1,896 research outputs found
An Energy-Based Comparison of Long-Hop and Short-Hop Routing in MIMO Networks
This paper considers the problem of selecting either routes that consist of
long hops or routes that consist of short hops in a network of multiple-antenna
nodes, where each transmitting node employs spatial multiplexing. This
distance-dependent route selection problem is approached from the viewpoint of
energy efficiency, where a route is selected with the objective of minimizing
the transmission energy consumed while satisfying a target outage criterion at
the final destination. Deterministic line networks and two-dimensional random
networks are considered. It is shown that when 1) the number of hops traversed
between the source and destination grows large or 2) when the target success
probability approaches one or 3) when the number of transmit and/or receive
antennas grows large, short-hop routing requires less energy than long-hop
routing. It is also shown that if both routing strategies are subject to the
same delay constraint, long-hop routing requires less energy than short-hop
routing as the target success probability approaches one. In addition,
numerical analysis indicates that given loose outage constraints, only a small
number of transmit antennas are needed for short-hop routing to have its
maximum advantage over long-hop routing, while given stringent outage
constraints, the advantage of short-hop over long-hop routing always increases
with additional transmit antennas.Comment: 27 pages, 12 figures, submitted to IEEE Transactions on Vehicular
Technology in March 2009, revised in July 200
Energy efficiency of some non-cooperative, cooperative and hybrid communication schemes in multi-relay WSNs
In this paper we analyze the energy efficiency of single-hop, multi-hop, cooperative selective decode-and-forward, cooperative incremental decode-and-forward, and even the combination of cooperative and non-cooperative schemes, in wireless sensor networks composed of several nodes. We assume that, as the sensor nodes can experience either non line-of-sight or some line-of-sight conditions, the Nakagami-m fading distribution is used to model the wireless environment. The energy efficiency analysis is constrained by a target outage probability and an end-to-end throughput. Our results show that in most scenarios cooperative incremental schemes are more energy efficient than the other methods
Hybrid Satellite-Terrestrial Communication Networks for the Maritime Internet of Things: Key Technologies, Opportunities, and Challenges
With the rapid development of marine activities, there has been an increasing
number of maritime mobile terminals, as well as a growing demand for high-speed
and ultra-reliable maritime communications to keep them connected.
Traditionally, the maritime Internet of Things (IoT) is enabled by maritime
satellites. However, satellites are seriously restricted by their high latency
and relatively low data rate. As an alternative, shore & island-based base
stations (BSs) can be built to extend the coverage of terrestrial networks
using fourth-generation (4G), fifth-generation (5G), and beyond 5G services.
Unmanned aerial vehicles can also be exploited to serve as aerial maritime BSs.
Despite of all these approaches, there are still open issues for an efficient
maritime communication network (MCN). For example, due to the complicated
electromagnetic propagation environment, the limited geometrically available BS
sites, and rigorous service demands from mission-critical applications,
conventional communication and networking theories and methods should be
tailored for maritime scenarios. Towards this end, we provide a survey on the
demand for maritime communications, the state-of-the-art MCNs, and key
technologies for enhancing transmission efficiency, extending network coverage,
and provisioning maritime-specific services. Future challenges in developing an
environment-aware, service-driven, and integrated satellite-air-ground MCN to
be smart enough to utilize external auxiliary information, e.g., sea state and
atmosphere conditions, are also discussed
Analyzing Energy-efficiency and Route-selection of Multi-level Hierarchal Routing Protocols in WSNs
The advent and development in the field of Wireless Sensor Networks (WSNs) in
recent years has seen the growth of extremely small and low-cost sensors that
possess sensing, signal processing and wireless communication capabilities.
These sensors can be expended at a much lower cost and are capable of detecting
conditions such as temperature, sound, security or any other system. A good
protocol design should be able to scale well both in energy heterogeneous and
homogeneous environment, meet the demands of different application scenarios
and guarantee reliability. On this basis, we have compared six different
protocols of different scenarios which are presenting their own schemes of
energy minimizing, clustering and route selection in order to have more
effective communication. This research is motivated to have an insight that
which of the under consideration protocols suit well in which application and
can be a guide-line for the design of a more robust and efficient protocol.
MATLAB simulations are performed to analyze and compare the performance of
LEACH, multi-level hierarchal LEACH and multihop LEACH.Comment: NGWMN with 7th IEEE Inter- national Conference on Broadband and
Wireless Computing, Communication and Applications (BWCCA 2012), Victoria,
Canada, 201
A cross layer multi hop network architecture for wireless Ad Hoc networks
In this paper, a novel decentralized cross-layer multi-hop cooperative network architecture is presented. Our architecture involves the design of a simple yet efficient cooperative flooding scheme,two decentralized opportunistic cooperative forwarding mechanisms as well as the design of Routing
Enabled Cooperative Medium Access Control (RECOMAC) protocol that spans and incorporates the physical, medium access control (MAC) and routing layers for improving the performance of multihop communication. The proposed architecture exploits randomized coding at the physical layer to realize cooperative diversity. Randomized coding alleviates relay selection and actuation mechanisms,and therefore reduces the coordination among the relays. The coded packets are forwarded via opportunistically formed cooperative sets within a region, without communication among the relays and without establishing a prior route. In our architecture, routing layer functionality is submerged into the
MAC layer to provide seamless cooperative communication while the messaging overhead to set up routes, select and actuate relays is minimized. RECOMAC is shown to provide dramatic performance improvements, such as eight times higher throughput and ten times lower end-to-end delay as well as reduced overhead, as compared to networks based on well-known IEEE 802.11 and Ad hoc On Demand
Distance Vector (AODV) protocols
- …