Turbo equalization with cancelation of nonlinear distortion for CP-assisted and zero-padded MC-CDM schemes

In this paper, we consider MC-CDM schemes (MultiCarrier Code Division Multiplexing) where clipping techniques are employed to reduce the envelope fluctuations of the transmitted signals. Both CP-assisted (Cyclic Prefix) and ZP (Zero- Padded) MC-CDM schemes are studied. We develop frequencydomain turbo equalizers combined with an iterative estimation and cancelation of nonlinear distortion effects, with relatively low complexity since they allow FFT-based (Fast Fourier Transform), frequency-domain implementations. Our performance results show that the proposed receivers allow significant performance improvements at low and moderate SNR (Signal-to-Noise Ratio), even when strongly nonlinear transmitters are employed. The receiver for ZP MC-CDM is of special interest for systems where the duration of the channel impulse response is not a small fraction of the duration of the MC-CDM blocks, being suitable to MC-CDM systems with very large blocks (hundreds or even thousands of subcarriers), since they do not require the inversion nor the multiplication of large matrixes

Esquemas de pré-codificação IA com IB-DFE para sistemas MC-CDMA

Mestrado em Engenharia Eletrónica e TelecomunicaçõesTo achieve high bit rates, needed to meet the quality of service requirements of future multimedia applications, multi-carrier code division multiple access (MC-CDMA) has been considered as a candidate air-interface. Interference alignment (IA) is a promising technique that allows high capacity gains in interfering channels. On the other hand, iterative block decision feedback equalization (IB-DFE) based receivers can efficiently exploit the inherent space-frequency diversity of the MIMO MC-CDMA systems. In this thesis we proposed an IA precoding at the transmitter with IB-DFE based processing at the receiver for MC-CDMA systems. The IA precoding is applied at chip level instead of the data symbols level, as in the conventional IA based systems. The receiver is designed in two steps: first the equalizers based on zero forcing (ZF) or minimum mean square error (MMSE) are used to remove the aligned users´ interference. Then and after a whitening noise process, an IB-DFE based equalizer is designed to remove both the residual inter-user aligned and inter-carrier interferences. The results have shown that the obtained performance is very close to the one obtained by the optimal matched filter, with few iterations at the receiver side.Para atingir maiores ritmos de transmissão, as futures aplicações multimédia necessitam de atingir a qualidade de serviço necessária. Para isso, o multi-carrier code division multiple access (MC-CDMA) tem sido apontado como um forte candidato para interface ar dos futuros sistemas celulares. O Interference Alignment (IA) ou alinhamento de interferência é uma técnica promissora que permite ter altos ganhos de capacidade em canais com interferência. Por outro lado, temos receptores baseados no conceito iterative block decision feedback equalization(IB-DFE) que conseguem tirar partido, de uma forma eficiente, da inerente diversidade espaço-frequência dos sistemas MIMO MC-CDMA. Nesta dissertação é implementada uma pré-codificação baseada no conceito de IA considerando três transmissores (ou estações base) juntamente, com um processamento IB-DFE no receptor para sistemas MC-CDMA.A pré-codificação é aplicada ao nível de chip em vez de ser aplicado ao nível dos dados. O receptor é projectado em dois passos: em primeiro lugar equalizadores baseados em ZF ou em MMSE são utilizados para remover a interferência alinhada dos restantes utilizadores. De seguida, e após aplicar um processo de branqueamento do ruído ao sinal à saída do primeiro equalizador, um segundo equalizador baseado em IB-DFE é projectado para remover a interferência inter-utilizador residual e também a interferência residual entre portadoras. Os resultados obtidos mostraram-se satisfatórios na remoção da interferência obtendo-se um desempenho muito próximo do obtido considerando um filtro adaptado

Técnicas de igualização adaptativas com estimativas imperfeitas do canal para os futuros sistemas 5G

Wireless communication networks have been continuously experiencing an exponential growth since their inception. The overwhelming demand for high data rates, support of a large number of users while mitigating disruptive interference are the constant research focus and it has led to the creation of new technologies and efficient techniques. Orthogonal frequency division multiplexing (OFDM) is the most common example of a technology that has come to the fore in this past decade as it provided a simple and generally ideal platform for wireless data transmission. It’s drawback of a rather high peak-to-average power ratio (PAPR) and sensitivity to phase noise, which in turn led to the adoption of alternative techniques, such as the single carrier systems with frequency domain equalization (SC-FDE) or the multi carrier systems with code division multiple access (MC-CDMA), but the nonlinear Frequency Domain Equalizers (FDE) have been of special note due to their improved performance. From these, the Iterative Block Decision Feedback Equalizer (IB-DFE) has proven itself especially promising due to its compatibility with space diversity, MIMO systems and CDMA schemes. However, the IB-DFE requires the system to have constant knowledge of the communication channel properties, that is, to have constantly perfect Channel State Information (CSI), which is both unrealistic and impractical to implement. In this dissertation we shall design an altered IB-DFE receiver that is able to properly detect signals from SC-FDMA based transmitters, even with constantly erroneous channel states. The results shall demonstrate that the proposed equalization scheme is robust to imperfect CSI (I-CSI) situations, since its performance is constantly close to the perfect CSI case, within just a few iterations.Redes sem fios têm crescido de maneira contínua e exponencial desde a sua incepção. A tremenda exigência para altas taxas de dados e o suporte para um elevado número de utilizadores sem aumentar a interferência disruptiva originada por estes são alguns dos focos que levaram ao desenvolvimento de técnicas de compensação e novas tecnologias. “Orthogonal frequency division multiplexing” (OFDM) é um dos exemplos de tecnologias que se destacaram nesta última década, visto ter fornecido uma plataforma para transmissão de dados sem-fio eficaz e simples. O seu maior problema é a alta “peak-to-average power ratio” (PAPR) e a sua sensibilidade a ruído de fase que deram motivo à adoção de técnicas alternativas, tais como os sistemas “single carrier” com “frequency domain equalization” (SC-FDE) ou os sistemas “multi-carrier” com “code division multiple access” (MC-CDMA), mas equalizadores não lineares no domínio de frequência têm sido alvo de especial atenção devido ao seu melhor desempenho. Destes, o “iterative block decision feedback equalizer” (IB-DFE) tem-se provado especialmente promissor devido à sua compatibilidade com técnicas de diversidade no espaço, sistemas MIMO e esquemas CDMA. No entanto, IB-DFE requer que o sistema tenha constante conhecimento das propriedades dos canais usados, ou seja, necessita de ter perfeito “channel state information” (CSI) constantemente, o que é tanto irrealista como impossível de implementar. Nesta dissertação iremos projetar um recetor IB-DFE alterado de forma a conseguir detetar sinais dum transmissor baseado em tecnologia SC-FDMA, mesmo com a informação de estado de canal errada. Os resultados irão então demonstrar que o novo esquema de equalização proposto é robusto para situações de CSI imperfeito (I-CSI), visto que o seu desempenho se mantém próximo dos valores esperados para CSI perfeito, em apenas algumas iterações.Mestrado em Engenharia Eletrónica e Telecomunicaçõe

Energy-efficient diversity combining for different access schemes in a multi-path dispersive channel

Dissertação para obtenção do Grau de Doutor em Engenharia Electrotécnica e ComputadoresThe forthcoming generation of mobile communications, 5G, will settle a new standard for a larger bandwidth and better Quality of Service (QoS). With the exploding growth rate of user generated data, wireless standards must cope with this growth and at the same time be energy efficient to avoid depleting the batteries of wireless devices. Besides these issues, in a broadband wireless setting QoS can be severely affected from a multipath dispersive channel and therefore be energy demanding. Cross-layered architectures are a good choice to enhance the overall performance of a wireless system. Examples of cross-layered Physical (PHY) - Medium Access Control (MAC) architectures are type-II Diversity Combining (DC) Hybrid-ARQ (H-ARQ) and Multi-user Detection (MUD) schemes. Cross-layered type-II DC H-ARQ schemes reuse failed packet transmissions to enhance data reception on posterior retransmissions; MUD schemes reuse data information from previously collided packets on posterior retransmissions to enhance data reception. For a multipath dispersive channel, a PHY layer analytical model is proposed for Single-Carrier with Frequency Domain Equalization (SC-FDE) that supports DC H-ARQ and MUD. Based on this analytical model, three PHY-MAC protocols are proposed. A crosslayered Time Division Multiple Access (TDMA) scheme that uses DC H-ARQ is modeled and its performance is studied in this document; the performance analysis shows that the scheme performs better with DC and achieves a better energy efficiency at the cost of a higher delay. A novel cross-layered prefix-assisted Direct-Sequence Code Division Multiple Access (DS-CDMA) scheme is proposed and modeled in this document, it uses principles of DC and MUD. This protocol performs better by means of additional retransmissions, achieving better energy efficiency, at the cost of higher redundancy from a code spreading gain. Finally, a novel cross-layered protocol H-ARQ Network Division Multiple Access (H-NDMA) is proposed and modeled, where the combination of DC H-ARQ and MUD is used with the intent of maximizing the system capacity with a lower delay; system results show that the proposed scheme achieves better energy efficiency and a better performance at the cost of a higher number of retransmissions. A comparison of the three cross-layered protocols is made, using the PHY analytical model, under normalized conditions using the same amount of maximum redundancy. Results show that the H-NDMA protocol, in general, obtains the best results, achieving a good performance and a good energy efficiency for a high channel load and low Signal-to-Noise Ratio (SNR). TDMA with DC H-ARQ achieves the best energy efficiency, although presenting the worst delay. Prefix-assisted DS-CDMA in the other hand shows good delay results but presents the worst throughput and energy efficiency

Approaching universal frequency reuse through base station cooperation

Base Station (BS) architectures are a promising cellular wireless solution to mitigate the interference issues and to avoid the high frequency reuse factors implemented in conventional systems. Combined with block transmission techniques, such as Orthogonal Frequency-Division Multiplexing (OFDM) for the downlink and Single-Carrier with Frequency-Domain Equalization (SC-FDE) for the uplink, these systems provide a significant performance improvement to the overall system. Block transmission techniques are suitable for broadband wireless communication systems, which have to deal with strongly frequency-selective fading channels and are able to provide high bit rates despite the channel adversities. In BS cooperation schemes users in adjacent cells share the same physical channel and the signals received by each BS are sent to a Central Processing Unit (CPU) that combines the different signals and performs the user detections and/or separation, which can be regarded as a Multi-User Detection (MUD) technique. The work presented in this thesis is focused on the study of uplink transmissions in BS cooperations systems, considering single carrier block transmission schemes and iterative receivers based on the Iterative-Block Decision Feedback Equalization (IB-DFE) concept, which combined with the employment of Cyclic Prefix (CP)-assisted block transmission techniques are appropriate to scenarios with strongly time-dispersive channels. Furthermore, the impact of the sampling and quantization applied to the received signals from each Mobile Terminal (MT) to the corresponding BS is studied, with the achievement of the spectral characterization of the quantization noise. This thesis also provides a conventional analytical model for the BER (Bit Error Rate) performance complemented with an approach to improve its results. Finally, this thesis addresses the contextualization of BS cooperation schemes in clustered C-RAN (Centralized-Radio Access Network)-type solutions.As arquitecturas BS cooperation são uma solução promissora de redes celulares sem fios para atenuar o problema da interferência e evitar os factores de reuso elevados, que se encontram implementados nos sistemas convencionais. Combinadas com técnicas de transmissão por blocos, como o OFDM para o downlink e o SC-FDE no uplink, estes sistemas fornecem uma melhoria significativa no desempenho geral do sistema. Técnicas de transmissão por blocos são adequadas para sistemas de comunicações de banda larga sem fios, que têm que lidar com canais que possuem um forte desvanescimento selectivo na frequência e são capazes de fornecer ligações com taxas de transmissão altas apesar das adversidades do canal. Em esquemas BS cooperation os terminais móveis situados em células adjacentes partilham o mesmo canal físico e os sinais recebidos em cada estação de base são enviados para uma Unidade Central de Processamento (CPU) que combina os diferentes sinais recebidos associados a um dado utilizador e realiza a detecção e/ou separação do mesmo, sendo esta considerada uma técnica de Detecção Multi-Utilizador (MUD). O trabalho apresentado nesta tese concentra o seu estudo no uplink de transmissões em sistemas BS cooperation, considerando transmissões em bloco de esquemas monoportadoras e receptores iterativos baseados no conceito B-DFE, em que quando combinados com a implementação de técnicas de transmissao por blocos assistidas por prefixos cíclicos (CP) são apropriados a cenários com canais fortemente dispersivos no tempo. Além disso, é estudado o impacto do processo de amostragem e quantização aplicados aos sinais recebidos de cada terminal móvel para a estação de base, com a obtenção da caracterização espectral do ruído de quantização. Esta tese também fornece um modelo analítico convencional para a computação do desempenho da taxa de erros de bit (BER), com um método melhorado para o mesmo. Por último, esta tese visa a contextualização dos sistemas BS cooperation em soluções do tipo C-RAN

Timing and Carrier Synchronization in Wireless Communication Systems: A Survey and Classification of Research in the Last 5 Years

Timing and carrier synchronization is a fundamental requirement for any wireless communication system to work properly. Timing synchronization is the process by which a receiver node determines the correct instants of time at which to sample the incoming signal. Carrier synchronization is the process by which a receiver adapts the frequency and phase of its local carrier oscillator with those of the received signal. In this paper, we survey the literature over the last 5 years (2010–2014) and present a comprehensive literature review and classification of the recent research progress in achieving timing and carrier synchronization in single-input single-output (SISO), multiple-input multiple-output (MIMO), cooperative relaying, and multiuser/multicell interference networks. Considering both single-carrier and multi-carrier communication systems, we survey and categorize the timing and carrier synchronization techniques proposed for the different communication systems focusing on the system model assumptions for synchronization, the synchronization challenges, and the state-of-the-art synchronization solutions and their limitations. Finally, we envision some future research directions