Passive Synthetic Aperture Radar Imaging Using Commercial OFDM Communication Networks

Modern communication systems provide myriad opportunities for passive radar applications. OFDM is a popular waveform used widely in wireless communication networks today. Understanding the structure of these networks becomes critical in future passive radar systems design and concept development. This research develops collection and signal processing models to produce passive SAR ground images using OFDM communication networks. The OFDM-based WiMAX network is selected as a relevant example and is evaluated as a viable source for radar ground imaging. The monostatic and bistatic phase history models for OFDM are derived and validated with experimental single dimensional data. An airborne passive collection model is defined and signal processing approaches are proposed providing practical solutions to passive SAR imaging scenarios. Finally, experimental SAR images using general OFDM and WiMAX waveforms are shown to validate the overarching signal processing concept

Carrier Aggregation Enabled Integrated Sensing and Communication Signal Design and Processing

The future mobile communication systems will support intelligent applications such as Internet of Vehicles (IoV) and Extended Reality (XR). Integrated Sensing and Communication (ISAC) is regarded as one of the key technologies satisfying the high data rate communication and highly accurate sensing for these intelligent applications in future mobile communication systems. With the explosive growth of wireless devices and services, the shortage of spectrum resources leads to the fragmentation of available frequency bands for ISAC systems, which degrades sensing performance. Facing the above challenges, this paper proposes a Carrier Aggregation (CA)-based ISAC signal aggregating high and low-frequency bands to improve the sensing performance, where the CA-based ISAC signal can use four different aggregated pilot structures for sensing. Then, an ISAC signal processing algorithm with Compressed Sensing (CS) is proposed and the Fast Iterative Shrinkage-Thresholding Algorithm (FISTA) is used to solve the reconfiguration convex optimization problem. Finally, the Cram'er-Rao Lower Bounds (CRLBs) are derived for the CA-based ISAC signal. Simulation results show that CA efficiently improves the accuracy of range and velocity estimation

Wide-Angle Multistatic Synthetic Aperture Radar: Focused Image Formation and Aliasing Artifact Mitigation

Traditional monostatic Synthetic Aperture Radar (SAR) platforms force the user to choose between two image types: larger, low resolution images or smaller, high resolution images. Switching to a Wide-Angle Multistatic Synthetic Aperture Radar (WAM-SAR) approach allows formation of large high-resolution images. Unfortunately, WAM-SAR suffers from two significant implementation problems. First, wavefront curvature effects, non-linear flight paths, and warped ground planes lead to image defocusing with traditional SAR processing methods. A new 3-D monostatic/bistatic image formation routine solves the defocusing problem, correcting for all relevant wide-angle effects. Inverse SAR (ISAR) imagery from a Radar Cross Section (RCS) chamber validates this approach. The second implementation problem stems from the large Doppler spread in the wide-angle scene, leading to severe aliasing problems. This research effort develops a new anti-aliasing technique using randomized Stepped-Frequency (SF) waveforms to form Doppler filter nulls coinciding with aliasing artifact locations. Both simulation and laboratory results demonstrate effective performance, eliminating more than 99% of the aliased energy

Applications of FM Noise Radar Waveforms: Spatial Modulation and Polarization Diversity

Two possible radar application spaces are explored through the exploitation of highdimensional nonrecurrent FM-noise waveforms. The first involving a simultaneous dual-polarized emission scheme that provides good separability with respect to co- and cross-polarized terms and the second mimicking the passive actuation of the human eye with a MIMO emission. A waveform optimization scheme denoted as pseudorandom optimized (PRO) FM has been shown to generate FM-noise radar waveforms that are amenable to high power transmitters. Each pulse is generated and optimized independently and possesses a non-repeating FM-noise modulation structure. Because of this the range sidelobes of each pulse are unique and thus are effectively suppressed given enough coherent integration. The PRO-FM waveform generation scheme is used to create two independent sets of FM-noise waveforms to be incorporated into a simultaneous dual-polarized emission; whereby two independent PRO-FM waveforms will be transmitted simultaneously from orthogonal polarization channels. This effectively creates a polarization diverse emission. The random nature of these waveforms also reduce cross-correlation effects that occur during simultaneous transmission on both channels. This formulation is evaluated using experimental open-air measurements to demonstrate the effectiveness of this high-dimensional emission. This research aims to build upon previous work that has demonstrated the ability to mimic fixational eye movements (FEM) employed by the human eye. To implement FEM on a radar system a MIMO capable digital array must be utilized in conjunction with spatial modulation beamforming. Successful imitation of FEM will require randomized fast-time beamsteering from a two-dimensional array. The inherent randomness associated with FEM will be paired with the PRO-FM waveforms to create an emission possessing randomness in the space and frequency domains, called the FEM radar (FEMR). Unlike traditional MIMO, FEMR emits a coherent and time varying beam. Simulations will show the inherent enhancement to spatial resolution in two-dimensional space (azimuth and elevation) relative to standard beamforming using only the matched filter to process returns

An investigation of a frequency diverse array

This thesis presents a novel concept for focusing an antenna beam pattern as a function of range, time, and angle. In conventional phased arrays, beam steering is achieved by applying a linear phase progression across the aperture. This thesis shows that by applying an additional linear frequency shift across the elements, a new term is generated which results in a scan angle that varies with range in the far-field. Moreover, the antenna pattern is shown to scan in range and angle as a function of time. These properties result in more flexible beam scan options for phased array antennas than traditional phase shifter implementations. The thesis subsequently goes on to investigate this phenomenon via full scale experimentation, and explores a number of aspects of applying frequency diversity spatially across array antennas. This new form of frequency diverse array may have applications to multipath mitigation, where a radio signal takes two or more routes between the transmitter and receiver due to scattering from natural and man-made objects. Since the interfering signals arrive from more than one direction, the range-dependent and auto-scanning properties of the frequency diverse array beam may be useful to isolate and suppress the interference. The frequency diverse array may also have applications to wideband array steering, in lieu of true time delay solutions which are often used to compensate for linear phase progression with frequency across an array, and to sonar, where the speed of propagation results in large percentage bandwidth, creating similar wideband array effects. The frequency diverse array is also a stepping stone to more sophisticated joint antenna and waveform design for the creation of new radar modes, such as simultaneous multi-mode operation, for example, enabling joint synthetic aperture radar and ground moving target indication

Iterative synthetic aperture radar imaging algorithms

Synthetic aperture radar is an important tool in a wide range of civilian and military imaging applications. This is primarily due to its ability to image in all weather conditions, during both the day and the night, unlike optical imaging systems. A synthetic aperture radar system contains a step which is not present in an optical imaging system, this is image formation. This is required because the acquired data from the radar sensor does not directly correspond to the image. Instead, to form an image, the system must solve an inverse problem. In conventional scenarios, this inverse problem is relatively straight forward and a matched lter based algorithm produces an image of suitable image quality. However, there are a number of interesting scenarios where this is not the case. Scenarios where standard image formation algorithms are unsuitable include systems with data undersampling, errors in the system observation model and data that is corrupted by radio frequency interference. Image formation in these scenarios will form the topics of this thesis and a number of iterative algorithms are proposed to achieve image formation. The motivation for these proposed algorithms is primarily from the eld of compressed sensing, which considers the recovery of signals with a low-dimensional structure. The rst contribution of this thesis is the development of fast algorithms for the system observation model and its adjoint. These algorithms are required by large-scale gradient based iterative algorithms for image formation. The proposed algorithms are based on existing fast back-projection algorithms, however, a new decimation strategy is proposed which is more suitable for some applications. The second contribution is the development of a framework for iterative near- eld image formation, which uses the proposed fast algorithms. It is shown that the framework can be used, in some scenarios, to improve the visual quality of images formed from fully sampled data and undersampled data, when compared to images formed using matched lter based algorithms. The third contribution concerns errors in the system observation model. Algorithms that correct these errors are commonly referred to as autofocus algorithms. It is shown that conventional autofocus algorithms, which work as a post-processor on the formed image, are unsuitable for undersampled data. Instead an autofocus algorithm is proposed which corrects errors within the iterative image formation procedure. The proposed algorithm is provably stable and convergent with a faster convergence rate than previous approaches. The nal contribution is an algorithm for ultra-wideband synthetic aperture radar image formation. Due to the large spectrum over which the ultra-wideband signal is transmitted, there is likely to be many other users operating within the same spectrum. These users can produce signi cant radio frequency interference which will corrupt the received data. The proposed algorithm uses knowledge of the RFI spectrum to minimise the e ect of the RFI on the formed image

2-D DOA Estimation of LFM Signals Based on Dechirping Algorithm and Uniform Circle Array

Based on Dechirping algorithm and uniform circle array(UCA), a new 2-D direction of arrival (DOA) estimation algorithm of linear frequency modulation (LFM) signals is proposed in this paper. The algorithm uses the thought of Dechirping and regards the signal to be estimated which is received by the reference sensor as the reference signal and proceeds the difference frequency treatment with the signal received by each sensor. So the signal to be estimated becomes a single-frequency signal in each sensor. Then we transform the single-frequency signal to an isolated impulse through Fourier transform (FFT) and construct a new array data model based on the prominent parts of the impulse. Finally, we respectively use multiple signal classification (MUSIC) algorithm and rotational invariance technique (ESPRIT) algorithm to realize 2-D DOA estimation of LFM signals. The simulation results verify the effectiveness of the algorithm proposed

Impact of Nonlinear Distortion in Pulse-Doppler Radar Receivers

The aim of the thesis is to study the applicability of Direct Conversion Receiver (DCR) in radar, as these receivers possess the advantage of reduced complexity and fewer bandwidth limiting components compared to the superheterodyne receiver. As the wireless technology, it is also necessary to study about the receiver functionalities in radar using Digital Signal Processing (DSP) techniques. In today’s radar technology, designing the front end part of the radar receiver is more challenging, especially radar employing DCR, as these receivers are more prone to non-idealities such as I/Q Imbalance, non-linear distortion, DC offset and phase noise thereby affecting the dynamic range of the received echo signal. The pulse doppler radar is chosen in the thesis, as these radars are coherent, also capable of multiple target detection and provide large unambiguous range. The objective of the thesis is to analyse the effect of non-linear distortion such as second and third order distortion and observing the effects of these non-linearities in post-processing blocks. In this thesis baseband non-linearities in I and Q branches of the radar receiver are more specifically addressed than the RF non-linearity and blockers. The analysis is carried out in such a way that, the basic mathematical expressions for the RF signal in the transmitter part and received echo signal at baseband considering the effect of doppler are modelled. The second and third order non-linearities are modelled with some special cases by introducing some imbalances in I and Q branches and the effect of increasing the doppler frequency beyond the specified Pulse Repetition Frequency (PRF) is to be analysed. The effects of non-linearities are observed in post-processing blocks of the pulse doppler radar receivers. Thus, the final stage in the radar receiver blocks includes matched filtering or pulse compression and doppler processing as they are capable of separating target and clutter. The matched filtering or pulse compression follows Linear Frequency Modulation technique (LFM) as it is simple to generate the signal and insensitivity to doppler shifts. The pulse compression or matched filtering maximizes the Signal-to-Noise Ratio (SNR) by reducing the sidelobe levels using appropriate weighting functions so as to improve the resolution of the target. The doppler processing is capable of separating the target and clutter thereby improving the Signal-to-Clutter Ratio (SCR). The target signal is recorded and observed in a Range/ Doppler (R/D) matrix where the various parameters such as range, doppler information that includes measuring the doppler shift and radial velocity, location of the target etc. can be estimated. Other than the parameter estimation, the effect of non-linearities is observed in the R/D matrix. Comparisons of ideal scenario and non-ideal scenario and tabulations illustrating the comparison of second and third order distortion profiles are illustrated in the thesis to study about the performance and practicality of the radar receivers

The Bi-directional Spatial Spectrum for MIMO Radar and Its Applications

<p>Radar systems have long applied electronically-steered phased arrays to discriminate returns in azimuth angle and elevation angle. On receiver arrays, beamforming is performed after reception of the data, allowing for many adaptive array processing algorithms to be employed. However, on transmitter arrays, up until recently pre-determined phase shifts had to applied to each transmitter element before transmission, precluding adaptive transmit array processing schemes. Recent advances in multiple-input multiple-output radar techniques have allowed for transmitter channels to separated after data reception, allowing for virtual non-causal "after-the-fact" transmit beamforming. The ability to discriminate in both direction-of-arrival and direction-of-departure allows for the novel ability to discriminate line-of-sight returns from multipath returns. This works extends the concept of virtual non-causal transmit beamforming to the broader concept of a bi-directional spatial spectrum, and describes application of such a spectrum to applications such as spread-Doppler multipath clutter mitigation in ground-vehicle radar, and calibration of a receiver array of a MIMO system with ground clutter only. Additionally, for this work, a low-power MIMO radar testbed was developed for lab testing of MIMO radar concepts.</p>Dissertatio

Three Dimensional Bistatic Tomography Using HDTV

The thesis begins with a review of the principles of diffraction and reflection tomography; starting with the analytic solution to the inhomogeneous Helmholtz equation, after linearization by the Born approximation (the weak scatterer solution), and arriving at the Filtered Back Projection (Propagation) method of reconstruction. This is followed by a heuristic derivation more directly couched in the radar imaging context, without the rigor of the general inverse problem solution and more closely resembling an imaging turntable or inverse synthetic aperture radar. The heuristic derivation leads into the concept of the line integral and projections (the Radon Transform), followed by more general geometries where the plane wave approximation is invalid. We proceed next to study of the dependency of reconstruction on the space-frequency trajectory, combining the spatial aperture and waveform. Two and three dimensional apertures, monostatic and bistatic, fully and sparsely sampled and including partial apertures, with controlled waveforms (CW and pulsed, with and without modulation) define the filling of k-space and concomitant reconstruction performance. Theoretical developments in the first half of the thesis are applied to the specific example of bistatic tomographic imaging using High Definition Television (HDTV); the United States version of DVB-T. Modeling of the HDTV waveform using pseudonoise modulation to represent the hybrid 8VSB HDTV scheme and the move-stop-move approximation established the imaging potential, employing an idealized, isotropic 18 scatterer. As the move-stop-move approximation places a limitation on integration time (in cross correlation/pulse compression) due to transmitter/receiver motion, an exact solution for compensation of Doppler distortion is derived. The concept is tested with the assembly and flight test of a bistatic radar system employing software-defined radios (SDR). A three dimensional, bistatic collection aperture, exploiting an elevated commercial HDTV transmitter, is focused to demonstrate the principle. This work, to the best of our knowledge, represents a first in the formation of three dimensional images using bistatically-exploited television transmitters