1,508 research outputs found
WIMAX Basics from PHY Layer to Scheduling and Multicasting Approaches
WiMAX (Worldwide Interoperability for Microwave Access) is an emerging broadband wireless technology for providing Last mile solutions for supporting higher bandwidth and multiple service classes with various quality of service requirement. The unique architecture of the WiMAX MAC and PHY layers that uses OFDMA to allocate multiple channels with different modulation schema and multiple time slots for each channel allows better adaptation of heterogeneous userâs requirements. The main architecture in WiMAX uses PMP (Point to Multipoint), Mesh mode or the new MMR (Mobile Multi hop Mode) deployments where scheduling and multicasting have different approaches. In PMP SS (Subscriber Station) connects directly to BS (Base Station) in a single hop route so channel conditions adaptations and supporting QoS for classes of services is the key points in scheduling, admission control or multicasting, while in Mesh networks SS connects to other SS Stations or to the BS in a multi hop routes, the MMR mode extends the PMP mode in which the SS connects to either a relay station (RS) or to Bs. Both MMR and Mesh uses centralized or distributed scheduling with multicasting schemas based on scheduling trees for routing. In this paper a broad study is conducted About WiMAX technology PMP and Mesh deployments from main physical layers features with differentiation of MAC layer features to scheduling and multicasting approaches in both modes of operations
Hybrid Satellite-Terrestrial Communication Networks for the Maritime Internet of Things: Key Technologies, Opportunities, and Challenges
With the rapid development of marine activities, there has been an increasing
number of maritime mobile terminals, as well as a growing demand for high-speed
and ultra-reliable maritime communications to keep them connected.
Traditionally, the maritime Internet of Things (IoT) is enabled by maritime
satellites. However, satellites are seriously restricted by their high latency
and relatively low data rate. As an alternative, shore & island-based base
stations (BSs) can be built to extend the coverage of terrestrial networks
using fourth-generation (4G), fifth-generation (5G), and beyond 5G services.
Unmanned aerial vehicles can also be exploited to serve as aerial maritime BSs.
Despite of all these approaches, there are still open issues for an efficient
maritime communication network (MCN). For example, due to the complicated
electromagnetic propagation environment, the limited geometrically available BS
sites, and rigorous service demands from mission-critical applications,
conventional communication and networking theories and methods should be
tailored for maritime scenarios. Towards this end, we provide a survey on the
demand for maritime communications, the state-of-the-art MCNs, and key
technologies for enhancing transmission efficiency, extending network coverage,
and provisioning maritime-specific services. Future challenges in developing an
environment-aware, service-driven, and integrated satellite-air-ground MCN to
be smart enough to utilize external auxiliary information, e.g., sea state and
atmosphere conditions, are also discussed
A Survey on Scheduling in IEEE 802.16 Mesh Mode
Cataloged from PDF version of article.IEEE 802.16 standard (also known as WiMAX)
defines the wireless broadband network technology which aims
to solve the so called last mile problem via providing high
bandwidth Internet even to the rural areas for which the cable
deployment is very costly. The standard mainly focuses on the
MAC and PHY layer issues, supporting two transmission modes:
PMP (Point-to-Multipoint) and mesh modes. Mesh mode is an
optional mode developed as an extension to PMP mode and it
has the advantage of having an improving performance as more
subscribers are added to the system using multi-hop routes. In
802.16 MAC protocol, mesh mode slot allocation and reservation
mechanisms are left open which makes this topic a hot research
area. Hence, the focus of this survey will mostly be on the mesh
mode, and the proposed scheduling algorithms and performance
evaluation methods
Recommended from our members
Design of interface selection protocols for multi-homed wireless networks
This thesis was submitted for the degree of Doctor of Philosophy and was awarded by Brunel University on 10 December 2010.The IEEE 802.11/802.16 standards conformant wireless communication stations have multi-homing transmission capability. To achieve greater communication efficiency, multi-homing capable stations use handover mechanism to select appropriate transmission channel according to variations in the channel quality. This thesis presents three internal-linked handover schemes, (1) Interface Selection Protocol (ISP), belonging to Wireless Local Area Network (WLAN)- Worldwide Interoperability for Microwave Access (WiMAX) environment (2) Fast Channel Scanning (FCS) and (3) Traffic Manager (TM), (2) and (3) belonging to WiMAX Environment. The proposed schemes in this thesis use a novel mechanism of providing a reliable communication route. This solution is based on a cross-layer communication framework, where the interface selection module uses various network related parameters from Medium Access Control (MAC) sub-layer/Physical Layer (PHY) across the protocol suite for decision making at the Network layer. The proposed solutions are highly responsive when compared with existing multi-homed schemes; responsiveness is one of the key factors in the design of such protocols. Selected route under these schemes is based on the most up to date link-layer information. Therefore, such a route is not only reliable in terms of route optimization but it also fulfils the application demands in terms of throughput and delay. Design of ISP protocol use probing frames during the route discovery process. The 802.11 mandates the use of different rates for data transmission frames. The ISP-metric can be incorporated into various routing aspects and its applicability is determined by the possibility of provision of MAC dependent parameters that are used to determine the best path metric values. In many cases, higher device density, interference and mobility cause variable medium access delays. It causes creation of âunreachable zonesâ, where destination is marked as unreachable. However, by use of the best path metric, the destination has been made reachable, anytime and anywhere, because of the intelligent use of the probing frames and interface selection algorithm implemented. The IEEE 802.16e introduces several MAC level queues for different access categories, maintaining service requirement within these queues; which imply that frames from a higher priority queue, i.e. video frames, are serviced more frequently than those belonging to lower priority queues. Such an enhancement at the MAC sub-layer introduces uneven queuing delays. Conventional routing protocols are unaware of such MAC specific constraints and as a result, these factors are not considered which result in channel performance degradation. To meet such challenges, the thesis presents FCS and TM schemes for WiMAX. For FCS, Its solution is to improve the mobile WiMAX handover and address the scanning latency. Since minimum scanning time is the most important issue in the handover process. This handover scheme aims to utilize the channel efficiently and apply such a procedure to reduce the time it takes to scan the neighboring access stations. TM uses MAC and physical layer (PHY) specific information in the interface metric and maintains a separate path to destination by applying an alternative interface operation. Simulation tests and comparisons with existing multi-homed protocols and handover schemes demonstrate the effectiveness of incorporating the medium dependent parameters. Moreover, show that suggested schemes, have shown better performance in terms of end-to-end delay and throughput, with efficiency up to 40% in specific test scenarios
A Novel QoS Guarantee Mechanism in IEEE 802.16 Mesh Networks
IEEE 802.16 defines perfect QoS (Quality of Service) guarantee mechanism in PMP (Point to Multi-Point) mode and denotes mesh mode cannot provide this capability. To resolve this problem of WiMAX Mesh network, a novel QoS guarantee mechanism including protocol process and minislot allocation algorithm is proposed. This mechanism uses existing service classes in original standard. Protocol processes that manage dynamic service flow are defined. WiMAX MAC layer is re-designed to support service classification in mesh mode. Using extended distributed scheduling messages, the delivery method of dynamic service management messages in WiMAX mesh networks is implemented. Minislot allocation algorithm is given to support data scheduling of various services. Service establishment time is analyzed in this paper. The simulation result shows that the mechanism can provide QoS in WiMAX mesh networks effectively
Auction-based Bandwidth Allocation Mechanisms for Wireless Future Internet
An important aspect of the Future Internet is the efficient utilization of
(wireless) network resources. In order for the - demanding in terms of QoS -
Future Internet services to be provided, the current trend is evolving towards
an "integrated" wireless network access model that enables users to enjoy
mobility, seamless access and high quality of service in an all-IP network on
an "Anytime, Anywhere" basis. The term "integrated" is used to denote that the
Future Internet wireless "last mile" is expected to comprise multiple
heterogeneous geographically coexisting wireless networks, each having
different capacity and coverage radius. The efficient management of the
wireless access network resources is crucial due to their scarcity that renders
wireless access a potential bottleneck for the provision of high quality
services. In this paper we propose an auction mechanism for allocating the
bandwidth of such a network so that efficiency is attained, i.e. social welfare
is maximized. In particular, we propose an incentive-compatible, efficient
auction-based mechanism of low computational complexity. We define a repeated
game to address user utilities and incentives issues. Subsequently, we extend
this mechanism so that it can also accommodate multicast sessions. We also
analyze the computational complexity and message overhead of the proposed
mechanism. We then show how user bids can be replaced from weights generated by
the network and transform the auction to a cooperative mechanism capable of
prioritizing certain classes of services and emulating DiffServ and time-of-day
pricing schemes. The theoretical analysis is complemented by simulations that
assess the proposed mechanisms properties and performance. We finally provide
some concluding remarks and directions for future research
- âŠ