Design and Validation of a Software Defined Radio Testbed for DVB-T Transmission

This paper describes the design and validation of a Software Defined Radio (SDR) testbed, which can be used for Digital Television transmission using the Digital Video Broadcasting - Terrestrial (DVB-T) standard. In order to generate a DVB-T-compliant signal with low computational complexity, we design an SDR architecture that uses the C/C++ language and exploits multithreading and vectorized instructions. Then, we transmit the generated DVB-T signal in real time, using a common PC equipped with multicore central processing units (CPUs) and a commercially available SDR modem board. The proposed SDR architecture has been validated using fixed TV sets, and portable receivers. Our results show that the proposed SDR architecture for DVB-T transmission is a low-cost low-complexity solution that, in the worst case, only requires less than 22% of CPU load and less than 170 MB of memory usage, on a 3.0 GHz Core i7 processor. In addition, using the same SDR modem board, we design an off-line software receiver that also performs time synchronization and carrier frequency offset estimation and compensation

Programmable rate modem utilizing digital signal processing techniques

The engineering development study to follow was written to address the need for a Programmable Rate Digital Satellite Modem capable of supporting both burst and continuous transmission modes with either binary phase shift keying (BPSK) or quadrature phase shift keying (QPSK) modulation. The preferred implementation technique is an all digital one which utilizes as much digital signal processing (DSP) as possible. Here design tradeoffs in each portion of the modulator and demodulator subsystem are outlined, and viable circuit approaches which are easily repeatable, have low implementation losses and have low production costs are identified. The research involved for this study was divided into nine technical papers, each addressing a significant region of concern in a variable rate modem design. Trivial portions and basic support logic designs surrounding the nine major modem blocks were omitted. In brief, the nine topic areas were: (1) Transmit Data Filtering; (2) Transmit Clock Generation; (3) Carrier Synthesizer; (4) Receive AGC; (5) Receive Data Filtering; (6) RF Oscillator Phase Noise; (7) Receive Carrier Selectivity; (8) Carrier Recovery; and (9) Timing Recovery

Direct GMSK modulation at microwave frequencies

Congestion in the radio spectrum is forcing emerging high rate wireless communication systems into upper microwave and millimeterwave frequency bands, where transceiver hardware architectures are less mature. One way to realize a simple and elegant hardware solution for a microwave transmitter is to exploit the advantages of directly modulating the phase of the carrier signal. A modulation method requiring continuous phase control of the carrier signal over the full 360 degree range is Gaussian Minimum Shift Keying (GMSK). Unfortunately, it is very difficult to design a microwave circuit to provide linear phase control of a carrier signal over the full 360 degree range using traditional methods. A novel method of obtaining continuous, linear phase modulation of a microwave carrier signal over the full 360 degree range is proposed. This method is based on controlling a phase shifter, at a subharmonic of the desired output carrier frequency, and then using a frequency multiplier to obtain the desired output frequency. The phase shifter is designed to be highly linear over a fraction of the full 360 range. The frequency multiplier is a nonlinear circuit that shifts the frequency by *'N'. The subtle part of this nonlinear operation is that the multiplier also multiplies the instantaneous phase of the phase shifter output signal by *'N', thus expanding the linear phase shift range to the required 360 degrees. Using this nonlinear frequency multiplication principle, the modulator can readily be extended into the millimeterwave region. A prototype circuit is designed and performance results are presented for this method of carrier phase modulation at 18 GHz. The prototype circuit is realized with very simple hardware, containing only a single microwave active device. An extension to the modulator involving phase locking or injection locking of a power oscillator is also suggested for obtaining higher power modulated output signals. In addition to direct continuous phase modulation, the proposed method is also suitable for a wide variety of transceiver applications, including phase synchronization of antenna and oscillator arrays, phased array antenna beam steering, indirect frequency modulation, and ultra-small carrier frequency translation

Toward Early-Warning Detection of Gravitational Waves from Compact Binary Coalescence

Rapid detection of compact binary coalescence (CBC) with a network of advanced gravitational-wave detectors will offer a unique opportunity for multi-messenger astronomy. Prompt detection alerts for the astronomical community might make it possible to observe the onset of electromagnetic emission from (CBC). We demonstrate a computationally practical filtering strategy that could produce early-warning triggers before gravitational radiation from the final merger has arrived at the detectors.Comment: 16 pages, 7 figures, published in ApJ. Reformatted preprint with emulateap

Digital Filters

The new technology advances provide that a great number of system signals can be easily measured with a low cost. The main problem is that usually only a fraction of the signal is useful for different purposes, for example maintenance, DVD-recorders, computers, electric/electronic circuits, econometric, optimization, etc. Digital filters are the most versatile, practical and effective methods for extracting the information necessary from the signal. They can be dynamic, so they can be automatically or manually adjusted to the external and internal conditions. Presented in this book are the most advanced digital filters including different case studies and the most relevant literature

AMiBA Wideband Analog Correlator

A wideband analog correlator has been constructed for the Yuan-Tseh Lee Array for Microwave Background Anisotropy. Lag correlators using analog multipliers provide large bandwidth and moderate frequency resolution. Broadband IF distribution, backend signal processing and control are described. Operating conditions for optimum sensitivity and linearity are discussed. From observations, a large effective bandwidth of around 10 GHz has been shown to provide sufficient sensitivity for detecting cosmic microwave background variations.Comment: 28 pages, 23 figures, ApJ in press

Smart FRP Composite Sandwich Bridge Decks in Cold Regions

INE/AUTC 12.0