well as 6G networks. At the same time, pervasive mmWave access will enable device localization and device-free sensing with unprecedented accuracy, especially with respect to sub-6 GHz commercial-grade devices. This paper surveys the state of the art in device-based localization and device-free sensing using mmWave communication and radar devices, with a focus on indoor deployments. We first overview key concepts about mmWave signal propagation and system design. Then, we provide a detailed account of approaches and algorithms for localization and sensing enabled by mmWaves. We consider several dimensions in our analysis, including the main objectives, techniques, and performance of each work, whether each research reached some degree of implementation, and which hardware platforms were used for this purpose. We conclude by discussing that better algorithms for consumer-grade devices, data fusion methods for dense deployments, as well as an educated application of machine learning methods are promising, relevant and timely research directions.Comment: 43 pages, 13 figures. Accepted in IEEE Communications Surveys & Tutorials (IEEE COMST